<< Prev Question Next Question >>

Question 77/121

OSPF is deployed in a campus to achieve network interworking, and OSPF is also enabled on the GEO/0/2 interface of R3. Area1 is deployed as an NSSA area, and the device addresses are shown in the figure. An engineer configures a static route on R3 to access the loopback interface address of R4, and imports the static route in the 0SPF process. At this point, in the Type5 LSA received by R1, the forwarding address (FA) is____. (Note: Please fill in the IP address without mask)

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (121q)
Question 1: About the site in the BGPIMPLS IP VPN network architecture. ...
Question 2: By executing the () command, users on different ports of the...
Question 3: Which description is correct about the MPLS forwarding mecha...
Question 4: Regarding multi-instance CE (Mlulti-VPN-Instance CE, MCE), w...
Question 5: As shown in the figure, network administrator A on the R1 ro...
Question 6: According to this picture, what can we judge? (Multiple choi...
Question 7: What is the most efficient way to view device alarms through...
Question 8: ping -a X-c Y-s z -vpn-instance M 10.5.16.2, what is the mea...
Question 9: The Discovery message of LDP is used for neighbor discovery,...
Question 10: A router runs OSPF, and the output information is shown in t...
Question 11: The rollback operation of the project cutover can be determi...
Question 12: From this figure, we can conclude that (Exhibit)...
Question 13: Which of the following regarding the configuration descripti...
Question 14: (Connection question) Please match the command with the real...
Question 15: Traditional BGP4 can only manage IPv4 unicast routing inform...
Question 16: Basic QinQ can choose the outer tag encapsulation method acc...
Question 17: For the same MA, C address, manually configured MA, C entrie...
Question 18: There is the concept of forwarding equivalent FEC in MPLS. W...
Question 19: Which of the following descriptions is wrong?...
Question 20: Through the display ip interface GE0/D/D command, you can vi...
Question 21: Regarding the label space of MPLS, which of the description ...
Question 22: In the multi-level RR scenario, a large number of secondary ...
Question 23: Which of the following statements about 1S-IS (IPv6) is true...
Question 24: The routing attributes of the three routing entries are show...
Question 25: The cutover risk assessment mainly considers which of the fo...
Question 26: An engineer used two routers to test IPv6 services, and simu...
Question 27: As shown in the figure, on the R1 router, network administra...
Question 28: After the cutover acceptance is completeD. what work still n...
Question 29: According to this picture, you can judge (Exhibit)...
Question 30: Please sort by the cutover execution steps....
Question 31: As shown in the figure, OSPF is deployed in a campus, and Ar...
Question 32: According to this picture, what can we judge? (Multiple choi...
Question 33: MPLS has the concept of FEC-Forwarding Equivalence Class, so...
Question 34: EGP authentication can prevent illegal routers from establis...
Question 35: Regarding the difference between NSR and NSF, which one is c...
Question 36: Which of the following are not included in the security prot...
Question 37: Which of the following descriptions is correct about configu...
Question 38: Part of the configuration of R1 is as follows. Which stateme...
Question 39: The following description of TL in PLSHeader is correct:...
Question 40: A network engineer outputs the following information when tr...
Question 41: The IS-IS neighbor between R3 and R1 is not established. Acc...
Question 42: From this picture, we can judge &lt;Redisplay ipv6 routing t...
Question 43: According to this figure, which of the following is the corr...
Question 44: After executing reset isis all, the IS-Is protocol process n...
Question 45: As shown in the figure, MPLS/BGP IPVPN is deployed on the ne...
Question 46: After a fault occurs, you need to collect and back up variou...
Question 47: The configuration shown in the figure is performed on R2 to ...
Question 48: Regarding the description of the label encapsulation format ...
Question 49: Regarding BGP/MPLS IPVPN data forwarding, which of the follo...
Question 50: In OSPF, the A, BR will convert all type 7 L SAs in the NSSA...
Question 51: If you want to check the files under Flash, which command sh...
Question 52: OSPF is deployed in a small and medium-sized network. When c...
Question 53: When deploying MPLS/BGP IP VPN, which of the following descr...
Question 54: Senior engineers with rich experience can quickly solve faul...
Question 55: Which of the following are static information coke analysis?...
Question 56: Which of the following operations may affect the normal oper...
Question 57: Network administrator A wants to use ACL to match specific r...
