<< Prev Question Next Question >>

Question 8/105

A company applies for a Class C address segment, which needs to be evenly distributed to 8 subsidiaries. The largest subsidiary has 14 computers. Different subsidiaries must be in different network segments. The subnet mask should be designed as ().

Recent Comments (The most recent comments are at the top.)

Abas - Dec 09, 2021

Nice dumps

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (105q)
Question 1: The load sharing mode at both ends of the Eth-Trunk can be i...
Question 2: Which of the following attributes cannot be used as a parame...
Question 3: A company has 50 private IP addresses. The administrator use...
Question 4: Which of the following statements about direct routing is co...
Question 5: In the network shown in the figure below, the bridge ID of t...
Question 6: Using the ACL shown in the figure on the router RTA to match...
Question 7: Which of the following statements about the default route ar...
1 commentQuestion 8: A company applies for a Class C address segment, which needs...
Question 9: What is the number range of the Layer 2 ACL?...
Question 10: As shown in the information in the figure, when learning thi...
Question 11: How many types of data flows with different service levels c...
Question 12: What is the destination IP address of the DHCP DISCOER messa...
Question 13: The management of users by NAS devices is based on domains. ...
Question 14: The following rules exist in a certain ACL of the router. ru...
Question 15: Which of the following does not be included in AAA?...
Question 16: The output information of a switch is shown in the figure. W...
Question 17: What is the total length of the VLAN frame format defined by...
Question 18: Which stage of the life cycle of campus network construction...
Question 19: In the switch MAC address table, which of the following entr...
Question 20: Which of the following statements about the S field in the M...
Question 21: SNMPv1 defines 5 protocol operations....
Question 22: The switch GO/0/1 port configuration information is shown in...
Question 23: Through SR (Segment Routing), an explicit path can be easily...
Question 24: What is the main function of the DNS protocol?...
Question 25: Which of the following are not open interfaces of Huawei net...
Question 26: The administrator has configured the router as shown in the ...
1 commentQuestion 27: The network administrator created VLAN 10 on the Layer 3 swi...
Question 28: VRP operating system commands are divided into 4 levels: acc...
Question 29: What is the total length of the IPv6 address in bits?...
Question 30: How many types of OSPF messages are there?...
Question 31: As shown in the figure below, all hosts can pass normally, s...
Question 32: On the VRP platform, the default protocol priority of routes...
Question 33: Which statement about SNMP protocol is correct?...
Question 34: In the VRP interface, use the command startup saved-configur...
Question 35: What percentage does the DHCP client expect to send the leas...
Question 36: On the broadcast network, both DR and BDR use the multicast ...
Question 37: In which working state of the STP protocol can the port be c...
Question 38: In the network as shown in the figure below, the host has an...
Question 39: Which of the following description of static and dynamic rou...
Question 40: Which of the following IPv6 is a global unicast address?...
Question 41: Complete the ACL configuration shown in the figure on the ro...
Question 42: Which of the following statements about router-on-a-stick ar...
Question 43: The DHCPv6 server supports providing other configuration inf...
Question 44: If the Proto of a certain route information in the routing t...
Question 45: The following two configuration commands can realize the rou...
Question 46: When the host frequently moves, which VLAN division method i...
Question 47: In the network shown in the figure below, the router receive...
Question 48: As shown in the following figure, router A and router B esta...
Question 49: Which of the following networks belong to a local area netwo...
Question 50: In the network shown in the figure below, the output informa...
Question 51: f a windows host is started for the first time, if the IP ad...
Question 52: If the broadcast address of a network is 172.16.1.255, what ...
Question 53: The Backup ports in RSTP may alternatively failed root port....
Question 54: Link aggregation is a common technology in enterprise networ...
Question 55: Which of the following authentication methods does not requi...
Question 56: What is the full name of the general routing platform VRP?...
Question 57: AC uses CAPWAP control tunnel to transmit management message...
Question 58: In the VRP interface, use the command delete vrpcfg.zip to d...
Question 59: Which of the following commands can be used to view the rout...
Question 60: What is the IEEE802.11 standard corresponding to Wi-F16?...
Question 61: Using the command mkdir test in the VRP operating platform, ...
Question 62: The switch becomes a logical switch after stacking and clust...
Question 63: The output information of the router R1 routing table is sho...
Question 64: The election of the root switch in STP only compares the swi...
Question 65: What are the advantages of using dynamic host configuration ...
Question 66: Which version of the SNMP protocol below supports encryption...
Question 67: Which of the following elements are included in the routing ...
Question 68: By default, in the SNMP protocol, which port number does the...
Question 69: Network shown below, Host A does not configure the gateway, ...
Question 70: The administrator wants all hosts to be unable to access the...
Question 71: The network shown below, it is desirable host traffic networ...
Question 72: The administrator plans to implement route backup by configu...
Question 73: Which of the following characteristics does the OSPF protoco...
Question 74: In the network shown in the figure below, the host has an AR...
Question 75: What is the range of VLAN ID that users can use?...
Question 76: There are hosts in a private network that need to access the...
Question 77: Which statement about the Hybrid port is correct?...
1 commentQuestion 78: The last option field of IPv4 is variable-length optional in...
Question 79: Which statement are correct about the shortcut keys of the V...
Question 80: Broadly speaking, which of the following does the transmissi...
Question 81: Which of the following descriptions about Trunk port and Acc...
Question 82: In IPv4 networks, AP supports static and DHCP methods to obt...
Question 83: Which of the following does not include in VRP system login ...
Question 84: Refer to the route-in-a-stick configuration in the figure be...
Question 85: In order to realize the network layer function on VLANIF int...
Question 86: When the router forwards a data packet, if it does not match...
Question 87: The configuration information of a certain port of the switc...
Question 88: Which of the following descriptions about the switch is wron...
Question 89: In order to distinguish different users and provide differen...
Question 90: What kind of message does the OSPF protocol use to send LSA ...
Question 91: Which of the following options are configured in a Layer 2 A...
Question 92: In the network shown in the figure below, switch A and route...
Question 93: The configuration information of a certain port of the switc...
Question 94: Which of the following information prompts will the VRP oper...
Question 95: The RSTP protocol uses the P/A mechanism to speed up the spe...
Question 96: Which of the following port states does the RSTP protocol in...
Question 97: All ports on the root bridge switch are designated ports....
Question 98: A certain ACL of the router is in the following rules, rule ...
Question 99: How many more bytes are the packets using MPLS label double-...
Question 100: The following statements about the election of active ports ...
Question 101: RADIUS is a common protocol to implement AAA....
1 commentQuestion 102: How to add AP on AC? (Multiple Choice)...
Question 103: Which of the following IPv4 addresses can be used by a host ...
Question 104: The link aggregation interface can only be used as a Layer 2...
Question 105: The information shown in the figure is the port status infor...