<< Prev Question Next Question >>

Question 17/22

Exhibit:

The exhibit represents a topology with all Dell EMC N4000 Series switches with RSTP enabled. In addition, the switches are using the default configuration on all ports and protocols.
Which port number will be blocked by spanning tree?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (22q)
Question 1: N4032F#show interfaces status (Exhibit) N4032F#show interfac...
Question 2: If a group of routers are running VRRP with a virtual router...
Question 3: What is the typical sequence of steps to upgrade the firmwar...
Question 4: A Dell EMC N-Series switch is configured to uplink to a cust...
Question 5: What is the maximum number of dynamic MAC addresses that can...
Question 6: What describes the POE+ capabilities of the Dell EMC N1100P ...
Question 7: Refer to the Exhibit. (Exhibit) If Client B sends a packet t...
Question 8: What happens when a match is found for an ACL with 15 entrie...
Question 9: A user's workstation is connected to an IP phone that is con...
Question 10: A network administrator wants to configure an ACL to deny tr...
Question 11: A network administrator is setting up several stacks in thei...
Question 12: Which default security level can be assigned to limit access...
Question 13: A network administrator added a new Dell EMC N-Series switch...
Question 14: Which interface on a Dell EMC N-Series switch provides the m...
Question 15: Which RSTP-PV features are embedded and cannot be disabled?...
Question 16: What is a recommended configuration for an MLAG peer-link on...
Question 17: Exhibit: (Exhibit) The exhibit represents a topology with al...
Question 18: Which commands should a network administrator use to configu...
Question 19: If a VRRP Master router is rebooted, what is the default beh...
Question 20: Which port security method converts existing dynamically lea...
Question 21: You need to configure OSPF on a DNOS 6 switch and have enter...
Question 22: In order to alter a packet's routing direction, which packet...