Question 58: BFDLink state detection at the heart (millisecond) level can...
Question 59: According to this picture, we can judge: (Exhibit)...
Question 60: When OSPFv2 evolves to OSPFv3, the format and function of LS...
Question 61: 0SPFV2 is an IGP running on an IPv4 network; 0SPFvV3 is an I...
Question 62: When deploying BGPIMPLS IPVPN, when two VPNs have a common s...
Question 63: (Drag and drop) As shown in the figure, there is a message c...
Question 64: Which of the following is wrong about DHCP Snooping?...
Question 65: As shown below: (Exhibit)
Question 66: Which of the following description of the configuration on t...
Question 67: Compared with the OSPFv2 packet header, which fields are add...
Question 68: According to this figure, it can be known that in VLAN 300, ...
Question 69: In BGP/MPLS IP VPN, the OSPF multi-instance process uses the...
Question 70: In the VLAN aggregation technology, multiple Sub-VLANs are u...
Question 71: As shown in the figure, all routers run OSPF, because R3 is ...
Question 72: What is the command to adjust the link cost of an IS-IS inte...
Question 73: As shown, all routers run OSPF. Which of the following state...
Question 74: Since BGP is an EGP routing protocol, BGP routing policies c...
Question 75: As shown in the figure, all interfaces of the router enable ...
Question 76: What types of Link Types are included in the Router LSA in O...
Question 77: OSPF is deployed in a campus to achieve network interworking...
Question 78: During the process of viewing the debug output through the S...
Question 79: (Drag and drop) Network administrator A needs to permit or d...
Question 80: As shown in the figure, Site1 and Site2 need to achieve mutu...
Question 81: What is the meaning of display current-configuration I inclu...
Question 82: According to this picture, the door can be judged? (Exhibit)...
Question 83: In addition to the virtual link, what type of IPv6 address i...
Question 84: According to the configuration shown in the figure below, yo...
Question 85: In OSPFv3, an LSA whose propagation range is one area has___...
Question 86: The Discovery message of LDP is used for neighbor discovery,...
Question 87: Regarding BGP/MPLS IPVPN routing interaction, which of the f...
Question 88: In an operator's MPLSVPN network, there are two devices, PE1...
Question 89: There is a concept of forwarding equivalence class (FEC-Fowa...
Question 90: The OSPF protocol runs between CE and PE, when CE1 advertise...
Question 91: About the difference between NSR and NSF, which is correct?...
Question 92: As shown in the figure, Client1 and Client2 act as clients o...
Question 93: The network administrator A wants to use the IP Prefix List ...
Question 94: Run the display ip interface GEO/D/D command to view statist...
Question 95: From the user's point of view, any phenomenon that affects t...
Question 96: To prevent hackers from attacking user devices or networks t...
Question 97: An enterprise purchased the leased lines of two operators. I...
Question 98: Which of the following statements about IPSG is false?...
Question 99: Regarding MP-BGP, which of the following descriptions is wro...
Question 100: The description of the MPLS forwarding mechanism is correct...
Question 101: Which of the following are advantages of VLAN aggregation?...
Question 102: In an MPLS VPN network, data packets are forwarded when they...
Question 103: The routing attributes of the three routing entries are show...
Question 104: Part of the configuration of R1 is as follows. Which stateme...
Question 105: When a fault occurs, the fault can be classified to reduce t...
Question 106: LDP messages are exchanged between LSRs running the LDP prot...
Question 107: In the process of viewing the debug output through the SSH t...
Question 108: According to this picture, what can we judge? (Multiple choi...
Question 109: Which of the following are the advantages of VLAN aggregatio...
Question 110: MPLS is called multi-protocol label switching. Regarding the...
Question 111: Which of the following functions will affect the establishme...
Question 112: When a fault occurs, the fault can be classified to reduce t...
Question 113: IS-IS is a link-state routing protocol that uses the SPF alg...
Question 114: By default, LDP adjacencies will trigger the establishment o...
Question 115: What is the default aging time of the MA, C address table of...
Question 116: As shown in the figure, OSPF is enabled on all interfaces of...
Question 117: As shown in the figure, R1, R2, R3, and R4 are in the same M...
Question 118: The Router ID of OSPFv3 needs to be configured in dotted dec...
Question 119: Which of the following information can the DHCP binding tabl...
Question 120: For the same MAC address, the priority of the manually confi...
Question 121: An engineer uses two routers to test IPv6 services, and simu...