H12-811_V1.0 Exam Dumps | On Huawei equipment, if AAA authentication is used for authorization, when the remote server does not

<< Prev Question Next Question >>

Question 58/163

On Huawei equipment, if AAA authentication is used for authorization, when the remote server does not respond, authorization can be performed from the network equipment side ()

A. False

B. True

Question List (163q): Question 1: On Huawei devices, if you use aaA authentication to authoriz...; Question 2: What is the corresponding Solicited.-node multicast address ...; Question 3: The protocol uses the P/A. mechanism to speed up the upstrea...; Question 4: The network administrator hopes to be able to effectively us...; Question 5: Which of the following options describes the concept of the ...; Question 6: As shown in the figure, if the command ping 10.1.1.2 is exec...; Question 7: As shown in the figure. If host A has the ARp cache table of...; Question 8: You can manually specify the source address or source interf...; Question 9: The CAPWAP control tunnel and data tunnel transmission adopt...; Question 10: The switch becomes a logical switch after stacking and clust...; Question 11: What is wrong about the ARP message? ()...; Question 12: By default, the lease period for the DHCP server to assign a...; Question 13: The CAPWAP protocol specifies the communication standard bet...; Question 14: Which state does the OSPF protocol use to indicate that the ...; Question 15: In order to distinguish different users and provide differen...; Question 16: If the Ethernet data frame Length/Type=0x0806, which of the ...; Question 17: The configuration information of a certain port of the switc...; Question 18: There are hosts in a private network that need to access the...; Question 19: When the switch port sends a data frame that carries the sam...; Question 20: A company applies for a C. IP address segment, which needs t...; Question 21: Which of the following descriptions of wireless devices is c...; Question 22: The configuration of the country code will affect the actual...; Question 23: The network is shown in the figure below. The following stat...; Question 24: The output information of a certain device is shown in the f...; Question 25: Which of the following protocols does the RA message used in...; Question 26: Which of the following statements about IPv6 RA. and RS mess...; Question 27: The output information of the sub-interface of a certain rou...; Question 28: Which of the following parameters is used in LCP negotiation...; Question 29: The output information of a certain router is shown in the f...; Question 30: In order to implement FIT AP online, FIT AP first needs to o...; Question 31: In order for the STA to obtain the SSID related information ...; Question 32: When using FTP for file transfer, how many TCP connections w...; Question 33: Which layers are not included in the TCP/IP model?...; Question 34: Which of the following statements about the various versions...; Question 35: In order to distinguish between different users and provide ...; Question 36: What are the advantages of the OSPF protocol? ()*...; Question 37: When the Access type port sends a message, it will ()....; Question 38: If the Length/Type of an Ethernet data frame is 0x8100. Whic...; Question 39: In the switching network shown in the figure below, all swit...; Question 40: Which of the following methods can read data non-blocking in...; Question 41: Network as shown in the picture. The administrator hopes tha...; Question 42: The AC can manually specify the source address or source int...; Question 43: Which of the following port states does not include the RSTP...; Question 44: When two switches are interconnected using link aggregation ...; Question 45: What are the characteristics of VLAN based on ports?...; Question 46: In what state does the OSPF protocol determine the master-sl...; Question 47: The output information of a certain device is shown in the f...; Question 48: Which of the following IEE802.11 standards support operation...; Question 49: The MAC address table of existing switches is shown in the f...; Question 50: The IPv6 address 2001: ABEF:2240E:FFE2:BCC0:CD0:DDBE:8D58 ca...; Question 51: When an Access type port sends a message, it will ()*...; Question 52: An AR2200 router needs to restore the initial configuration,...; Question 53: 1/128 is the IPv6 loopback address ()...; Question 54: Which of the following statements about IPv6 address configu...; Question 55: Which of the following types of addresses are not included i...; Question 56: By default, what is the forward delay time of the STP protoc...; Question 57: AC. Use CAPWAP control tunnel to transmit management message...; Question 58: On Huawei equipment, if AAA authentication is used for autho...; Question 59: Trunk ports can allow multiple VLANs to pass, including VLAN...; Question 60: If the administrator wants to update the VRP version of Huaw...; Question 61: How many bytes is the length of the basic IPV6 header?...; Question 62: The transport layer protocol has UDP and TCP, but UDP is mor...; Question 63: When the switch port receives a data frame that does not car...; Question 64: The router forwards data according to the IP routing table, ...; Question 65: As shown in the figure below, assuming that the other config...; Question 66: The router needs to modify the destination IP address in the...; Question 67: Which stage in the life cycle of campus network construction...; Question 68: The output information of a router is shown in the figure. W...; Question 69: Which of the following packet types is used by RADIUS to ind...; Question 70: According to the command output as shown in the figure, whic...; Question 71: As shown in the figure, the network administrator creates VL...; Question 72: Which parameter is used in the spanning tree protocol for ro...; Question 73: What are the ACL classifications*...; Question 74: A network administrator of a company wants to be able to rem...; Question 75: VLAN4095 cannot be created on Huawei switches, and VLAN1 can...; Question 76: Use the command kdir test in the VRP operating platform. The...; Question 77: When the host frequently moves the office, which VLAN divisi...; Question 78: Which of the following IPv6 is a global unicast address ()...; Question 79: The network administrator configures the RTA on the Huawei r...; Question 80: As shown in the figure below. Which port of the following