<< Prev Question Next Question >>

Question 101/105

An EMC Data Domain customer wants to set up link aggregation using two network interface connections.
The connections will go from the Data Domain system to Switch A and Switch B.
The following IP/ networking configuration will be used to create the aggregation:
Switch A is connected to DD interface eth3a
10 GB link
IP = 10.200.1.10
Switch B is connected to DD interface eth4b
1 GB link
IP = 10.200.1.11
Which mode would you recommend for this configuration?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (105q)
Question 1: When configuring backups to an EMC Data Domain system using ...
Question 2: You are an administrator for an EMC Data Domain system. Rece...
Question 3: A customer is implementing an EMC Data Domain system integra...
Question 4: What is the default password on a new EMC Data Domain system...
Question 5: A customer is using EMC NetWorker with EMC DD Boost, writing...
Question 6: An EMC Data Domain system has been installed at a customer's...
Question 7: Refer to the exhibit. (Exhibit) When monitoring the system s...
Question 8: A customer is writing critical data to the pre-configured, d...
Question 9: A customer is deploying EMC Data Domain systems in four data...
Question 10: What are the states of the SAS LED connection status indicat...
Question 11: A customer environment has an EMC Data Domain system with Da...
Question 12: A company has decided to change their EMC Data Domain with N...
Question 13: A customer has an EMC Data Domain integrated into their Syma...
Question 14: What is a benefit of snapshots on an EMC Data Domain system?...
Question 15: A customer creates a DD Boost storage unit called "oracle". ...
Question 16: When a customer deploys an EMC Data Domain system at a remot...
Question 17: After backups are expired and data is marked for deletion, w...
Question 18: A customer has EMC Data Domain system installed in their dat...
Question 19: What is a characteristic of EMC Data Domain collection repli...
Question 20: You are installing an EMC Data Domain system with two expans...
Question 21: A customer wants to improve upon their current disaster reco...
Question 22: An EMC NetWorker 8.0 SP1 administrator is tasked with settin...
Question 23: In an EMC Data Domain environment, when are cage nuts used?...
Question 24: What is the default behavior for the "messages" log file in ...
Question 25: A customer needs the ability to prevent their retained data ...
Question 26: Refer to the exhibit (Exhibit) You are installing an EMC Dat...
Question 27: You are installing an EMC Data Domain system with two expans...
Question 28: An EMC Data Domain customer notices that backups are exceedi...
Question 29: An EMC Data Domain customer has an environment with 10 branc...
Question 30: A customer has two EMC Data Domain systems. They plan to per...
Question 31: An EMC Data Domain customer wants to add a static route usin...
Question 32: You are responsible for capacity planning in an EMC Data Dom...
Question 33: A customer is backing up data to an EMC Data Domain system w...
Question 34: Refer to the exhibit. (Exhibit) When monitoring the system s...
Question 35: A customer has configured an MTree (/data/col1/departments) ...
Question 36: Refer to Exhibit. (Exhibit) An EMC Data Domain customer has ...
Question 37: A customer wants to integrate an EMC Data Domain appliance i...
Question 38: A customer wants to integrate an EMC Data Domain system with...
Question 39: An EMC Data Domain customer is looking for a way to charge e...
Question 40: You are tasked with integrating two new EMC Data Domain syst...
Question 41: What changed in the WWN format of the EMC Data Domain OS 5.4...
Question 42: On an EMC Data Domain system, what is the role of file syste...
Question 43: An organization currently writes backups to an EMC Data Doma...
Question 44: When using Intel cards, how many 10 GbE interfaces can be us...
Question 45: When using VTL on an EMC Data Domain system, why should pers...
Question 46: A company is replicating two specific directories between tw...
Question 47: Refer to the Exhibit. (Exhibit) On the EMC Data Domain syste...
Question 48: On an EMC Data Domain system with Extended Retention, when i...
Question 49: What is the current NAA type in the WWN format used within E...
