<< Prev Question Next Question >>

Question 15/25

Which of the following channels is used to send uplink power control commands?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (25q)
Question 1: The PCFICH and PHICH channels have been deleted from the phy...
Question 2: Which of the following is not a typical application scenario...
Question 3: In a Huawei base station, which of the following bearers can...
Question 4: Which of the following is not the cause of cell unavailabili...
Question 5: Which of the following protocols/data belong to Layer 3 of t...
Question 6: In NSA networking, which of the following methods can be use...
Question 7: In an intra-frequency reselection procedure, which message c...
Question 8: In the MR-DC architecture, which of the following factors af...
Question 9: In downlink peak rate testing, the modulation and coding sch...
Question 10: On a 5G network, the NAS layer uses 5G-GUTI to replace IMSI ...
Question 11: In SA networking, which of the following messages is used to...
Question 12: Which of the following protocol layers has been added to the...
Question 13: Which of the following is not covered by a site survey?...
Question 14: Which of the following items can be used for measurement eva...
Question 15: Which of the following channels is used to send uplink power...
Question 16: Which of the following NR system indicators is at the base s...
Question 17: What is the maximum bandwidth in mmWave bands as defined in ...
Question 18: Slot distribution in BBU5900 is the same as that in BBU3910....
Question 19: Which of the following boards support CPU usage query?(Selec...
Question 20: Which of the following protocols/data belong to Layer 3 of t...
Question 21: Which of the following spectrum sharing technologies can be ...
Question 22: Which of the following are common causes of overshoot covera...
Question 23: Which of the following statements about the space principles...
Question 24: How many RBs are included when a bandwidth of 100 MHz and a ...
Question 25: Which of the following statements about downlink beamforming...