<< Prev Question Next Question >>

Question 145/151

An empty-configured MSR router is connected to the same OSPF network through multiple interfaces, and OSPF is enabled on all these interfaces. After the configuration is completed, the router has successfully learned the OSPF routes in the network.
Now run the following command on an OSPF interface of the router:
[MSR-GigabitEthernet0/0]ospf cost 256
In the case of keeping other configurations unchanged, the correct understanding of the configuration is _____.

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (151q)
Question 1: The following routing information is seen on the MSR router ...
Question 2: The three MSR routers are connected as shown in the figure. ...
Question 3: Divide a class B network segment into subnets. If the subnet...
Question 4: The following routing information is seen on the MSR router ...
Question 5: The Layer 2 Ethernet switch searches the MAC address table f...
Question 6: The correct sequence of the steps in the startup process of ...
Question 7: The customer's network connection looks like: HostA----GE0/0...
Question 8: The command to start the spanning tree protocol on the switc...
Question 9: The command to configure the switch SWA to work in RSTP work...
Question 10: The two MSR routers are interconnected through their respect...
Question 11: 119.100.1100 1000 132.119.100.1100 1111 .... Broadcast addre...
Question 12: The following statement about the upgrade of H3C network equ...
Question 13: A customer’s MSR router is connected to the Internet throug...
Question 14: The IP address 203.108.2.110 is the ______ address....
Question 15: Common FTP file transfer types include ______. (Multiple cho...
Question 16: The broadcast address of the natural classification network ...
Question 17: Which of the following statements about frame relay are corr...
Question 18: During the establishment of the TCP connection as shown in t...
Question 19: The IP address 112.1.1.1 corresponds to the network address ...
Question 20: The WAN link between the two routers MSR-1 and MSR-2 uses th...
Question 21: The client router's interface GigabitEthernet0/0 is connecte...
Question 22: The two routers MSR-1 and MSR-2 are interconnected through G...
Question 23: The correct statement about the IP address below is ______. ...
Question 24: When configuring ISDN DCC, the customer configured the follo...
Question 25: The IP address of a private network device A is 192.168.1.1/...
Question 26: The following statement about the upgrade of H3C network equ...
Question 27: The customer router MSR-1 configures the MP to connect to th...
Question 28: After configuring the relevant configuration of the Telnet s...
Question 29: The two WAN interfaces S1/0 and S1/1 of the router MSR-1 are...
Question 30: To view the debug information of NAT packets, you should use...
Question 31: The three MSR routers are connected as shown in the figure. ...
Question 32: In the LCP negotiation phase, what content will PPP negotiat...
Question 33: The correct statement below is ______. (Multiple choice)...
Question 34: After the DHCP client receives the DHCP ACK message, if it f...
Question 35: In the following statement about Easy IP, the error is _____...
Question 36: The network administrator of a certain enterprise needs to s...
Question 37: The rate of the D channel in ISDN BRI is ______....
Question 38: The hub (Hub) works in the ______ of the OSI reference model...
Question 39: Use the ______ command to specify the operating system softw...
Question 40: The Ethernet frame exchange on the switch relies on the MAC ...
Question 41: The common fields of UDP protocol and TCP protocol header ar...
Question 42: Two MSR routers are directly connected back-to-back through ...
Question 43: There are many kinds of WAN interfaces. Which of the followi...
Question 44: The address of the GE0/0 interface of the router MSR-1 is 19...
Question 45: To set a subnet mask so that 192.168.0.94 and 192.168.0.116 ...
Question 46: The two MSR routers are interconnected back-to-back through ...
Question 47: Which part of the subnet division technology is implemented ...
Question 48: Which of the following statements about Ethernet is correct ...
Question 49: The two branches of XYZ company are located in different reg...
Question 50: There are two hops from the source device to the destination...
Question 51: NAPT mainly converts the ______ information of the data pack...
Question 52: The FQDN of the following domain names is ______....
Question 53: The customer's network structure is shown in the figure. (Ex...
Question 54: Which of the following statements about HDLC is correct is _...
Question 55: Regarding the compressed expression of the IPv6 address 2001...
Question 56: The customer's network connection looks like: HostA----GE0/0...
Question 57: The network environment is shown in the figure. Do the follo...
Question 58: Two empty-configured MSR routers are directly connected back...
Question 59: The customer's network looks like this: HostA----GE0/0--MSR-...
Question 60: Which of the following statements about optical fiber are co...
Question 61: The two MSR30 routers of the customer are interconnected thr...
Question 62: Which of the following statements about IP addresses are cor...
Question 63: The PC is connected to the port E1/0/2 of the switch SWA, th...
Question 64: A network connection is like: HostA----GE0/0--MSR-1--S1/0---...
Question 65: The TFTP protocol is a protocol based on ______....
Question 66: Normally, the router will fragment packets whose length is g...
Question 67: If you want the current configuration to continue to take ef...
Question 68: In the switching network shown in the figure, all switches h...
Question 69: A Layer 3 switch is connected to the GigabitEthernet0/0 inte...
Question 70: The following statement about the functions of each layer of...
Question 71: The subnet mask of the IP address 132.119.100.200 is 255.255...
Question 72: The network delay (delay) defines the time required for the ...
