<< Prev Question Next Question >>

Question 60/79

You are troubleshooting your OSPF configuration and notice that you have subnet mismatch errors when running the show ospf statisticscommand.
Which two actions would further troubleshoot the errors? (Choose two.)

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (79q)
Question 1: You disconnected a switch from the Virtual Chassis, but the ...
Question 2: An EBGP session sources its TCP connection from which IP add...
Question 3: Click the Exhibit button. (Exhibit) You are asked to change ...
Question 4: What is the default BGP group type on a Junos device?...
Question 5: Which state indicates that the BGP session is fully converge...
Question 6: Click the Exhibit button. Referring to the exhibit, which ty...
Question 7: Click the Exhibit button. Given the information shown in the...
Question 8: Click the Exhibit button. Based on the trace options output ...
Question 9: Which mechanism is used to share routes between routing tabl...
Question 10: Which two OSPF LSA types will you see in a stub area? (Choos...
Question 11: Click the Exhibit button. (Exhibit) The IS-IS adjacency betw...
Question 12: Click the Exhibit button. (Exhibit) Referring to the exhibit...
Question 13: Click the Exhibit button. (Exhibit) You have an existing Vir...
Question 14: Click to the exhibit button. Referring to the exhibit, which...
Question 15: Which two sequence correctly describe the correct processing...
Question 16: Click the Exhibit button. Referring to the exhibit, what doe...
Question 17: Click the Exhibit button. (Exhibit) Referring to the exhibit...
Question 18: Which statement is true about load balancing of equal cost p...
Question 19: What is reviewed first in the BGP route selection process?...
Question 20: Depending on the link type, OSPF sends link state update pac...
Question 21: Click the Exhibit button. Referring to the exhibit, what doe...
Question 22: Which two statements are correct about redundant trunk group...
Question 23: Click the Exhibit button. (Exhibit) You are unable to establ...
Question 24: Click the Exhibit button. (Exhibit) Referring to the exhibit...
Question 25: What is considered a requirement for passing traffic through...
Question 26: Click the Exhibit button. Switch-1 in the exhibit receives a...
Question 27: Click the Exhibit button. Referring to the exhibit, Router-1...
Question 28: Click the Exhibit button. (Exhibit) What would cause the sta...
Question 29: Click the Exhibit button. (Exhibit) Referring to the outputs...
Question 30: Click the Exhibit button. Referring to the exhibit, you are ...
Question 31: You notice that there are currently two MAC addresses associ...
Question 32: Click the Exhibit button. Referring to the exhibit, which st...
Question 33: Click the Exhibit button. (Exhibit) Referring to the exhibit...
Question 34: Click the Exhibit button. (Exhibit) The configuration shown ...
Question 35: Which two statements about RSTP are correct? (Choose two.)...
Question 36: You manage a Layer 2 network that spans two buildings. You a...
Question 37: Click the Exhibit button. (Exhibit) Referring to the exhibit...
Question 38: Click the Exhibit button. Referring to the exhibit, which ro...
Question 39: Which statement about IS-IS adjacencies is true?...
Question 40: Which two statements are true about nonstop bridging (NSB)? ...
Question 41: Which protocol prevents loops and calculates the best path t...
Question 42: You are currently defining a new OSPF area. The area must ad...
Question 43: Which two statements are correct about a Virtual Chassis?...
Question 44: You have deployed a Juniper EX Series switch in the network....
Question 45: What are three types of bridge protocol data units? (Choose ...
Question 46: Which three mechanisms are associated with the bridging proc...
Question 47: Click the Exhibit button. Referring to the exhibit, which st...
Question 48: Which three BGP attributes are well-known and mandatory? (Ch...
Question 49: Click the Exhibit button. (Exhibit) Referring to the exhibit...
Question 50: Which two statements describe the BGP Local Preference attri...
Question 51: Click the Exhibit button. In the exhibit, each IP subnet in ...
Question 52: Click the Exhibit button. (Exhibit) You are establishing a B...
Question 53: Click the Exhibit button. (Exhibit) You manage the Layer 2 n...
Question 54: There is a GRE tunnel configured over the Internet between R...
Question 55: Click the Exhibit button. Referring to the exhibit, which po...
Question 56: Which two statements are true about link aggregation groups ...
Question 57: Click the Exhibit button. Based on the output shown in the e...
Question 58: What are two OSPF packet types that use multicast for commun...
Question 59: Click the Exhibit button. (Exhibit) You are troubleshooting ...
Question 60: You are troubleshooting your OSPF configuration and notice t...
Question 61: Click the Exhibit button. (Exhibit) Referring to the exhibit...
Question 62: Which three link-specific fields must match between OSPF nei...
Question 63: Click the Exhibit button. (Exhibit) Referring to the exhibit...
Question 64: Click the Exhibit button. (Exhibit) There are dynamically an...
Question 65: What are three RSTP port states? (Choose three.)...
Question 66: Which two port security features are dependent on the DHCP s...
Question 67: Which statement describes optional transitive BGP attributes...
Question 68: Click the Exhibit button. (Exhibit) What will be two results...
Question 69: Click to the Exhibit button. Referring to the exhibit, which...
Question 70: You received an alert from your monitoring system that the m...
Question 71: Click the Exhibit button. Referring to the exhibit, what is ...
Question 72: An EX Series switch receives a frame with an unknown destina...
Question 73: What are three components that populate the Ethernet switchi...
Question 74: You are asked to ensure that a designated interface on an EX...
Question 75: Which two statements are true about the IRB interface? (Choo...
Question 76: Which static route next-hop value indicated that the packet ...
Question 77: Click the Exhibit button. Referring to the exhibit, which ty...
Question 78: Which Junos feature allows you to combine multiple interface...
Question 79: Which two statements are true about OSPF not-so-stubby areas...