<< Prev Question Next Question >>

Question 9/87

In an operator's MPLSVPN network, there are two devices, PE1 and PE2, for MPLSVPN data forwarding. PE1 receives a 172.16.1.0/24 private network route from the client, and transforms it into a VPNv4 route on PE1 and assigns labels. Released to PE2 as 1027. The outgoing label of the MPLSLSR-ID from PE2 to PE1 is 1025.
When the client on PE2 accesses 172.16.1.0/24, the inner and outer labels of the frame sent by PE2 should be the combination of the following options?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (87q)
Question 1: BGP routing strategy can control the distribution and recept...
Question 2: Which of the following statements about LDP label retention-...
Question 3: Display interface GE0/0/0 once, and find that the Total Eror...
Question 4: Qing technology is a technology that expands the VLAN space....
Question 5: Network administrator A wants to check the neighbor status o...
Question 6: As shown in the figure: (Exhibit)...
Question 7: If the temperature of the device is found to be too high, it...
Question 8: When troubleshooting MSTP, you executed the display current-...
Question 9: In an operator's MPLSVPN network, there are two devices, PE1...
Question 10: For the same MAC address, the priority of the manually confi...
Question 11: According to this picture, we can judge: (Exhibit)...
Question 12: (Connection) The default MPLS label release method and label...
Question 13: If you are faced with a complex network failure, and after e...
Question 14: Traditional BGP4 can only manage IPv4 unicast routing inform...
Question 15: In the intra-domain MPLS VPN network, when the data packet e...
Question 16: As shown in the figure, MPLS/BGP IPVPN is deployed in the ne...
Question 17: As shown in the figure, Site1 and Site2 need to achieve mutu...
Question 18: Regarding the difference between NSR and NSF, which one is c...
Question 19: According to this picture, what can we judge? (Multiple choi...
Question 20: Network administrator A wants to use ACL to match specific r...
Question 21: (Connection question) Please correspond the alarm level with...
Question 22: A network engineer outputs the following information when tr...
Question 23: R1 executes the operation ping -a 10.1.1.1 10.5.16.2, what d...
Question 24: . OSPFv2 is an IGP running on an IIPv4 network. OSPFV3 is an...
Question 25: By default, the Domain ID of each OSPF process running on th...
Question 26: BFD session down will cause the direct link to fail....
Question 27: The Router ID of OSPFv3 needs to be configured in dotted dec...
Question 28: As shown in the figure, the entire network of a certain comp...
Question 29: A park deployed IPv6 for business testing. There are 4 route...
Question 30: As shown in the figure, PE1 and PE2 and their respective CEs...
Question 31: (Drag and drop) Network administrator A needs to permit or d...
Question 32: EGP authentication can prevent illegal routers from establis...
Question 33: Which of the following descriptions is correct about configu...
Question 34: ping -a X-c Y-s z -vpn-instance M 10.5.16.2, what is the mea...
Question 35: Which of the following regarding the configuration descripti...
Question 36: The network administrator A wants to use the IP Prefix List ...
Question 37: Regarding multi-instance CE (Mlulti-VPN-Instance CE, MCE), w...
Question 38: What is the meaning of the display current-configuration I i...
Question 39: How to view log information? (Multiple choice)...
Question 40: When deploying MPLS/BGP IP VPN, regarding the use of BGP to ...
Question 41: By default, which of the following secure MAC address types ...
Question 42: (Connection question) Please match the command with the real...
Question 43: In OSPF, ABR will convert all Type 7 LSAs in the NSSA area i...
Question 44: When configuring the DHCP Relay function on the device, the ...
Question 45: IS-IS is a link state routing protocol that uses the SPF alg...
Question 46: In order to speed up the perception of link failures in the ...
Question 47: Which packets can Huawei equipment perform traffic suppressi...
Question 48: Compared with the OSPFv2 message header, what fields are add...
Question 49: What is the flooding scope in OSPFv3 for the LSA in the enti...
Question 50: Which of the following commands can be used to view BGP VPNv...
Question 51: What are the work that needs to be performed in the closing ...
Question 52: The OSPF protocol runs between CE and PE, when CE1 advertise...
Question 53: Which of the following statements about the MP_REACH_NLRI at...
Question 54: Which of the following is not part of the preliminary prepar...
Question 55: To ensure security, authentication can be configured in the ...
Question 56: In an MPLS domain, LSR can be divided into Ingress LSR, Tran...
Question 57: In OSPFv3, the LSA whose propagation range is an area has ()...
Question 58: According to this picture, what can we judge? (Multiple choi...
Question 59: An engineer uses two routers to test IPv6 services, and simu...
Question 60: Which of the following Community attributes can ensure that ...
Question 61: (Drag and drop) Please match the following DHCP attack types...
Question 62: According to the configuration shown in the figure below, yo...
Question 63: As shown in the figure, a certain park has deployed IPv6 for...
Question 64: Which description is correct about the MPLS forwarding mecha...
Question 65: Regarding the role of ping and tracert, which of the followi...
Question 66: OSFFv2 is an IGP running on an IPv4 network: OSPFV3 is an IG...
Question 67: Regarding the site in the BGPIMPLS IP VPN network architectu...
Question 68: A router is running OSPF, and the output information is as s...
Question 69: When deploying BCPIMPLS TP VPN, the OSPF VPN route tag (VPN ...
Question 70: MPLS is called multi-protocol label switching. Regarding the...
Question 71: Which of the following series can be matched by the regular ...
Question 72: As shown in the figure, all interfaces of the router enable ...
Question 73: In an MPLS network, there are different types of operations ...
Question 74: In an MPLS VPN network, data packets are forwarded when they...
Question 75: Which of the following reasons may cause the hosts in the sa...
Question 76: What is the purpose of configuring LSP fragmentation for IS-...
Question 77: Regarding sham link, which of the following description is w...
Question 78: According to this picture, what can we judge? (Multiple choi...
Question 79: MPLS has the concept of FEC-Forwarding Equivalence Class, so...
Question 80: What check items can be set in IPSG? (Multiple choice)...
Question 81: What types of Link Types are included in the Router LSA in O...
Question 82: As shown in the figure, all routers run OSPF, because R3 is ...
Question 83: After configuring the VLAN-based MAC address drift detection...
Question 84: In order to prevent hackers from attacking user equipment or...
Question 85: Regarding the role of ping and tracert, which of the followi...
Question 86: IS-IS supports multi-instance and multi-process, that is, on...
1 commentQuestion 87: If the display current-configuration can reach the IS-IS con...