<< Prev Question Next Question >>

Question 128/178

A network administrator wishes to implement VLAN 10 to isolate certain users. It is common, however, for these users to often change their physical location. Which of the following VLAN implementations should be used?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (178q)
Question 1: If the value of the " Type/Length " field of an Ethernet dat...
Question 2: Which of the following methods can be used to add APs on an ...
Question 3: If Proto of a route displayed in the routing table is OSPF, ...
Question 4: Dynamic routing protocols can automatically adapt to network...
Question 5: (Each network device running SNMP runs an agent process loca...
Question 6: (ICMP packets do not contain port numbers. Therefore, NAPT c...
Question 7: Loops may cause broadcast storms on a Layer 2 network....
Question 8: What are the advantages of using DHCP to allocate IP address...
Question 9: The following figure shows the MAC address table of a switch...
Question 10: When the ACL in the following figure is configured on a Teln...
Question 11: Assuming that OSPF has been enabled on all routers in the fo...
Question 12: For the Versatile Routing Platform (VRP), the login timeout ...
Question 13: What of the following statements is correct regarding Access...
Question 14: If AAA authentication is used on Huawei devices and the remo...
Question 15: The TCP protocol uses the three-way handshake mechanism to e...
Question 16: Which of the following are advantages of stacking and CSS (C...
Question 17: Refer to the following MAC address table of a switch. Which ...
Question 18: Which of the following traffic can be filtered by an advance...
Question 19: Which of the following are features of the OSPF protocol?...
Question 20: A router that runs OSPF can enter the Full state only after ...
Question 21: The Network Management Station uses SNMP to manage devices. ...
Question 22: On the network shown in the figure, G0/0/0 and G0/0/1 of RTA...
Question 23: As shown in the figure, all switches run STP. Assume that th...
Question 24: Which of the following WLAN security policies support open l...
Question 25: Which of the following DHCP options needs to be configured o...
Question 26: Which of the following IEEE 802.11 standards support both th...
Question 27: If the MAC address of an interface is 00E0-FCEF-0FEC, the co...
Question 28: Which of the following commands can be used to change the de...
Question 29: During STP calculation, the port cost is associated with the...
Question 30: For STP, the default root path cost of the root bridge is 0....
Question 31: On an STP-enabled switch, a port in the forwarding state can...
Question 32: Which of the following are not layers in the TCP/IP model?...
Question 33: In the following figure, after the OSPF routers converge, in...
Question 34: To enable the FTP server function on a router, set the usern...
Question 35: Refer to the following figure of the ACL configured on a rou...
Question 36: On a Layer 2 WLAN, STAs use an AC as their gateway....
Question 37: (The IP addresses of VLANIF interfaces on the same switch mu...
Question 38: Which of the following port numbers is used by the FTP contr...
Question 39: To enable Router A to communicate with Loopback 0 on Router ...
Question 40: As specified by the RSTP protocol, when a root port fails, w...
Question 41: A switch needs to forward a frame with the destination MAC a...
Question 42: A routing entry contains multiple fields. Which of the follo...
Question 43: Which of the following descriptions regarding the TTL field ...
Question 44: (You can run the " pwd " and " dir " commands on the Versati...
Question 45: Which of the following planes does a network device have?...
Question 46: The following figure shows the display stp command output on...
Question 47: After a switch restarts, static MAC address entries saved on...
Question 48: As shown in the figure, which of the following ports will be...
Question 49: A router in the backbone area has complete LSDBs of routers ...
Question 50: As shown in the figure, the configuration of Router A is as ...
Question 51: Refer to the following figure of the ACL configured on a rou...
Question 52: Refer to the following configuration of an interface on a sw...
Question 53: Which of the following statements are true about the shortcu...
Question 54: Which of the following statements about the output on the ro...
Question 55: In the following figure, all links are Ethernet links, and a...
Question 56: The following configuration commands implement route backup ...
Question 57: Network Address and Port Translation (NAPT) allows multiple ...
Question 58: Which of the following statements about the routing table sh...
Question 59: Which of the following configurations can prevent Host A and...
Question 60: A Windows host is started for the first time. If the host ob...
Question 61: What are the advantages of OSPF?...
Question 62: Which of the following commands sets the data forwarding mod...
Question 63: Which of the following parts compose SNMP?...
Question 64: Refer to the following display vlan command output. Which of...
Question 65: Which of the following fields are contained in an ARP packet...
Question 66: For an Eth-Trunk in LACP mode, what is the default LACP syst...
Question 67: When the host accesses the web service of the server, the va...
Question 68: While inspecting packets in the network, a network administr...
Question 69: Which of the following parameters is not used by an Advanced...
Question 70: Which of the following authentication methods are supported ...
Question 71: UDP is connectionless. As such, which of the following must ...
Question 72: IPv6 uses NS and NA packets to perform duplicate address det...
Question 73: Which of the following sources of routes can be obtained by ...
Question 74: On the command line interface of Huawei AR routers, the role...
Question 75: On the network shown in the figure, VLAN 2 is created on SWA...
Question 76: An ACL rule is as follows. Which of the following IP address...
Question 77: Which of the following is not a common network layer in a mi...
Question 78: Which extension headers are supported by IPv6 packets?...
Question 79: Which of the following methods is not used for logging in to...
Question 80: On the network shown in the figure, Host A and Host B cannot...
Question 81: Which of the following is a valid default route configuratio...
Question 82: Which of the following network types are supported by OSPF?...
Question 83: An ACL is essentially a packet filter. An ACL takes effect o...
Question 84: Which of the following protocols can be used to prevent loop...
Question 85: A trunk interface allows frames from multiple VLANs includin...
Question 86: Assume that an OSPF-enabled router has no loopback interface...
Question 87: Which of the following commands can switch a view from the s...
