Valid JN0-104 Dumps shared by ExamDiscuss.com for Helping Passing JN0-104 Exam! ExamDiscuss.com now offer the newest JN0-104 exam dumps, the ExamDiscuss.com JN0-104 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com JN0-104 dumps with Test Engine here:
Access JN0-104 Dumps Premium Version
(145 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 26/106
You have enabled trace options to log error messages. You want to have the messages displayed to your terminal session automatically as they occur.
Which command should you use in this scenario?
Which command should you use in this scenario?
Correct Answer: D
- Question List (106q)
- Question 1: Given the following configuration, set system authentication...
- Question 2: Which operational mode command will provide real-time usage ...
- Question 3: Which statement describes the ulst next-hop type that appear...
- Question 4: The IP address 10.1.1.1 belongs to which class of IP address...
- Question 5: You want to temporarily apply a candidate configuration to t...
- Question 6: Which command is used to load the rescue configuration?...
- Question 7: Which command causes the Junos OS to temporarily activate a ...
- Question 8: Click the Exhibit button. (Exhibit) What is the next hop for...
- Question 9: Which two statements describe the default behavior for OSPF?...
- Question 10: When a system process encounters an error, how does the Juno...
- Question 11: What are three benefits of using a dynamic routing protocol?...
- Question 12: Which source of routing information is preferred by default?...
- Question 13: Which two statements are correct about the request system ze...
- Question 14: You must configure the 2bfc:0000:0000:beef:0217:cbff:0000:5c...
- Question 15: Click the Exhibit button. (Exhibit) Referring to the exhibit...
- Question 16: Exhibit: (Exhibit) You notice traffic destined to 172.31.17....
- Question 17: Click the Exhibit Button. (Exhibit) You are asked to limit t...
- Question 18: Referring to the exhibit. (Exhibit) what happens when you is...
- Question 19: Click the Exhibit button. (Exhibit) You must apply the polic...
- Question 20: What is the network ID address of the IPv4 subnet that inclu...
- Question 21: What's is the minimum system-defined user class required to ...
- Question 22: What are two examples of transit traffic? (Choose two.)...
- Question 23: Which statement about the Junos OS forwarding table is corre...
- Question 24: Which command allows you to view the raw packet data of inte...
- Question 25: What are two important steps when upgrading an SRX300 Series...
- Question 26: You have enabled trace options to log error messages. You wa...
- Question 27: Which three benefits are made possible by the separation of ...
- Question 28: Which two statements about the configure exclusive command a...
- Question 29: Click the Exhibit button, (Exhibit) You are creating a new r...
- Question 30: Which statement is true about a virtual router routing insta...
- Question 31: Which two conditions must exist in a Junos device for traffi...
- Question 32: Click the Exhibit button. (Exhibit) Which statement is corre...
- Question 33: Which component is responsible for performing protocol updat...
- Question 34: You are asked to configure a Junos device to perform regular...
- Question 35: Which two statements describe PFE functions are true?...
- Question 36: Which two parameters are considered action modifiers in the ...
- Question 37: What are two configurable physical interface properties? (Ch...
- Question 38: What happens when a route does not match any user-configured...
- Question 39: What are two benefits realized by the disaggregated Junos? (...
- Question 40: Which two interfaces are considered physical interface? Choo...
- Question 41: You are troubleshooting an issue and want to monitor syslog ...
- Question 42: Which keystroke combination allows users to move the cursor ...
- Question 43: Referring to the exhibit, (Exhibit) which command will cause...
- Question 44: Which two interfaces are considered logical interfaces? (Cho...
- Question 45: What are two default password requirements on devices runnin...
- Question 46: Given the configuration shown below: set system authenticati...
- Question 47: Which two statements are correct about the inet.0 routing ta...
- Question 48: Which key could you use to auto-complete a command in the Ju...
- Question 49: Depending on the device type, Junos is built upon which two ...
- Question 50: Which command displays the output shown in the exhibit? (Exh...
- Question 51: Which two conditions must exist in a Junos device for traffi...
- Question 52: Host A is communicating with Host B through a Layer 2 switch...
- Question 53: For the interface ge-1/2/3.4, what does "ge" represent?...
- Question 54: Which two platforms are supposed in both physical and virtua...
- Question 55: Click the Exhibit button (Exhibit) Referring to the exhibit,...
- Question 56: What is the default location of the syslog file on Junos dev...
- Question 57: Which parameter would you use to prohibit the redistribution...
- Question 58: What are three functions of the RE? (Choose three.)...
- Question 59: Which protocol is responsible for learning an IPv6 neighbor'...
- Question 60: Referring to the exhibit, which statement is true?...
- Question 61: Which two statements about login classes are correct? (Choos...
- Question 62: Click the Exhibit button (Exhibit) You are capturing logs to...
- Question 63: Referring to the exhibit, what information is provided about...
- Question 64: Which command is used to replace the current configuration?...
- Question 65: What is the initial prompt displayed when logging in as the ...
- Question 66: Which three protocols are connectionless? (Choose three.)...
- Question 67: Which statement about the show chassis hardware Command is c...
- Question 68: Which two statements are true about static routes in the Jun...
- Question 69: What information would you find using the CLI help function?...
- Question 70: Which two commands will provide the current configuration of...
- Question 71: Which statement regarding transit traffic processing is corr...
- Question 72: What is minimum configuration required for a Junos device to...
- Question 73: What are three firewall filter terminating actions? (Choose ...
- Question 74: Click the Exhibit button. -- Exhibit -- user@router> rest...
- Question 75: Which two firewall filter actions will affect a packet's cla...
- Question 76: You are asked to configure filter-based forwarding Which rou...
- Question 77: How does the PFE determine how to forward transit traffic?...
- Question 78: What are two services performed by the Packet Forwarding Eng...
- Question 79: Referring to the exhibit, which command will change the 172....
- Question 80: Which statement is correct regarding exception traffic on Ju...
- Question 81: Which account is used to access a Junos device in a factory-...
- Question 82: When you first log in to a router, how does the router indic...
- Question 83: Which statement about the forwarding table is correct?...
- Question 84: What is the name of the volume containing the software and f...
- Question 85: Which parameter of the monitor traffic command should be use...
- Question 86: Click the Exhibit button. (Exhibit) Your Junos device is usi...
- Question 87: You must verify that interface ge-0/0/0.0 is administrativel...
- Question 88: Which two keystrokes are used to auto-complete commands? (Ch...
- Question 89: Which Junos release would address only bug fixes that were n...
- Question 90: Which two statements describe the connection between control...
- Question 91: You successfully established a BGP session with peer, but do...
- Question 92: Which two interfaces are considered as physical interface? (...
- Question 93: A BGP route does not match any term within a routing policy ...
- Question 94: You suspect a duplicate MAC address on a subnet. You want to...
- Question 95: Exhibit: (Exhibit) While working on a Junos Device, you rece...
- Question 96: Which two commands would you use to reset the candidate conf...
- Question 97: You are troubleshooting an issue and want to monitor syslog ...
- Question 98: Click the Exhibit button (Exhibit) Referring to the exhibit,...
- Question 99: Which two statements about the Junos OS are true? (Choose tw...
- Question 100: What is the purpose of the discard action of a firewall filt...
- Question 101: Which command verifies configuration syntax without applying...
- Question 102: By default, which character indicates the UNIX shell prompt?...
- Question 103: Your firewall filters are not in the correct order, what wou...
- Question 104: Which three statements describe OSPF? (Choose three)...
- Question 105: How would you change the display so the display so that 40 l...
- Question 106: What are two protocols that the Junos OS uses to archive con...
