- Home
- Juniper
- Enterprise Routing and Switching, Specialist (JNCIS-ENT)
- Juniper.JN0-347.v2019-04-15.q62
- Question 11
Valid JN0-347 Dumps shared by ExamDiscuss.com for Helping Passing JN0-347 Exam! ExamDiscuss.com now offer the newest JN0-347 exam dumps, the ExamDiscuss.com JN0-347 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com JN0-347 dumps with Test Engine here:
Access JN0-347 Dumps Premium Version
(138 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 11/62
Router-1 and Router-2 need to connect through the Internet using a tunneling technology.
Hosts that are connected to Router-1 and Router-2 will be sending traffic up to 1500 bytes.
The maximum segment size is supported across the path is 1520 bytes. Which tunneling technology will allow this communication to take place?
Hosts that are connected to Router-1 and Router-2 will be sending traffic up to 1500 bytes.
The maximum segment size is supported across the path is 1520 bytes. Which tunneling technology will allow this communication to take place?
Correct Answer: D
Explanation/Reference:
Explanation:
Difference Between GRE and IP-IP Tunnel. Generic Routing Encapsulation (GRE) and IP-in-IP (IPIP) are two rather similar tunneling mechanisms which are often confused. In terms of less overhead, the GRE header is 24 bytes and an IP header is 20 bytes.
Explanation:
Difference Between GRE and IP-IP Tunnel. Generic Routing Encapsulation (GRE) and IP-in-IP (IPIP) are two rather similar tunneling mechanisms which are often confused. In terms of less overhead, the GRE header is 24 bytes and an IP header is 20 bytes.
- Question List (62q)
- Question 1: Which two values are used to generate a bridge ID when using...
- Question 2: Click the Exhibit button. (Exhibit) You manage the Layer 2 n...
- Question 3: Click the Exhibit button. Referring to the exhibit, what is ...
- Question 4: Depending on the link type, OSPF sends link state update pac...
- Question 5: What are three types of bridge protocol data units? (Choose ...
- Question 6: Which two statements describe the BGP Local Preference attri...
- Question 7: You disconnected a switch from the Virtual Chassis, but the ...
- Question 8: Click the Exhibit button. (Exhibit) Referring to the exhibit...
- Question 9: Click to the Exhibit button. Referring to the exhibit, which...
- Question 10: Click the Exhibit button. (Exhibit) What would cause the sta...
- Question 11: Router-1 and Router-2 need to connect through the Internet u...
- Question 12: An EBGP session sources its TCP connection from which IP add...
- Question 13: What information is included in the DHCP snooping database? ...
- Question 14: Which two statements are true about DIS elections in IS-IS? ...
- Question 15: Click to the exhibit button. Referring to the exhibit, which...
- Question 16: You are currently defining a new OSPF area. The area must ad...
- Question 17: What is reviewed first in the BGP route selection process?...
- Question 18: Which two statements are correct about aggregate routes in t...
- Question 19: Click the Exhibit button. (Exhibit) You are troubleshooting ...
- Question 20: Which static route next-hop value indicated that the packet ...
- Question 21: Which Junos feature allows you to combine multiple interface...
- Question 22: What is the default BGP group type on a Junos device?...
- Question 23: Click the Exhibit button. (Exhibit) You are asked to change ...
- Question 24: Which statement about IS-IS adjacencies is true?...
- Question 25: Click the Exhibit button. (Exhibit) There are dynamically an...
- Question 26: Click the Exhibit button. (Exhibit) You have an existing Vir...
- Question 27: Click the Exhibit button. (Exhibit) What will be two results...
- Question 28: Click the Exhibit button. (Exhibit) The IS-IS adjacency betw...
- Question 29: Click the Exhibit button. In the exhibit, each IP subnet in ...
- Question 30: Which three statements are correct about the voice VLAN feat...
- Question 31: What is considered a requirement for passing traffic through...
- Question 32: Click the Exhibit button. Based on the output shown in the e...
- Question 33: Host-1 was recently added in the network and is attached to ...
- Question 34: Click the Exhibit button. (Exhibit) Referring to the exhibit...
- Question 35: You are asked to ensure that a designated interface on an EX...
- Question 36: Click the Exhibit button. Referring to the exhibit, you are ...
- Question 37: Which statement describes optional transitive BGP attributes...
- Question 38: Click the Exhibit button. (Exhibit) Referring to the exhibit...
- Question 39: What are three extended BGP communities? (Choose three.)...
- Question 40: Which two statements about RSTP are correct? (Choose two.)...
- Question 41: Click the Exhibit button. (Exhibit) Referring to the exhibit...
- Question 42: Which two statements are true about the IRB interface? (Choo...
- Question 43: Which two statements are true about OSPF not-so-stubby areas...
- Question 44: Which protocol prevents loops and calculates the best path t...
- Question 45: Click the Exhibit button. Given the information shown in the...
- Question 46: Which two statements are true about nonstop bridging (NSB)? ...
- Question 47: Which two port security features are dependent on the DHCP s...
- Question 48: You are troubleshooting your OSPF configuration and notice t...
- Question 49: Click the Exhibit button. (Exhibit) You are establishing a B...
- Question 50: Click the Exhibit button. (Exhibit) Referring to the outputs...
- Question 51: Click the Exhibit button. Referring to the exhibit, what doe...
- Question 52: You received an alert from your monitoring system that the m...
- Question 53: Click the Exhibit button. (Exhibit) Referring to the exhibit...
- Question 54: Which statement is true about load balancing of equal cost p...
- Question 55: An EX Series switch receives a frame with an unknown destina...
- Question 56: You manage a Layer 2 network that spans two buildings. You a...
- Question 57: What are three components that populate the Ethernet switchi...
- Question 58: You have deployed a Juniper EX Series switch in the network....
- Question 59: Which three BGP attributes are well-known and mandatory? (Ch...
- Question 60: What are two types of IS-IS PDUs? (Choose two.)...
- Question 61: Which two statements are correct about redundant trunk group...
- Question 62: Click the Exhibit button. Switch-1 in the exhibit receives a...