sw...; Question 81: What is correct about the SNMP protocol?...; Question 82: NFV (Network Functional Virtualization), network function vi...; Question 83: UDP is connectionless and must rely on () to ensure the reli...; Question 84: Which of the following statements about static routing is wr...; Question 85: The election of the root switch in STP only compares the pri...; Question 86: On the switch, which VLANs can be deleted by using the undo ...; Question 87: If the Ethernet data frame Length/Type=0X0806, which stateme...; Question 88: The output information of a certain router is shown in the f...; Question 89: What is the total length of the VLAN frame format defined by...; Question 90: As shown in the figure, after the two routers are configured...; Question 91: The switch is connected to the host. What is the common port...; Question 92: Which of the following statements are correct for the MAC ad...; Question 93: VRP does not support how to configure the router?...; Question 94: The data link layer adopts PPP encapsulation, and the IP add...; Question 95: Which of the following advantages does the single-arm routin...; Question 96: An ACL is essentially a packet filter. Only when the ACL is ...; Question 97: Which of the configurations in the following options belong ...; Question 98: The link aggregation interface can only be used as a Layer 2...; Question 99: When using the FTP protocol to upgrade the router software, ...; Question 100: Management Information Base (MIB) Information Base) is a vir...; Question 101: When OSPF protocol establishes adjacency, which of the follo...; Question 102: To ensure that the same data stream is forwarded on the same...; Question 103: As shown in the figure below, which port of the following sw...; Question 104: When the device running STP receives the RSTP configuration ...; Question 105: In the network shown in the figure, the administrator wants ...; Question 106: The output information of the router R1 routing table is sho...; Question 107: On Huawei ARG3 series routers, what authentication modes doe...; Question 108: Which information of the data frame is used by the VLANIF in...; Question 109: When Huawei switches allow STP, the priority of the switch b...; Question 110: In the network shown in the figure below, Router A uses manu...; Question 111: What are the advantages of using dynamic host configuration ...; Question 112: As shown in the figure below. All hosts can communicate norm...; Question 113: What are the three sources for routers to obtain routing ent...; Question 114: If host A. has the ARP cache of host B., host A. can ping ho...; Question 115: The following two configuration commands can realize the mas...; Question 116: The MAC address table of a certain switch is shown in the fi...; Question 117: What is wrong about the following description of the router?...; Question 118: When accessing across network segments, the source and desti...; Question 119: In the network shown in the figure below, there are the foll...; Question 120: The Layer 2 Ethernet switch generates entries in the MAC add...; Question 121: PAP authentication is more secure than CHAP authentication b...; Question 122: Which bridge ID is unlikely to appear in the configuration B...; Question 123: As shown in the figure below, assuming that the MAC address ...; Question 124: In order to detect the connectivity status of the CAPWAP tun...; Question 125: Which information of the data frame is used by the VLANIF in...; Question 126: There is a WeB server in the private network that needs to p...; Question 127: Which of the following parameters is used in LCP negotiation...; Question 128: Complete the ACL configuration shown in the figure on the ro...; Question 129: Which of the following statements about Adjacency Segment is...; Question 130: Apply the ACL configured as shown in the figure in Telnet. W...; Question 131: The output information of a certain router is shown in the f...; Question 132: What is the length of the Ethernet II frame containing the E...; Question 133: The network is shown in the figure below. Switch configurati...; Question 134: The following statement about Python is incorrect ()...; Question 135: Which of the following fields are present in both IPv6 and I...; Question 136: Which of the following subnet routes might be the route entr...; Question 137: The output information of the router R1 routing table is sho...; Question 138: The figure shows the display startup information of the R220...; Question 139: By default, what is the lease period for the DHCP server to ...; Question 140: When the LCP phase of PPP is negotiated, the content of the ...; Question 141: By default, network devices running the SNMPv2C. protocol us...; Question 142: The output information of the sub-interface of a router aggr...; Question 143: What is the port number used by the FTP protocol control pla...; Question 144: The static MAC. address table will not be lost after the sys...; Question 145: The router receives a data packet with a destination IP addr...; Question 146: The two switches shown in the figure below have both enabled...; Question 147: What is the function of the command port trunk allow pass vl...; Question 148: The router Radius information configuration is shown in the ...; Question 149: The mask length is 12 bits can be expressed as?...; Question 150: What is the total length of port ID in Spanning Tree Protoco...; Question 151: In the network shown in the figure below, the router receive...; Question 152: Which of the following messages does the AP use to request t...; Question 153: Which of the following IEEE802.11 standards only supports th...; Question 154: Network equipment running the SNMP protocol can take the ini...; Question 155: At what layer of the OSI reference model does a router opera...; Question 156: As shown in the figure below, what kind of network equipment...; Question 157: ForwardD.Delay exists when an STP port transitions between w...; Question 158: Layer 2 ACL can match source MAC, destination MAC, source IP...; Question 159: Which of the following statements about RA and RS messages i...; Question 160: When the router forwards a data packet, if it does not match...; Question 161: 192.168.1.127/25 represents () address ()...; Question 162: In what ways does VRP support router configuration? ()*...; Question 163: In the wLAN network architecture, terminal devices that supp...

Question 58/163

LEAVE A REPLY

Download PDF File