FreeCram
  1. Home
  2. EMC
  3. Specialist - Implementation Engineer, PowerProtect DD Exam
  4. EMC.DES-DD23.v2022-12-07.q18
  5. Question 2
<< Prev Question Next Question >>

Question 2/18

An engineer is configuring a PowerProtect DD system for VTL using Fibre Channel. How should the zones be configured?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (18q)
Question 1: An engineer is deploying two PowerProtect DD6900 systems in ...
Question 2: An engineer is configuring a PowerProtect DD system for VTL ...
Question 3: Which command is used to check if NFS is enabled?...
Question 4: Refer to the exhibit. (Exhibit) To which shelf and port shou...
Question 5: What happens to the data when it is moved from the active ti...
Question 6: A PowerProtect DD appliance has been installed at a company'...
Question 7: A backup administrator has enabled the Retention Lock featur...
Question 8: A PowerProtect DD system is configured for VTL. The backup a...
Question 9: Which PowerProtect DD procedure uses the DoD/NIST standards ...
Question 10: A customer needs to use DD Retention Lock Compliance to ensu...
Question 11: Which of the following protocols are supported by PowerProte...
Question 12: What is the correct sequence of steps to configure storage f...
Question 13: The finance department requires PDFs older than 90 days to b...
Question 14: An administrator has retained snapshots for a single MTree a...
Question 15: An organization uses tape libraries in their current backup ...
Question 16: When the PowerProtect DD system boots up for the first time,...
Question 17: Which enterprise applications does the DDBEA agent support?...
Question 18: An administrator recognizes poor network performance when us...