H12-831-ENU Exam Dumps | Different virtual machines can use the VTEP tunnel established by vswitchi to communicate with VXLAN.

Home
Huawei
HCIP-Datacom
Huawei.H12-831-ENU.v2022-12-31.q142
Question 17

Valid H12-831-ENU Dumps shared by ExamDiscuss.com for Helping Passing H12-831-ENU Exam! ExamDiscuss.com now offer the newest H12-831-ENU exam dumps, the ExamDiscuss.com H12-831-ENU exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com H12-831-ENU dumps with Test Engine here:

Access H12-831-ENU Dumps Premium Version
(420 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 17/142

Different virtual machines can use the VTEP tunnel established by vswitchi to communicate with VXLAN. Then the communication process of VXLAN is: 1 The source VTEP encapsulates the ARP broadcast sent by the source VM into a multicast packet and sends it to the L3 network. 2 After receiving the multicast packet, the destination VTEP learns the mapping relationship between the source VM and VTEP, and forwards the multicast packet to the local VM. 3 Local unicast response. 4 The destination VTEP encapsulates the Vxlan tunnel, establishes a mapping table and encapsulates it, and then unicasts it to the source VTEP. 5 The source VTEP receives the response and establishes the mapping relationship between the target VM and the target VEP, removes the tunnel and forwards it to the source VM. 6 The source VM and the target VM communicate unicast packets through the tunnel.

