<< Prev Question Next Question >>

Question 27/104

Before the gNode configuration is adjusted, in order to avoid alarm reporting and display in the network management foreground, the project status cannot be set to which of the following states?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (104q)
Question 1: What are the RRUs that support the FDD 1800M uplink and down...
Question 2: Which of the following description about the CRAN pre-transm...
Question 3: Regarding BWP, what is the following description correct?...
Question 4: gNodeB The order in which hardware devices are added is "cab...
Question 5: 5G RAN side service slice management, which of the following...
Question 6: Which is the correct description of the NR time domain resou...
Question 7: Regarding the description of NSA networking, which of the fo...
Question 8: Which of the passive WDM schemes for CRAN fronthaul is corre...
Question 9: When a CPE device is upgraded in the near end, the firmware ...
Question 10: Compared with 4G, 5G redefines the core network NGC, which n...
Question 11: When gNodeB planning has multiple IP addresses and different...
Question 12: The calculation formula of the absolute frequency point of t...
Question 13: gNodeB's baseband device BascbandEQM is an optional addition...
Question 14: Which of the following requirements does the 5G eMBB scene t...
Question 15: 3GPP Release Version 15 does not describe which 5G applicati...
Question 16: What is the vision of IMT-2020 for the peak rate of 5G netwo...
Question 17: What is the correct description of the fiber straight-pull s...
Question 18: Performing a VSWR test on the U2000 causes service interrupt...
Question 19: 5G RAN 2.0 version gNodeB logical cells and sector devices u...
Question 20: What is the maximum MIMO supported by the 5G Indoor CPE desi...
Question 21: When the NodeB adds the NRCELL cell information, it binds th...
Question 22: After the new NSA network is turned on, which of the followi...
Question 23: What is the application type used by the node remote mainten...
Question 24: In the NSA networking scenario, gNodeB does not need to conf...
Question 25: Which of the following boards cannot be reset by command?...
Question 26: What are the networking methods between the BBU and the RF u...
Question 27: Before the gNode configuration is adjusted, in order to avoi...
Question 28: Which of the following is not a BBU veneer?...
Question 29: Under NSA networking, the X2 interface of gNB can be self-es...
Question 30: What is the length of the TTI scheduled in the 5G NR?...
Question 31: The bandwidth of PRACH in NR is fixed....
Question 32: Which of the following high-frequency communication uplink a...
Question 33: Which functional modules of the BTS5900A base station are op...
Question 34: In the NSA Networking Option3x series scenario, gNodeB must ...
Question 35: When gNodeB enables the MassiveMIMO function, select "Beam" ...
Question 36: In the NSA network test using Probe, it was found that the M...
Question 37: The transmission data in the initial data configuration of t...
Question 38: What are the negotiation parameters that the NodeB needs to ...
Question 39: The transmitted data in the initial data configuration of gN...
Question 40: Regarding the NR slot structure, what are the correct terms ...
Question 41: Which of the following bands does the candidate SUL spectrum...
Question 42: The NSA networking needs to modify the original EPS. What ot...
Question 43: In the process of automatically obtaining an IP address thro...
Question 44: In the NSA networking option3 series scenario, gNodeB must c...
Question 45: In the 5G RAN2.0 version, what is the maximum number of 100M...
Question 46: To delete the original default data before configuring gNode...
Question 47: Which of the following description about AAU5613 is wrong?...
Question 48: Which MML command is used to bind the physical sector of gNo...
Question 49: NR is divided into competitive and non-competitive random ac...
Question 50: In the GL to GL+NR (BBU39XO+BBU5900) evolution path, which o...
Question 51: Which of the following half-width 5G baseband boards are sup...
Question 52: NSA networking needs to modify the original EPS, in addition...
Question 53: Regarding DWP, what are the correct descriptions of the foll...
Question 54: The NR neighboring cell measurement event of the UE adopts B...
Question 55: The gNodeB alarm level includes emergency alarms, important ...
Question 56: Which of the following are gNodeB mandatory modules? (Multip...
Question 57: There is no scene of clock interlock between the NR and GL b...
Question 58: On the NSA network, which of the following commands can be u...
Question 59: gNodeB sector is deployed using AAU5613, what is the maximum...
Question 60: In an NSA networking scenario, the gNodeB does not need to b...
Question 61: Which entity is the RLC layer used for detection and error c...
Question 62: When NSA selects and interprets the 2.6Ghz band networking, ...
Question 63: Which of the following does not belong to the BBU board?...
Question 64: AAU/RRU and BBU fronthaul fiber is less than 100 meters, mos...
Question 65: What are the configuration modules that differ between the g...
Question 66: What is the MML command used by gNodeB to add CI port config...
Question 67: Execute "route add 10.10.10.0 mask 255.255.255.0 192.168.5.1...
Question 68: Which of the following AAUs is suitable for the 2.6Ghz scena...
Question 69: Which channel is 5G used for downlink data demodulation and ...
Question 70: What is the maximum rate of the Ethernet port supported by g...
Question 71: The calculation formula of the absolute frequency of gNodeB ...
Question 72: gNodeB binds the carrier ID when adding tracking area inform...
Question 73: What is the maximum number of UBBP boards can the BBU5900 ac...
Question 74: The fan modules of the BBU3910 and BBU5900 are compatible....
Question 75: Which of the following parameters is related to the frequenc...
Question 76: What is the maximum number of UBBP boards can the BBU5900 ac...
Question 77: Only 60 kHz subcarrier bandwidth supports extended CP config...
Question 78: DCDU-12B is a DC power distribution unit. How much DC power ...
Question 79: Which of the following boards supports software reset?...
Question 80: When debugging the NR base station through the near end of t...
Question 81: Which module is used in the base station power system to mon...
Question 82: When gNodeB adds NRCELL cell information, it binds the DU un...
Question 83: In the C-band scenario defined by R15, which of the followin...
Question 84: In order to verify the successful establishment of NSA servi...
Question 85: The maximum transmit power of NRDUCELTRP in the gNode config...
Question 86: Which of the following high-frequency communication uplink a...
Question 87: The transmission DSCP value indicates the priority of the di...
Question 88: Which of the following protocols/data are attributed to Leve...
Question 89: When the CU/DU is combined, the CU logical node and the DU l...
Question 90: Which of the following two cells has a relatively large PBCH...
Question 91: In the NSA networking option3x scenario, which MOs in the S1...
Question 92: Under the EN-DC architecture, the eNodeB/gNodeB only support...
Question 93: Which command does gNodeB use to complete the configuration ...
Question 94: VSWR testing on U2000 will cause business interruption and p...
Question 95: Only the 60kHz subcarrier bandwidth supports the configurati...
Question 96: The uplink and downlink subframe ratio of 5G RAN2.0 gNodeB c...
Question 97: Which of the following factors affects the peak CPE downlink...
Question 98: What is the broadcast period of MIB messages in NR?...
Question 99: Before deleting the original default data before configuring...
Question 100: On the NSA network, what objects are unnecessary in the self...
Question 101: Which of the following are new RNTI types in NR? (Multiple c...
Question 102: When logging in to the CPE Web Management page, the LTE indi...
Question 103: Which application scenario of 5G is not described in 3GPP Re...
Question 104: QoS of gNB implements hierarchical congestion management of ...