<< Prev Question Next Question >>

Question 37/48

In the LTE system, the radio interface includes layer 1, layer 2, and layer 3, wherein layer 1 is a physical layer; layer 2 includes MAC layer, an RLC layer, and PDCP layer, wherein the MAC layer performs ARQ functions.

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (48q)
Question 1: Regarding the carrier aggregation characteristics, which of ...
Question 2: D, F, E spectrum corresponding frequency band are respective...
Question 3: Regarding the over-zone, overlapping coverage control, which...
Question 4: In the LTE network, which of the following is the handover c...
Question 5: Which of the following handovers will definitely not go to t...
Question 6: In the downlink scheduling, which factors will affect the al...
Question 7: Which of the following scenarios need to use the RIM process...
Question 8: Which QCI does IMS signaling correspond to?...
Question 9: Which of the following value does the service cell reselecti...
Question 10: Which of the following messages contains UE history informat...
Question 11: Which of the following modulation method can LTE system supp...
Question 12: The UBBP board supports reuse of baseband resources between ...
Question 13: Which of the following reasons will cause radio frequency un...
Question 14: Which of the following description about GPS laying principl...
Question 15: Which of the following defines the maximum sum of all non-GB...
Question 16: Regarding LTE neighbor cell planning, Which of the following...
Question 17: In large, medium and small cities, many streets have tall bu...
Question 18: In the process of Attach/TAU/Handover, which of the followin...
Question 19: Which of the following NE (Network Element) does the packet ...
Question 20: Which of the following interface is based on the Diameter pr...
Question 21: SFBC is a transmit diversity technology that mainly obtains ...
Question 22: What is the role of IMRN in VOLTE?...
Question 23: What are the correct adjustment principles for RE and ABS in...
Question 24: What are the effects of improper adjustment of the mechanica...
Question 25: What information is determined by the location of the PHICH ...
Question 26: During the test, the bit error rate below 20% is normal....
Question 27: About the description of the gateway selection in EPC, which...
Question 28: What are the control information that PUCCH can carry? (Mult...
Question 29: Which of the following factors will affect the coverage dist...
Question 30: Which information has been re-acquired after the service req...
Question 31: In SAE, which of the following entity use to deal with the c...
Question 32: The RET interface on RRU is used to connect tunable antenna....
Question 33: Huawei base station all version supports multiple RRU merger...
Question 34: Which of the following statements about LTE tools is ? (Mult...
Question 35: Regarding TA planning, which of the following statements is ...
Question 36: Which of the following channels can change the modulation mo...
Question 37: In the LTE system, the radio interface includes layer 1, lay...
Question 38: The wireless layer access class information, which is alloca...
Question 39: Which of the following modules does the AAU function module ...
Question 40: Which of the following parameters is not used for cell resel...
Question 41: Which of the following transmission modes does the RLC layer...
Question 42: When CPRI uitzoomen distance is greater than 20km and less t...
Question 43: When the user is in ECM-IDLE state, which of the following i...
Question 44: Which of the following options can improve the VOLTE uplink ...
Question 45: One resource block RB has 14 symbols in the time domain and ...
Question 46: How long is the TTI of the MIB (master information block)?...
Question 47: Which of the following ways can reduce the power consumption...
Question 48: Which of the following radio bearers is used to carry RRC me...