Question 88: Trunk interfaces can send both tagged and untagged frames....
Question 89: Assuming all STP enabled switches have the same bridge prior...
Question 90: Which of the following is the default port number for networ...
Question 91: If Spanning Tree Protocol (STP) is disabled on the network c...
Question 92: On the network shown in the figure, router A adopts link agg...
Question 93: Which of the following parameters is not contained in STP co...
Question 94: Which of the following commands can be used to permanently d...
Question 95: Which statement is true regarding the following command? ip ...
Question 96: The ARP protocol can resolve the MAC address of a destinatio...
Question 97: Which of the following statements is false about OSPF area p...
Question 98: On an STP-enabled switch, a port in the Learning state can t...
Question 99: You want to check the running configuration on a device by r...
Question 100: Which of the following is not included in the routing table?...
Question 101: For multiple paths to the same destination network, the rout...
Question 102: In STP, the bridge ID on the switching network is as follows...
Question 103: As shown in the figure, the host has ARP cache. Host A sends...
Question 104: In STP, which of the following items may affect the selectio...
Question 105: After an Eth-Trunk in LACP mode is created, devices on both ...
Question 106: It is advised to assign static IP addresses to servers durin...
Question 107: What protocol does OSPF run over?...
Question 108: The CAPWAP protocol defines the communication standard betwe...
Question 109: Which of the following is a link-state routing protocol?...
Question 110: On Huawei routers, which of the following is the default pre...
Question 111: The data link layer uses PPP encapsulation. The IP addresses...
Question 112: When both ends running PPP protocol detect that the physical...
Question 113: Which of the following IPv4 addresses can be directly used b...
Question 114: You can run the user-interface maximum-vty command to config...
Question 115: What is the TPID value defined by IEEE 802.1Q?...
Question 116: VLAN 4095 is reserved for system use and VLAN 1 cannot be de...
Question 117: What action does an access port take in the process of sendi...
Question 118: An administrator wishes to manage the router in the remote b...
Question 119: An ACL rule is as follows. Which of the following IP address...
Question 120: Refer to the following display vlan command output. Which of...
Question 121: Which type of OSPF packets are sent by neighbors to exchange...
Question 122: Which of the following mask lengths is recommended for devic...
Question 123: As shown in the figure, RTA uses NAT and has an address pool...
Question 124: Which of the following statements about wireless devices is ...
Question 125: (Which of the following methods can be used to assign servic...
Question 126: For STP, the Message Age in the configuration BPDUs sent by ...
Question 127: In RSTP, a backup port can replace a faulty root port....
Question 128: A network administrator wishes to implement VLAN 10 to isola...
Question 129: Which of the following statements is true about link aggrega...
Question 130: As shown in the figure, router A has successfully telneted t...
Question 131: More than two switches can be stacked into one logical devic...
Question 132: In RSTP, an edge port becomes a common STP port after receiv...
Question 133: Which of the following descriptions regarding the STP forwar...
Question 134: Which of the following information is displayed when an ente...
Question 135: By referring to the topology and the configurations of G0/0/...
Question 136: When an Ethernet frame is received by an interface on a Laye...
Question 137: Refer to the following configuration of GigabitEthernet0/0/1...
Question 138: A trunk interface and a hybrid interface process packets in ...
Question 139: Refer to the following configuration of an interface on a sw...
Question 140: The authentication, authorization, and accounting schemes an...
Question 141: In the case of Huawei routers, what is the " -i " parameter ...
Question 142: What function does Ctrl+Z have in the VRP system?...
Question 143: Which of the following route entries can be aggregated into ...
Question 144: When a router is powered on, the router reads the configurat...
Question 145: As shown in the figure, which of the following ports will be...
Question 146: When two switches are connected through link aggregation, wh...
Question 147: Which of the following OSPF packets can be sent to request t...
Question 148: If PPP authentication fails, which type of packet will be se...
Question 149: A company applies for a class C IP address for subnetting. I...
Question 150: What is the number range of an advanced ACL?...
Question 151: According to the one-armed routing configurations shown in t...
Question 152: In standard STP mode, which of the following ports on non-ro...
Question 153: Which of the following statements about the commands shown i...
Question 154: Which of the following elements are included in a routing ta...
Question 155: Which of the following statements is true about direct route...
Question 156: The priority of static routes cannot be manually specified....
Question 157: Which of the following IP addresses can be used by another h...
Question 158: Which of the following statements is false about static rout...
Question 159: Refer to the following configuration of a switch interface. ...
Question 160: Which type of IPv6 address is FE80::2E0:FCFF:FE6F:4F36?...
Question 161: When redundant links exist on a switching network, STP can b...
Question 162: Refer to the following configuration of an interface on a sw...
Question 163: If the broadcast address of a network is 172.16.1.255, which...
Question 164: Which of the following operations are mandatory to restore t...
Question 165: The tracert diagnostic tool of Huawei routers is used to tra...
Question 166: If the network administrator assigns the IPv4 address 192.16...
Question 167: Which of the following are the stable states of OSPF neighbo...
Question 168: Which of the following network parameters can be allocated u...
Question 169: Which of the following is NOT an open API of Huawei controll...
Question 170: The following figure shows the display interface Eth-Trunk 1...
Question 171: On the network shown in the following figure, assuming that ...
Question 172: Which one of the following can be configured on an AP to pro...
Question 173: According to OSI reference model, which layer is responsible...
Question 174: A Layer 2 ACL can match information such as the source MAC a...
Question 175: The LACP priority is shown in the figure. Switch A and Switc...
Question 176: Refer to the following configuration of an interface on a sw...
Question 177: The default bridge priority of a Huawei switch is 32768....
Question 178: When Fit APs go online on an AC, they will necessarily downl...