In a VPLEX system, zoning a host initiator to a Director-A port requires identifying the front-end ports, which are used for host connectivity. Based on the standard VPLEX director port configuration:
* Director Identification: Determine which unit is Director-A. In a VPLEX system, directors are typically labeled as A or B, and each has a set of front-end and back-end ports1.
* Front-End Port Selection: The front-end ports on Director-A are used for connecting to host initiators.
These ports are typically numbered starting with 01.
* Zoning Process: Zoning involves configuring the SAN fabric to allow communication between the host's HBA (Host Bus Adapter) and the VPLEX front-end port. This is done using the SAN switch management interface1.
* Port Identification in Exhibit: Based on the exhibit provided, if the black arrow points to the first port on Director-A, it would be the front-end port 0, which can be zoned to a host initiator1.
* Verification: To confirm the correct port for zoning, one would typically refer to the official Dell EMC VPLEX documentation for hardware installation and setup, which would provide clear labeling of each port1.
In summary, based on the standard VPLEX port configuration, the Director-A port that can be zoned to a host initiator is the front-end port 0, which is indicated by the letter D in the exhibit provided.