Question 50: Refer to the Exhibit. (Exhibit) When creating a second shelf...
Question 51: An EMC Data Domain customer can view data on a destination s...
Question 52: What is the maximum number of snapshots supported on an EMC ...
Question 53: An EMC Data Domain administrator needs to replicate the enti...
Question 54: Which two licenses are tied to capacity on an EMC Data Domai...
Question 55: Refer to the exhibit. (Exhibit) Based on the exhibit, what d...
Question 56: A customer's EMC Data Domain system has an Ethernet port cal...
Question 57: As an administrator, you are configuring the data movement p...
Question 58: Which user role is limited to monitoring and performing fast...
Question 59: In a EMC Data Domain system, which user role allows creation...
Question 60: An EMC NetWorker customer has recently implemented an EMC Da...
Question 61: Which protocols are supported with EMC Data Domain Extended ...
Question 62: You are tasked with installing a new EMC Data Domain system ...
Question 63: Refer to the Exhibit. (Exhibit) On the EMC Data Domain syste...
Question 64: Which command is used to check the SAS HBA card status on an...
Question 65: By default, which percentage of CPU resources are allocated ...
Question 66: An administrator wants to decrease the time needed to back u...
Question 67: A customer is integrating an EMC Data Domain into their Syma...
Question 68: In an EMC Data Domain system with Extended Retention, what i...
Question 69: Refer to the Exhibit. (Exhibit) When connecting a single exp...
Question 70: A customer wants to use the 10 GigE interfaces in their EMC ...
Question 71: Which segment size(s) is used by EMC Data Domain SISL?...
Question 72: You have deployed an EMC Data Domain system in a customer en...
Question 73: While implementing an EMC Data Domain system, the system is ...
Question 74: Refer to the Exhibit. (Exhibit) On the EMC Data Domain syste...
Question 75: Which hardware and capacity license options are available fo...
Question 76: When monitoring EMC Data Domain systems, an administrator se...
Question 77: What does the EMC Data Domain file level retention locking f...
Question 78: Which CLI command will display information about disks in EM...
Question 79: Which CLI command will show the cleaning status on an EMC Da...
Question 80: A customer wants to implement EMC Data Domain Extended Reten...
Question 81: NetBackup has been configured to use an EMC Data Domain appl...
Question 82: An EMC Data Domain customer wants VTL replication functional...
Question 83: A customer notices an improved deduplication rate and write ...
Question 84: If a customer has an EMC Data Domain (DD) system with Extend...
Question 85: What can an optional PCI-x Card slot be used for on an EMC D...
Question 86: A customer is deploying an EMC Data Domain system for virtua...
Question 87: In which path location are Autosupport logs stored on an EMC...
Question 88: Refer to the exhibit. (Exhibit) You are installing an EMC Da...
Question 89: Which TCP port is used to send SNMP traps from an EMC Data D...
Question 90: You have been tasked with configuring an NFS export on an EM...
Question 91: A customer wants to integrate an EMC Data Domain appliance i...
Question 92: If you have a 2U EMC Data Domain Controller with three expan...
Question 93: Where does in-line deduplication occur in an EMC Data Domain...
Question 94: Which method of deduplication yields better deduplication re...
Question 95: An EMC Data Domain customer has configured replication of fo...
Question 96: What is the maximum number of MTrees that can be created on ...
Question 97: What is indicated by a flashing green LED on an EMC Data Dom...
Question 98: On an EMC Data Domain system, which command is used to add a...
Question 99: A customer's EMC Data Domain system reports a global compres...
Question 100: If cleaning is already in progress, when does data movement ...
Question 101: An EMC Data Domain customer wants to set up link aggregation...
Question 102: On an EMC Data Domain system, when does the "throttle" setti...
Question 103: A customer reports that their EMC Data Domain system is runn...
Question 104: A customer is deploying an EMC Data Domain system for virtua...
Question 105: What is the name of the dedicated IPMI management Ethernet p...