<< Prev Question Next Question >>

Question 12/77

The default interval for sending VGMP hello packets is 1 second. That is, when the hello packet sent by the peer is not received within the range of three hello packets, the peer is considered to be faulty. Master status.

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (77q)
Question 1: The topology diagram of the BFD-bound static route is as fol...
Question 2: Virtual firewall technology can achieve overlapping IP addre...
Question 3: A user wants to limit the maximum bandwidth of the 192.168.1...
Question 4: Connecting the internal network interface address from the f...
Question 5: As shown in the figure, the firewall is dual-system hot stan...
Question 6: In the first phase of IKE V1, the pre-shared key master mode...
Question 7: What are the three elements of an abnormal flow cleaning sol...
Question 8: As shown below, the domain abc address pool is the address p...
Question 9: The following scan snoop attacks are:...
Question 10: In the application scenario of IPSec traversal by NAT, the a...
Question 11: Which of the following statements about the blacklist is cor...
Question 12: The default interval for sending VGMP hello packets is 1 sec...
Question 13: About load balancing, the following configuration is availab...
Question 14: 112. The ESP only verifies the IP payload and can perform NA...
Question 15: What are the drainage schemes that can be used in the scenar...
Question 16: In the active/standby mode of the USG dual-system hot backup...
Question 17: Which of the following statements is true about L2TP over IP...
Question 18: In a dual-system hot standby network, the NAT configurations...
Question 19: What is the correct statement about the Eth-trunk function?...
Question 20: Virtual firewall virtualizes multiple logical firewalls on a...
Question 21: The management control information and service information o...
Question 22: The ip-link sends a probe packet to the specified IP address...
Question 23: What are the following VPN protocols that do not provide enc...
Question 24: The hot standby and IPSec functions are combined. Which of t...
Question 25: The branch firewall of an enterprise is configured with NAT....
Question 26: The firewall device defends against the SYN Flood attack by ...
Question 27: What are the following attacks that are special message atta...
Question 28: To ensure the normal forwarding of large traffic, a network ...
Question 29: Both AH and ESP protocols of IPSec support NAT traversal...
Question 30: 87. The SSL VPN scenario under dual-system hot standby is sh...
Question 31: The figure shows the data flow direction of the Bypass inter...
Question 32: What is the correct description of IKE?...
Question 33: Which of the following is the correct description of the SMU...
Question 34: Accessing the headquarters server through the IPSec VPN from...
Question 35: What are the following attacks that are malformed?...
Question 36: USG A and USG B are configured with a static BFD session. Th...
Question 37: The SSL VPN authentication login is unsuccessful and the mes...
Question 38: The interaction process of the firewall linkage NIP intrusio...
Question 39: The dual-system hot standby networking environment is as sho...
Question 40: Two USG firewalls establish an IPSec VPN through the Site to...
Question 41: In IPSec VPN, which one is incorrect about the difference be...
Question 42: After the link-group is configured on the device, use the di...
Question 43: Avoid DHCP server spoofing attacks. DHCP snooping is usually...
Question 44: Based on the following information analysis on the firewall,...
Question 45: The constraints of the policy in the traffic limiting policy...
Question 46: In the application scenario of the virtual firewall technolo...
Question 47: SSL VPN authentication is successful. Using the file sharing...
Question 48: When the ip-link link health check is performed, if it is un...
Question 49: The first packet discarding technology of Huawei Anti-DDoS d...
Question 50: The server health check mechanism is enabled on the USG fire...
Question 51: What are the correct statements about the IP address scannin...
Question 52: Which of the following encryption methods does IPSec VPN use...
Question 53: Which of the following attacks is a SYN Flood attack?...
Question 54: The following figure shows the L2TP over IPSec application s...
Question 55: When an IPSec VPN is set up on both ends of the firewall, th...
Question 56: The SSL VPN authentication is successful, but the Web-link r...
Question 57: The enterprise network is as shown in the figure. On the USG...
Question 58: In the dual-system hot backup, when the slave does not recei...
Question 59: 134. Which of the following is the connection status data to...
Question 60: In the IPSec VPN, the digital certificate is used for identi...
Question 61: In the case of IPSec VPN NAT traversal, you must use IKE's a...
Question 62: In dual-system hot backup, the backup channel must be the pr...
Question 63: Two USG firewalls failed to establish an IPSec VPN tunnel th...
Question 64: Regarding the virtual gateway type exclusive and shared type...
Question 65: The principle of HTTPS Flood source authentication defense i...
Question 66: Load balancing implements the function of distributing user ...
Question 67: Which of the following statements is true for virtual servic...
Question 68: The following figure shows the data packet of the pre-shared...
Question 69: SSL works at the application layer and encrypts specific app...
Question 70: An administrator can view the IPSec status information and d...
Question 71: On the USG, you need to delete sslconfig.cfg in the hda1:/ d...
Question 72: The malformed packet attack technology uses some legitimate ...
Question 73: In the IDC room, a USG firewall can be used to divide into s...
Question 74: After the NAT server is configured (no-reverse parameter is ...
Question 75: A data flow has established a session in the firewall. If th...
Question 76: When an attack occurs, the result of packet capture on the a...
Question 77: What are the correct descriptions of IPSec and IKE below?...