<< Prev Question Next Question >>

Question 16/148

In an MPLS VPN network, different CE devices can use different routing protocols to exchange routing information with the same PE device, and the routing protocols used between different CE devices and the same PE device are independent of each other.

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (148q)
Question 1: Which of the following statements about HTTPS is false?...
Question 2: Assuming that the shaping rate of a port is 100Mbps, the inp...
Question 3: Protocols using TCP ports 443, 179, 137, 110 and 23 are...
Question 4: Which of the following descriptions about VRRP load sharing ...
Question 5: What is the most efficient way to pass view device alarms vi...
Question 6: The two routers are connected together through serial ports,...
Question 7: Which of the following descriptions about the LDP session es...
Question 8: The following about MED The correct one is: (multiple choice...
Question 9: Which of the following statements about MPLS is incorrect?...
Question 10: Which of the following scenarios is not suitable for deployi...
Question 11: Which of the following statements about OSPF route filtering...
Question 12: Regarding the difference between NSR and NSF, which is corre...
Question 13: The topology diagram and configuration are as follows. Now I...
Question 14: When the administrator configures VRRP, which of the followi...
Question 15: Bandwidth parameters need to be configured when deploying LL...
Question 16: In an MPLS VPN network, different CE devices can use differe...
Question 17: Which of the following is incorrect about BGP routing? (Sing...
Question 18: A routerRouter LSA As shown in the picture, which of the fol...
Question 19: Assuming that the neighbor relationship between BGP routers ...
Question 20: If PIM-SM is run in a multicast network, a multicast forward...
Question 21: There are many ways to establish a cluster on a modular swit...
Question 22: Which of the following descriptions about the properties of ...
Question 23: The following is about IGMPv1 and IGMPv2description, which i...
Question 24: Which type of address prefix in the following options indica...
Question 25: at the VLAN (802.1Q) The priority field in the data encapsul...
Question 26: If the interface sticky MAC function is enabled, what is the...
Question 27: About IGMP Proxy is correct? (multiple choice)...
Question 28: The following is about the PIM-SMRegister message descriptio...
Question 29: OSPF is enabled on the router HW, the role of the router HW ...
Question 30: An engineer performed the import operation on an OSPF router...
Question 31: There is no routing protocol running on the router HW and on...
Question 32: Which of the following statements about BGP route reflectors...
Question 33: As shown in the figure, there are two IPv6 networks that can...
Question 34: Which of the following statements about NSSA areas is true...
Question 35: Through the display ip interface GEO/0/0 command, the statis...
Question 36: If there is no default route in the local IP routing table, ...
Question 37: In Huawei equipment, when ISIS imports external routes and s...
Question 38: uninterrupted forwardingNSF (Non-Stopping Forwarding) and no...
Question 39: Regarding the authentication of the ISIS protocol, the corre...
Question 40: an engineer uses 2 router for IPv46 business test, by runnin...
Question 41: Which of the following descriptions about BGP load sharing i...
Question 42: Which of the following BGP attributes is not a BGP routeUp d...
Question 43: As shown in the picture below, the correct description is: (...
Question 44: IBGP was established on two Between directly connected devic...
Question 45: In a multicast network, what causes the multicast traffic to...
Question 46: The host HW1 in the HW device network wants to join a video ...
Question 47: The following about OSPFv3Router-LSA, which statement is cor...
Question 48: Which of the following tools cannot beRoute if in policy-mat...
Question 49: As shown in the following topology, EBGP is run between AS10...
Question 50: A campus has deployed IPv6 for business testing. In the earl...
Question 51: The existing router HW1 running BGP is configured with both ...
Question 52: A company's two-layer phase network signature is shown in th...
Question 53: In order to configure AAA, we first need to defineRADIUS ser...
Question 54: How many interfaces of the router have IS-IS enabled, the ou...
Question 55: Use the IP prefix list as shown for route matching, which of...
Question 56: In IS-IS Configure ipv in protocol view6 preference, the fun...
Question 57: Which of the following options may affect the establishment ...
Question 58: command ip ip-prefix ip-prefix-name [index index-number] { p...
Question 59: Subnets under different VPNs of VXLAN need to be accessed in...
Question 60: The advanced access control list is a series of ordered rule...
Question 61: If a Huawei switch runs the RSTP protocol, when will the BPD...
Question 62: When configuring AS-Path-Filter, ipas-path-filter10 permit _...
Question 63: If the PIM-SM protocol is run in the multicast network, RP n...
Question 64: (Exhibit)
Question 65: What are the advantages of OSPF division area?...
Question 66: As shown below, R1 and R2 establish EBGP neighbors and enabl...
Question 67: The intranet users of a company use the no-pat mode of NAT t...
Question 68: As shown in the figure, private network routing information ...
Question 69: Check the LSP on a router and see the following results: (Ex...
Question 70: an existing AS-path-filter: ip as-path-filter 1 permit 100( ...
Question 71: Which of the following packets does the BGP protocol support...
Question 72: Which properties meet the following two conditions: BGP rout...
