Next Question >>

Question 1/36

Which method can be used to identify the server HBA WWN?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (36q)
Question 1: Which method can be used to identify the server HBA WWN?...
Question 2: A customer is running the Dell Storage Manager (DSM) Suite a...
Question 3: In an SC Series environment, which Fibre Channel zoning meth...
Question 4: What is a licensed feature of Dell Storage Manager?...
Question 5: A customer notices a volume is using an above average amount...
Question 6: You have implemented two SC Series systems at a customer sit...
Question 7: A customer wants to configure a threshold alert definition. ...
Question 8: A customer wants to add an iSCSI path to a Microsoft Windows...
Question 9: What is the purpose of the Dell Storage Manager (DSM) Server...
Question 10: Assume a storage administrator is using the recommended stor...
Question 11: Which SC Series array feature simplifies iSCSI connectivity ...
Question 12: Why should Legacy Port Mode be selected rather than Virtual ...
Question 13: When performing the initial configuration on an SC9000 throu...
Question 14: An SC9000 controller was rebooted to test failover and is ba...
Question 15: How much memory does the Dell Storage Manager (DSM) Virtual ...
Question 16: When an RS-232 serial cable is connected between a service l...
Question 17: When installing an SC Series array, the customer indicated t...
Question 18: You are deploying a new SCv2020 system with four additional ...
Question 19: Which configuration represents how the back-end is cabled on...
Question 20: You are deploying a new SC9000 system running Storage Center...
Question 21: A customer is using an SC8000 array with three chained SC220...
Question 22: Which 64-bit server operating systems are compatible with th...
Question 23: Which operating system runs the Dell Storage Manager (DSM) a...
Question 24: You need to set up the iDRAC IP address on an SC Series cont...
Question 25: You are installing a new SC9000. Which procedure should be u...
Question 26: Refer to the exhibit. (Exhibit) Which port on the second SC2...
Question 27: (Exhibit) Based on the exhibit, a customer is using Virtual ...
Question 28: A customer wants to add an SC420 and an SC200 to a SC7020 st...
Question 29: You are implementing a front-end connection in Legacy Port M...
Question 30: What are the possible methods to upgrade the firmware on a B...
Question 31: Based on documented best practices, which options may need t...
Question 32: What is the maximum number of disks that can be supported by...
Question 33: Which component of the Dell Storage Manager (DSM) Suite's on...
Question 34: During the initial installation of a new SC9000 Storage Cent...
Question 35: An administrator wants to configure an SC Series array to us...
Question 36: A customer is concerned they are over utilizing their 7K dri...