<< Prev Question Next Question >>

Question 25/78

A Dell EMC N3048P with two power supplies is configured for Class-Based Power Management.
The switch has the following devices connected and fully operational:
10x 802.3af PDs negotiating as Class0 devices
10x 802.3af PDs negotiating as Class4 devices
10x 802.3at PDs negotiating as Class4 devices
How much power is reserved from the PSE budget by the devices referenced above?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (78q)
Question 1: Why would a network administrator select MLAG for two switch...
Question 2: Based on the graphic, which command should be used on the De...
Question 3: Which OSPF router type connects one or more Areas to the Bac...
Question 4: Which command will show the policy-based routing map applied...
Question 5: Which configuration tool will allow a network administrator ...
Question 6: A switch has the following IP configuration: - VLAN10: IP ad...
Question 7: Which AAA method is only used for 802.1x and never returns a...
Question 8: What describes the POE+ capabilities of the Dell EMC N1100P ...
Question 9: What Dell PowerSwitch N-Series switches require QSFP28 to be...
Question 10: In a PoE environment, what information does the Network Poli...
Question 11: Which port security method converts existing dynamically lea...
Question 12: You need to configure OSPF on a DNOS 6 switch and have enter...
Question 13: In a Dell EMC N-Series switch, what is the default LAG hashi...
Question 14: When setting up VoIP, you decide that you want to use LLDP. ...
Question 15: What is true about Dell N1100 Series switches?...
Question 16: Which two are true about discovery protocols on the Dell N-S...
Question 17: A network administrator configured two Dell EMC N-Series swi...
Question 18: What is the typical sequence of steps to upgrade the firmwar...
Question 19: Which scope provides for unique public IPv6 addresses routab...
Question 20: How many untagged VLANs are allowed on a switchport mode tru...
Question 21: A network administrator wants different applications' traffi...
Question 22: You are configuring VRRP on a group of Dell EMC Campus netwo...
Question 23: A network administrator wants to lock down network access us...
Question 24: If a VRRP Master router is rebooted, what is the default beh...
Question 25: A Dell EMC N3048P with two power supplies is configured for ...
Question 26: What is the maximum number of dynamic MAC addresses that can...
Question 27: Which technology is designed to protect against a default ga...
Question 28: What are key features of the Dell EMC N4064 or N4064F switch...
Question 29: If VoIP traffic uses multiple QoS prioritization schemes, wh...
Question 30: What describes the operation of a VRRP router in a backup st...
Question 31: What describes Dell EMC support for UPoE in the Campus netwo...
Question 32: A router from a different AS is advertising a route to Area ...
Question 33: Which Dell PowerSwitch N-Series model supports the BGP and s...
Question 34: What is the PoE source maximum power budget for a Class 3 en...
Question 35: In a traditional campus network design using a three-tier hi...
Question 36: Which command should a network administrator use to configur...
Question 37: A user connects via serial to a switch in a stack and gets t...
Question 38: What is an accurate statement about configuring a LAG on a D...
Question 39: Which two functions do the preempt command configure on VRRP...
Question 40: Which bit value is commonly used to indicate video traffic w...
Question 41: What are two benefits of using remote user accounts for swit...
Question 42: Which interface on a Dell EMC N-Series switch provides the m...
Question 43: How can a network administrator determine which Dell PowerSw...
Question 44: What is the maximum power that a Class 4 PoE device can cons...
Question 45: Refer to the exhibit: (Exhibit) Which authentication method ...
Question 46: Which Layer 2 network protocol is used for automatic configu...
Question 47: Which decimal value is used to indicate Assured Forwarding w...
Question 48: Refer to the Exhibit. (Exhibit) Switch-1(config)# radius ser...
Question 49: Which command is used to display the current VLAN and switch...
Question 50: Which type of an attack is considered MAC poisoning?...
Question 51: Which command enables Virtual Router Redundancy Protocol in ...
Question 52: A customer is upgrading their campus network Access layer sw...
Question 53: You have been tasked with troubleshooting a LAG issue betwee...
Question 54: Which Dell EMC N-Series switch models can have up to 12 of t...
Question 55: Which statement is correct about IPv6?...
Question 56: What is the Administrative Distance of static routes on a De...
Question 57: What is the maximum N1100 and N1500 switches that can be sta...
Question 58: Which function does a VRRP backup router perform?...
Question 59: A network administrator is troubleshooting why Host 1 cannot...
Question 60: A user's host with an IP address of 172.16.1.22/24 is attemp...
Question 61: What is the effect of the default preempt setting on a Dell ...
Question 62: What describes one of the primary functions of a VLAN?...
Question 63: Which methods can be used by an IP phone to put priority on ...
Question 64: Which L3 feature overrides routing protocol decisions and de...
Question 65: Standard IP access-lists are not supported on Dell PowerSwit...
Question 66: Which is a valid link-local IPv6 address?...
Question 67: Refer to the Graphic. (Exhibit) If the switches are configur...
Question 68: What happens when a match is found for an ACL with 15 entrie...
Question 69: A network administrator wants the traffic on different appli...
Question 70: A network administrator is configuring a switch for authenti...
Question 71: What is the IP protocol number, in decimal, assigned by IANA...
Question 72: When configuring a standard MAC ACL on a Dell EMC N-Series s...
Question 73: If a user's IP phone sends a frame to a Dell EMC N-Series sw...
Question 74: What is the destination IP address for IPv4 VRRP keep-alives...
Question 75: What is needed to allow an SSH connection to a Dell EMC N-Se...
Question 76: An administrator is attempting to configure MLAG on two pair...
Question 77: In the VRRP configuration between two switches, switch A is ...
Question 78: Users report phone calls on VOIP phones have degraded audio ...