<< Prev Question Next Question >>

Question 15/24

A network administrator is troubleshooting an OSPF routing issue. There are two paths to a destination network from one switch. In addition, one path is comprised of four 1 Gb links. The other path is comprised of two 1 Gb and two 100 Mb links. The administrator ran several trace routes and notices that the packets are swapping back and forth between the two paths.
Which corrective action must be taken on the switch infrastructure to correct this issue?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (24q)
Question 1: In which Spanning Tree protocol state does a port record MAC...
Question 2: Which platforms are supported by the Dell EMC Networking OS ...
Question 3: Which fields are mandatory TLVs in a LLDP PDU frame?...
Question 4: What accurately describes the Network Time Protocol (NTP)?...
Question 5: What is the bandwidth of an RPM for a C9010 Network Director...
Question 6: What is the aggregated lanes' maximum speed rating for a QSF...
Question 7: Which IP address is in the Class B range?...
Question 8: What is the default OSPF "hello interval"?...
Question 9: A Dell EMC Networking N-Series switch is configured on a por...
Question 10: Which option is used to configure Network Address Translatio...
Question 11: A network administrator wants to use a subnet that will only...
Question 12: Which message is sent by a router when TTL expires?...
Question 13: What is the valid range assigned to a client during a TCP co...
Question 14: What accurately describes the comparison between stacking an...
Question 15: A network administrator is troubleshooting an OSPF routing i...
Question 16: Which Ethernet frame forwarding method works best when the o...
Question 17: A network administrator has a Dell EMC switch that has been ...
Question 18: Which port and protocol is used by NTP to communicate?...
Question 19: Refer to the exhibit. (Exhibit) Switch A and Switch B are co...
Question 20: Which BASE-T Ethernet standard specifies a CAT6 cable type?...
Question 21: Which port type does a Dell EMC Networking N-Series switch h...
Question 22: How is a switch different from a hub?...
Question 23: On which Dell EMC Networking switches can Multi-Chassis Link...
Question 24: What is the correct sequence of steps when a web browser acc...