A. 3-5-2-4-1-3

B. 1-2-3-4-5-6

C. 1-3-2-4-6-5

D. 1-5-6-4-3-2

Correct Answer: B

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (142q): Question 1: Which of the following descriptions of RT is correct? (Multi...; Question 2: According to this figure, what can we judge? (Multiple choic...; Question 3: The ORF function of BGP can control the routing entries sent...; Question 4: Which of the following limitations of traditional networks d...; Question 5: Through the display ip interface GE0/0/0 command, you can vi...; Question 6: If faced with a complex network failure, and after evaluatio...; Question 7: As shown in the figure, all routers run OSPF, because R3 is ...; Question 8: OSPFv2 is an IGP that runs on IPv4 networks. OSPFV3 is an IG...; Question 9: MPLS has always been slower than IP forwarding....; Question 10: When MPLS is deployed in the network and the network layer p...; Question 11: What is the command to adjust the IS-IS interface link cost ...; Question 12: By executing the command ( ), users on different ports in th...; Question 13: Which of the following is correct when conducting equipment ...; Question 14: As shown in the figure, the router runs OSPF, and Area 2 is ...; Question 15: IS-IS supports the processing and calculation of IPV6 routes...; Question 16: The IS-IS neighbor relationship between R3 and R1 is not est...; Question 17: Different virtual machines can use the VTEP tunnel establish...; Question 18: As shown in the figure. (Exhibit) What can we judge from thi...; Question 19: Which of the following statements is true about the multicas...; Question 20: Regarding the description of OSPF's neighbor relationship fa...; Question 21: MPLS is called Multi-Protocol Label Switching, which descrip...; Question 22: IS-IS supports multiple instances and multiple processes, th...; Question 23: As shown in the figure, the network has a loop because STP i...; Question 24: The role of Link-LSA in OSPFv3 does not include:...; Question 25: The QoS technique commonly used for congestion avoidance is?...; Question 26: What can we infer from this graph? (Multiple choice) (Exhibi...; Question 27: According to this figure, can we judge whether R4 is on? (Ex...; Question 28: MTBF, MRRT and other indicators are used to describe which o...; Question 29: OSFFv2 is an IGP running on an IPv4 network, and OSPFV3 is a...; Question 30: After a fault occurs, it is necessary to collect and backup ...; Question 31: High-risk operations refer to all operations that may affect...; Question 32: In order to quickly detect network link failures, which of t...; Question 33: Network administrator A wants to use the IP Prefix List to m...; Question 34: As shown in the figure, the operator's BGP MPLS IP VPN backb...; Question 35: When a large number of IP phones and WLAN APs need to be acc...; Question 36: According to this figure, what can we judge? (Multiple choic...; Question 37: Configure ipv6 preference in IS-IS protocol view. The functi...; Question 38: A campus deploys both IPv4 and IPv6 networks for service tes...; Question 39: Which command descriptions are correct for the PC to obtain ...; Question 40: As shown in the figure, OSPF is enabled on all interfaces of...; Question 41: As shown in the figure, Site1 and Site2 need to achieve mutu...; Question 42: When configuring MPLS VPNI, the administrator configured the...; Question 43: OSPF fast convergence is an extended feature to improve the ...; Question 44: BFD can implement link state detection at the s (millisecond...; Question 45: The ipv6 enable topology standard is configured in the IS-IS...; Question 46: Access control refers to restricting or blocking specific ac...; Question 47: What are the advantages of PQ+WFQ? (Multiple choice)...; Question 48: When encountering a large-scale network cutover project, it ...; Question 49: According to this figure, what can we judge? (Multiple choic...; Question 50: The DHCP protocol can assign some TCP/IP-related parameter i...; Question 51: In the test phase of the cutover, the criteria for indicatin...; Question 52: The operation process for putting the equipment on the shelf...; Question 53: When encountering network failures, engineers often use hier...; Question 54: In the following description, which of the following items a...; Question 55: What characteristics must a high-risk operating program have...; Question 56: As shown in the figure, OSPF is enabled on all interfaces of...; Question 57: A campus has deployed IPv6 for service testing. There are 4 ...; Question 58: The routing policy tools that BGP can use mainly include Fil...; Question 59: What information can be used for complex traffic classificat...; Question 60: The three basic characteristics of an SDN network architectu...; Question 61: What are the working modes of firewall interfaces? (Multiple...; Question 62: Which of the following belong to the delivery process of dry...; Question 63: Which of the following WAN links are part of a packet switch...; Question 64: In the MPLS VPN network, the data packets are forwarded when...; Question 65: What conditions must eSight meet to receive and manage devic...; Question 66: When there are multiple redundant links in an IS-IS network,...; Question 67: In order to improve network security in a company, all inter...; Question 68: For which packets can Huawei equipment perform traffic suppr...; Question 69: What are the main items included in the project implementati...; Question 70: RR rules for advertising routes violate the rules of IBGP sp...; Question 71: As shown in the figure, a campus deploys OSPF to achieve net...; Question 72: DHCP Snooping is a DHCP security feature that can be used to...; Question 73: In the label forwarding table of the MPLS device, for the sa...; Question 74: In the MPLS forwarding process, which descriptions are corre...; Question 75: According to this figure, what can we judge? (Exhibit)...; Question 76: By default, LDP adjacencies will trigger the establishment o...; Question 77: The end-to-end delay is equal to the sum of all processing d...; Question 78: When deploying BGPIMPLS IPVPN, when two VPNs have a common s...; Question 79: Man-in-the-middle attacks or IP/MAC Spooping attacks can lea...; Question 80: In the topology shown in the figure, if the entire network r...; Question 81: Which of the following statements about IS-IS (IPv4 6) is co...; Question 82: When upgrading the device software, which of the following d...; Question 83: As shown in the figure, in a medium-sized network, in order ...; Question 84: As shown in the figure, to enable the traffic between Site1 ...; Question 85: As shown in the figure, OSPF is enabled on all interfaces of...; Question 86: What can we infer from this graph? (Multiple choice) (Exhibi...; Question 87: When configuring the DHCP Relay function on the device, the ...; Question 88: Which of the following sequences can be matched by the regul...; Question 89: Which of the following statements about ASPF and Servermap i...; Question 90: After configuring the VLAN-based MAC address flapping detect...; Question 91: On the boundary between the enterprise network and the exter...; Question 92: In order to advertise IPv6 routes in BGP4+, what fields are ...; Question 93: Configured on an interface: isis timer hello5 level-2, which...; Question 94: OSPF is a very mature protocol. In the case of conventional ...; Question 95: ping-a X-c Y-s z-vpn-instance M 10.5.16.2, what is the meani...; Question 96: If the neighbor does not advertise a certain route, it means...; Question 97: MPLS is called multi-protocol label switching. Regarding the...; Question 98: As shown in the figure, the entire network of a company uses...; Question 99: Which of the following commands is used to configure VRRP pr...; Question 100: R1, R2, R3, and R4 belong to OSPF area 0, and the cost of th...; Question 101: The packet filtering firewall provides support for detecting...; Question 102: What types of Link Types are included in the Router LSA in O...; Question 103: The three authorizations required for high-risk operations d...; Question 104: As shown in the figure, an engineer uses 4 routers to test b...; Question 105: IS-IS is a link-state routing protocol that uses the SPF alg...; Question 106: A DHCP server can use different address ranges to assign to ...; Question 107: When deploying MPLS/BGP IP VPN, which of the following descr...; Question 108: OSPFV2 is an IGP running on an IPV4 network; OSPFv3 is an IG...; Question 109: Regarding the sham link, which of the following descriptions...; Question 110: Basic QinQ can choose the outer tag encapsulation method acc...; Question 111: In MPLS VPNE, in order to distinguish IPV4 prefixes that use...; Question 112: esigth uses different colors to distinguish different alarm ...; Question 113: Which description is correct about the DHCP address pool? (M...; Question 114: When configuring a RADIUS server template on a Huawei switch...; Question 115: BFD determines whether a fault occurs by periodically detect...; Question 116: As shown in the figure, a sham link is established between P...; Question 117: Regarding the BGP/MPLS IPVPN routing interaction, which of t...; Question 118: The rollback operation of project cutover can be temporarily...; Question 119: The preliminary investigation of the cutover project is main...; Question 120: In the scenario of multi-level RR, a large number of seconda...; Question 121: What is the value of the linkage between OSPF and BFD?...; Question 122: In the process of viewing the debug output through the SSH t...; Question 123: Which descriptions about the MPLS forwarding mechanism are c...; Question 124: According to this figure, which statement is correct about t...; Question 125: What traffic can port mirroring mirror? (Multiple choice)...; Question 126: The default MPLS label publishing mode, label distribution c...; Question 127: As shown in the figure, OSPF is deployed in a campus, and Ar...; Question 128: According to this figure, what can we judge? (Multiple choic...; Question 129: Deploying port isolation technology in Ethernet can realize ...; Question 130: Which protocol modules can BFD detection be associated with?...; Question 131: An engineer uses two routers to test IPV6 services, and simu...; Question 132: In the label forwarding table of the MPLS device, for differ...; Question 133: Which description is correct about the characteristics of a ...; Question 134: By viewing DHCP configuration information and packet statist...; Question 135: The Router LSA of a certain router is shown in the figure. W...; Question 136: The classic network forwarding method is based on routing ta...; Question 137: In an operator's MPLS VPN network, there are two devices PE1...; Question 138: Which of the following reasons may cause the hosts in the sa...; Question 139: When performing software and configuration backups, which of...; Question 140: An engineer uses two routers to test IPv6 services, and simu...; Question 141: An engineer uses 2 routers to test the IPV6 service, and run...; Question 142: Which of the following tools cannot be used to match BGP rou...

[×]

Download PDF File

Enter your email address to download Huawei.H12-831-ENU.v2022-12-31.q142.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 17/142

LEAVE A REPLY

Download PDF File