Question 73: ICMPv6 has two types of error message (Error Messages) and i...
Question 74: The association between LDP and IGP means that IGP suppresse...
Question 75: A router runs IS-IS, and its output information is shown in ...
Question 76: four routersR1, R2, R3 and R4 run ISIS, The ISIS router type...
Question 77: Which of the following information can be included in a basi...
Question 78: four routers running IS-IS And the adjacency relationship ha...
Question 79: OSI Reference Model and which layers in the TCP/IP model are...
Question 80: RD is used to distinguish the same IP address in different V...
Question 81: OSPFAmong the five types of LSAs are used to transmit extern...
Question 82: Different from STP, RSTP BPDU typeonly one, its value 2, noT...
Question 83: Regarding route introduction, which of the following descrip...
Question 84: BGP EVPN Type2 Routing is used to pass IRB In the case of ty...
Question 85: BGP routing policy can control the publishing and receiving ...
Question 86: Which of the following routes is used to advertise external ...
Question 87: What is wrong with the description of MAC address spoofing a...
Question 88: As shown in the figure, OSPF is enabled on all interfaces of...
Question 89: As shown, all routers are at 0SPThe loopback interface addre...
Question 90: Four routers run IS-IS and have established adjacency relati...
Question 91: As shown in the following topology diagram, all interfaces o...
Question 92: The security protection actions that can be performed by a s...
Question 93: BGP4+ is running between the two routers, and the neighbor r...
Question 94: HW users are transferring a very large number of files via T...
Question 95: an existing switch is running RSTPprotocol. If the network t...
Question 96: When DLDP detects the existence of a unidirectional link in ...
Question 97: Which of the following descriptions about ISIS' route penetr...
Question 98: Which of the following IEE standards were developed for Giga...
Question 99: Configured under an interface: isis timer hello 5 level-2, i...
Question 100: In order to reduce the number of OSPF routes in some stub ar...
Question 101: In the process of using the LACP protocol, which of the foll...
Question 102: Regarding BGP4+, which of the following statements is correc...
Question 103: When the BFD detection time intervals at both ends are 30ms ...
Question 104: [R1]ospf 1 [R1-ospf-1]area 2 [R1-ospf-1-area-0.0.0 2] networ...
Question 105: command ip as path-filterr 1 permit ^12.*74$ can match which...
Question 106: Look at the picture and talk? (Exhibit)...
Question 107: The following description of Link ID, Data, Type and Metirc ...
Question 108: As shown in the following figure, part of the LSPs in the LS...
Question 109: In IS-ISFilter-policy 2000 export is configured in the proce...
Question 110: the following aboutWhat are the wrong technical claims about...
Question 111: Community-filter has two types of basic community attribute ...
Question 112: Which of the following does not belong to the role of EVPN T...
Question 113: The HW device network administrator plans to migrate the mul...
Question 114: Network managers can use CAR technology in traffic supervisi...
Question 115: The router connects two EBGP neighbors through two parallel ...
Question 116: If the router's GigabitEthermet0/0/0 interface sends out 0SP...
Question 117: Since BGP is an EGP routing protocol, BGP routing policies c...
Question 118: the following aboutThe establishment process of LDP LSP, whi...
Question 119: Which description is correct about BGP reflector?...
Question 120: Which of the following descriptions about ISIS' LSP fragment...
Question 121: by default, which of the following are safeMAC Will the entr...
Question 122: routerR1 runs OSPF protocol, use "display ip "routing-table"...
Question 123: The following are for the source side in PIM-SMWhich of the ...
Question 124: Router HW1 asMPLS LSR routers exist in the network of the op...
Question 125: When the administrator wants to manage some routes on the ro...
Question 126: The router HW1 and the router HW2 are connected to the netwo...
Question 127: Which of the following descriptions about OSPF virtual links...
Question 128: In the laboratory network, build a network according to the ...
Question 129: Which of the following information about BGP4+ is correct?...
Question 130: As shown in the figure, department A of branch 1 can access ...
Question 131: There are routing tools that are not only used for BGP routi...
Question 132: IPv6 Link-local addresses can be generated by stateless auto...
Question 133: IPSG can statically configure the binding table, orDHCP-Snoo...
Question 134: After dividing an interface of the firewall into the Untrust...
Question 135: About PIM-Description of He1lo message in SM, what is wrong?...
Question 136: In order to enable the VPN instance to advertise IP routes t...
Question 137: As shown, in IPv44 and IPv6 environment, ISISThe SEL field i...
Question 138: Through the following display command, you can judge which i...
Question 139: about the followingWhich RADIUS statement is true?...
Question 140: VLAN L3 Gateway is used to implement different V?The three-l...
Question 141: As shown in the figure, which of the following statements is...
Question 142: After a switch is powered on, it joins a running stack syste...
Question 143: What is the role of RT in MPLS VPN?...
Question 144: When the payload is an ICMPY6 packet, if the extension heade...
Question 145: Which of the following statements about the VRRP protocol is...
Question 146: inUSG Series firewalls, Untrust. What is the security level ...
Question 147: You want to set the DSCP value for VoIP traffic in the HW ne...
Question 148: Regarding the stub area in the OSPF protocol, the following ...