Question 73: Connect an empty-configured MSR router to the network throug...
Question 74: Which of the following statements about the OSPF area in the...
Question 75: Use the ______ command on the MSR router to turn off the inf...
Question 76: An empty-configured MSR router connects to the frame relay n...
Question 77: The Ethernet port Ethernet1/0 of the customer router MSR-1 i...
Question 78: The transport layer protocol that DNS can use is ______....
Question 79: The interface information of a router is displayed as follow...
Question 80: The customer's network connection looks like: HostA----GE0/0...
Question 81: The standard physical medium of 100BASE-TX is ______....
Question 82: The user can use the ______ command to view the history comm...
Question 83: PPP has to go through a series of negotiation process before...
Question 84: The network address of the natural classification network se...
Question 85: The main link of the WAN of a company's MSR router is a sync...
Question 86: Use the display nat session command to view the NAT informat...
Question 87: The router S0/0 interface is connected to the network throug...
Question 88: In Windows operating system, which command can display ARP t...
Question 89: The MAC address table on a layer 2 switch is shown in the fi...
Question 90: According to the different ways the switch processes VLAN da...
Question 91: The customer router connects to the operator's network throu...
Question 92: If all 0 and all 1 subnets can be used as effective subnets,...
Question 93: In the switching network shown in the figure, all switches h...
Question 94: The customer's network connection looks like: HostA----GE0/0...
Question 95: Which of the following descriptions of circuit switching and...
Question 96: The correct statement below is ______. (Multiple choice)...
Question 97: During system startup, type ______ according to the prompt, ...
Question 98: Create an aggregate port with port Ethernet1/0/1 and ID 2 on...
Question 99: The two routers RTA and RTB are interconnected back-to-back ...
Question 100: A network administrator configured on a router RIP: rip 1 ve...
Question 101: Which of the following descriptions about Frame Relay DLCI a...
Question 102: A default route A is configured on an MSR router running RIP...
Question 103: Xiao L is a senior IP network expert, determined to develop ...
Question 104: UDP belongs to the ______ of the OSI reference model....
Question 105: On the MSR router, you can see the following display in the ...
Question 106: The WAN links of the customer's two routers MSR-1 and MSR-2 ...
Question 107: According to the needs of users, the administrator needs to ...
Question 108: A network connection is like: HostA----GE0/0--MSR-1--S1/0---...
Question 109: In the switching network shown in the figure, all switches h...
Question 110: On the MSR router, use the ______ command to view the curren...
Question 111: The customer's network connection looks like: N1-----MSR-1--...
Question 112: DNS works on the ______ of the OSI reference model....
Question 113: Two MSR routers implement dynamic routing learning through O...
Question 114: The following ACL is configured on the MSR router: acl numbe...
Question 115: Which of the following statements about HDLC is correct is _...
Question 116: Regarding the compressed expression of the IPv6 address 2001...
Question 117: The following statements about OSPF information display and ...
Question 118: In the router's routing table, there is an entry for a route...
Question 119: The following devices working at the data link layer of the ...
Question 120: The following ACL is configured on a router: acl number 2000...
Question 121: The router discovery function in IPv6 Neighbor Discovery Pro...
Question 122: The two empty-configured MSR routers are connected as shown ...
Question 123: During the establishment of the TCP connection as shown in t...
Question 124: The network environment is shown in the figure, ______ is th...
Question 125: The XYZ company network is shown in the figure. (Exhibit) Th...
Question 126: The following descriptions about Trunk ports and links are c...
Question 127: The number of available host addresses contained in the natu...
Question 128: If a port running STP in the Ethernet switch does not receiv...
Question 129: The routers MSR-1 and MSR-2 are interconnected through their...
Question 130: On the MSR router, if you want to view the files in the recy...
Question 131: The MAC address table on a layer 2 switch is shown in the fi...
Question 132: The customer's two MSR routers MSR-1 and MSR-2 are interconn...
Question 133: In the OSI reference model, encryption is a function of ____...
Question 134: On the MSR router, use the ______ command to view the router...
Question 135: Which of the following statements about CSMA/CD is correct i...
Question 136: A network environment looks like: HostA----GE0/0--MSR-1--S1/...
Question 137: The Serial0/0 interface of the router MSR1 of the Shenzhen b...
Question 138: In the routing table of an MSR router, which of the followin...
Question 139: The WAN link between the only two routers MSR-1 and MSR-2 in...
Question 140: In the process of tearing down the TCP connection as shown i...
Question 141: Suppose an MSR router obtains two routes to the destination ...
Question 142: Compared with the standard subnet division, the biggest diff...
Question 143: The IP protocol corresponds to layer ______ of the OSI refer...
Question 144: The customer's network connection looks like: HostA----GE0/0...
Question 145: An empty-configured MSR router is connected to the same OSPF...
Question 146: If a port running STP in the Ethernet switch receives and fo...
Question 147: Which of the following statements about MAC addresses are co...
Question 148: WLAN (Wireless LAN) is a combination of computer network and...
Question 149: An empty MSR router RTA connects two routers RTB and RTC run...
Question 150: If a port running STP in the Ethernet switch does not receiv...
Question 151: The following description of the characteristics of the rout...