GB0-371-ENU Exam Dumps | After executing the display interface Ethernet 1/0/2 command on the switch SWA, the output information

Home
H3C
Constructing H3C High-Performance Campus Networks
H3C.GB0-371-ENU.v2021-12-16.q117
Question 87

Valid GB0-371-ENU Dumps shared by EduDump.com for Helping Passing GB0-371-ENU Exam! EduDump.com now offer the newest GB0-371-ENU exam dumps, the EduDump.com GB0-371-ENU exam questions have been updated and answers have been corrected get the newest EduDump.com GB0-371-ENU dumps with Test Engine here:

Access GB0-371-ENU Dumps Premium Version
(337 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 87/117

After executing the display interface Ethernet 1/0/2 command on the switch SWA, the output information is as follows:
[SWA]display interface Ethernet 1/0/2
Ethernet1/0/2 current state: UP
PVID: 10
Mdi type: auto
Link delay is 0(sec)
Port link-type: trunk
VLAN passing: 1 (default vlan), 10
VLAN permitted: 1 (default vlan), 2-4094
Trunk port encapsulation: IEEE 802.1q
Port priority: 0
It can be judged from the above output

A. Port Ethernet1/0/2 only allows data from VLAN 1 and VLAN 10 to pass through

B. Data frames with VLAN20 tags will be discarded when they enter port Ethernet1/0/2

C. The only VLANs existing on the switch are VLAN1 and VLAN10

D. Data frames with VLAN1 tags will not be stripped off when they leave port Ethernet1/0/2

Correct Answer: B,C,D

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (117q): 1 commentQuestion 1: For the following configuration commands: [H3C] ntp-service ...; Question 2: The topology is shown in the figure, and the STP calculation...; Question 3: As shown in the networking, SWB and SWC enable STP, SWC is t...; Question 4: Regarding the basic concepts of MSTP, the correct statement ...; Question 5: When the host receives the GeneralQuery message sent by the ...; Question 6: In the network as shown in the figure, the corresponding con...; Question 7: In the network as shown in the figure, the switch SWA is a L...; Question 8: Among the following PIMV2 messages, the destination address ...; Question 9: The figure shows the application of SmartLink and RRPP hybri...; Question 10: What is the correct statement about the MSTP calculation pro...; Question 11: The two routers are connected through the LAN to form a VRRP...; Question 12: In the PIM-DM networking, about the router sending Prune (pr...; Question 13: After executing the display interface Ethernet 1/0/1 command...; Question 14: The customer LAN switches SWA, SWB, SWC, and SWD form an RRP...; Question 15: Regarding the MSTP calculation process, the correct statemen...; Question 16: Regarding the comparison of unicast, multicast and broadcast...; Question 17: As the basis for the realization of the SNMP protocol, the m...; Question 18: In the networking model shown in the figure, after the confi...; Question 19: The host PCA, PCB and PCC are respectively connected to the ...; Question 20: The topology is shown in the figure, and the STP calculation...; Question 21: After executing the displayinterface Ethernet 1/0/1 command ...; Question 22: The following statements about multicast routing protocols a...; Question 23: In the networking model shown in the figure, if Accoing is r...; Question 24: Regarding the comparison of the calculation convergence of R...; Question 25: As the network management director of a certain company, Mr....; Question 26: The IP address of the host PCA is 40.1.1.1 and the MAC addre...; Question 27: The two routers are connected through a LAN to form a VRRP b...; Question 28: Before configuring Layer 3 multicast, the first configuratio...; Question 29: Regarding the role and status of the STP port, the following...; Question 30: Regarding the port status and role in RSTP, what are the cor...; Question 31: The customer purchased a router. If the performance index of...; Question 32: Regarding priority mapping and priority trust, there are cor...; Question 33: In the networking shown in the figure, the PIM SM protocol r...; Question 34: In a large local area network, what are the functional layer...; Question 35: The SSH protocol is widely used as a secure remote login pro...; Question 36: The Ethemet1/0/1 port configuration of the switch SWA is as ...; Question 37: Which statement is correct about the communication between s...; Question 38: In the switching network as shown in the figure, VLAN 10 is ...; Question 39: The customer LAN switches SWA, SWB, and SWC form the RRPP ri...; Question 40: The customer LAN switches SWA, SWB, and SWC form the RRPP ri...; Question 41: The customer's six switches SWA, SWB, SWC, SWD, SWE, and SWF...; Question 42: The following statements about the STP protocol are correct...; Question 43: Regarding the relationship between RSTP and STP, the correct...; Question 44: Which statement about the STP protocol is correct?...; Question 45: As shown in the network, the switches all run RSTP. Initiall...; Question 46: In the switching network shown in the figure, VLAN10 is set ...; Question 47: Regarding the generation of TCN BPDUs, which of the followin...; Question 48: In the network as shown in the figure, after completing the ...; Question 49: Mid-to-high-end switch equipment has its own redundancy. If ...; Question 50: As shown in the diagram, SWA, SWB and SWC enable STP. If the...; Question 51: Among the SNMPv1 messages, the messages sent by the Agent to...; Question 52: In the switching network as shown in the figure, VLAN10 is s...; Question 53: The following statements about BSR and RP in PIMSM are corre...; Question 54: Regarding the three versions of the multicast group manageme...; Question 55: In the switching network as shown in the figure, all three s...; Question 56: Regarding the three versions of the multicast group manageme...; Question 57: As shown in the figure, there are two group member hosts Cli...; Question 58: As shown in the networking, initially Link 2 is not connecte...; Question 59: The customer LAN switches SWA, SWB, and SWC form the RRPP ri...; Question 60: In the switching network as shown in the figure, all three s...; Question 61: In the network as shown in the figure, the interconnection l...; Question 62: In the network connection as shown in the figure, SWA and SW...; Question 63: The three routers RTA, RTB, and RTC are connected together v...; Question 64: As shown in the networking, SWA and SWC enable STP, SWC is t...; Question 65: Regarding the configuration of the timer in the spanning tre...; Question 66: In order to achieve efficient network management, what serve...; Question 67: Which of the following descriptions about the IP address of ...; Question 68: In the switching network as shown in the figure, all three s...; Question 69: The figure shows the stable topology after STP calculation a...; Question 70: If customers prefer to use TACACS+ protocol instead of RADUS...; Question 71: Regarding the comparison between MSTP and RSTP, the correct ...; Question 72: The security of the campus network should consider which of ...; Question 73: Which of the following methods of dividing VLANs has the adv...; Question 74: SNMP vc2 relative to the improvement of SNMPV1 protocol incl...; Question 75: As shown in the figure, each switch enables RSTP. Assuming t...; Question 76: Regarding BPDU protection, the following statements are corr...; Question 77: Which of the following descriptions about H3C switch static ...; Question 78: Regarding the designation of the MSTP root bridge, the corre...; Question 79: SOA-based network architecture divides the enterprise IT sys...; Question 80: To query the CPU utilization of a certain device through SNM...; Question 81: Regarding the stpmcheck command in the spanning tree configu...; Question 82: The customer's two switches SWA and SWB are connected by sev...; Question 83: Which of the following addresses is not an IPv4 multicast ad...; Question 84: What kind of request operation does SNMP v2c add to the SNMP...; Question 85: The following are functions of the convergence layer (choose...; Question 86: Which statement is correct about the communication between s...; Question 87: After executing the display interface Ethernet 1/0/2 command...; Question 88: In the switching network as shown in the figure, VLAN10 is s...; Question 89: As shown in the picture, SWA, SWB and SWC enable STP, and th...; Question 90: Regarding the relationship between SuperVLAN and Sub VLAN, t...; Question 91: Which of the following addresses is not an IPv4 multicast ad...; Question 92: Regarding the configuration BPDU and TCM BPDU, the statement...; Question 93: In the PIM-DM network, the diffusion process of multicast pa...; Question 94: In the switching network as shown in the figure, VLAN 10 is ...; Question 95: Regarding the spanning tree port overhead configuration of H...; Question 96: As shown in the networking, the switch enables RSTP, and the...; Question 97: As shown in the network topology, if STP is enabled on SWA a...; Question 98: The figure shows the networking application of RRPP. The cus...; Question 99: Regarding the comparison of the calculation convergence of R...; Question 100: After executing the display interface Ethernet 1/0/1 command...; Question 101: Which of the following methods does RADIUS use to ensure the...; Question 102: The customer LAN switches SWA, SWB, and SWC form the RRPP ri...; Question 103: Regarding the basic concepts of MSTP, the correct statement ...; Question 104: Regarding RP and BSR, which of the following statements are ...; Question 105: In the switching network as shown in the figure, all three s...; Question 106: The customer requires that during network design, there must...; Question 107: To configure the Ethernet1/0/1 port of the switch SWA as a h...; Question 108: Regarding root bridge protection, the following statements a...; Question 109: Regarding the description of Isolate-user-vlan technology an...; Question 110: In the network connection as shown in the figure, SWA and SW...; Question 111: When the router receives the multicast data, it searches the...; Question 112: The customer requires that during network design, there must...; Question 113: In the networking shown in the figure, the interconnection l...; Question 114: When configuring MSTP, the configuration steps of area view ...; Question 115: Regarding the comparison of RSTP and STP BPDU format, the fo...; Question 116: What is correct about IGMP Snooping?...; Question 117: The following statements about the PIM SM joining process ar...

[×]

Download PDF File

Enter your email address to download H3C.GB0-371-ENU.v2021-12-16.q117.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 87/117

LEAVE A REPLY

Download PDF File