Valid DSDPS-200 Dumps shared by ExamDiscuss.com for Helping Passing DSDPS-200 Exam! ExamDiscuss.com now offer the newest DSDPS-200 exam dumps, the ExamDiscuss.com DSDPS-200 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com DSDPS-200 dumps with Test Engine here:
Access DSDPS-200 Dumps Premium Version
(56 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 37/55
A technician sets up a new PS Series 6100XV array in an existing PS Group. The PS Group runs on a 10 GbE network with Data Center Bridging (DCB) enabled.
What is the effect on the topology of the iSCSI network?
What is the effect on the topology of the iSCSI network?
Correct Answer: B
Explanation/Reference:
Explanation:
6100XV supports DCB.
DCB requirements for PS Series arrays
It is required that all devices in the PS Series SAN support DCB for iSCSI when this functionality is enabled. If any device in the SAN does not support DCB, then DCB needs to be disabled at the switches for the entire SAN. Once all devices in the SAN are DCB compliant, then DCB can be re-enabled.
References:
Dell EMC Storage Compatibility Matrix for SC,PS and FS Series Arrays, page 28
http://en.community.dell.com/dell-groups/dtcmedia/m/mediagallery/20438558/download Dell PS Series Configuration Guide, page 70
http://en.community.dell.com/dell-groups/dtcmedia/m/mediagallery/19852516/download
Explanation:
6100XV supports DCB.
DCB requirements for PS Series arrays
It is required that all devices in the PS Series SAN support DCB for iSCSI when this functionality is enabled. If any device in the SAN does not support DCB, then DCB needs to be disabled at the switches for the entire SAN. Once all devices in the SAN are DCB compliant, then DCB can be re-enabled.
References:
Dell EMC Storage Compatibility Matrix for SC,PS and FS Series Arrays, page 28
http://en.community.dell.com/dell-groups/dtcmedia/m/mediagallery/20438558/download Dell PS Series Configuration Guide, page 70
http://en.community.dell.com/dell-groups/dtcmedia/m/mediagallery/19852516/download
- Question List (55q)
- Question 1: A customer is moving to a new datacenter and needs to put th...
- Question 2: An administrator recently deploys the Dell Virtual Storage M...
- Question 3: A customer needs to control the location of data securely. D...
- Question 4: SupportAssist has been enabled for a PS Series group. The Ac...
- Question 5: The volume in-use warning slider is visible only when which ...
- Question 6: A customer shares an iSCSI network with other traffic. What ...
- Question 7: A technician is setting up a new M1000e blade environment th...
- Question 8: A customer orders a PS6610E storage array. What does the "E"...
- Question 9: A SQL administrator needs to deploy two databases: one for s...
- Question 10: An installer deploys a new environment that consists of a si...
- Question 11: A technician has installed the Host Integration Toolkit (HIT...
- Question 12: A customer has a large complex VMware environment connected ...
- Question 13: A customer reports that a problematic array is acting up. Th...
- Question 14: As part of failover testing, a technician restarts one of th...
- Question 15: (Exhibit) Refer to the exhibit. An installer configures one ...
- Question 16: An installer needs to set up a PS Series group using the rec...
- Question 17: A customer has several datacenters on a small campus with fu...
- Question 18: An installer sets up multiple volumes on a PS Series group a...
- Question 19: An administrator needs to change the RAID type from RAID 10 ...
- Question 20: A customer needs 36 TB of storage space for an upcoming SAN ...
- Question 21: According to Dell recommendations, when should a firmware up...
- Question 22: A customer needs to use a Disaster Recovery (DR) site for re...
- Question 23: A technician needs to install PSM4110 storage arrays in an M...
- Question 24: An engineer is creating snapshot schedules for a volume to p...
- Question 25: A customer must capture latency issues that occur for a very...
- Question 26: (Exhibit) Refer to the exhibit. An installer has cabled an a...
- Question 27: Which four PC arrays support Vertical Port Failover? (Choose...
- Question 28: Which three settings are unique when creating a thin volume?...
- Question 29: A customer requires a one-way replication of a volume to a r...
- Question 30: A customer buys two PS Series arrays to store data for the d...
- Question 31: A new storage administrator (SA) is configuring replication ...
- Question 32: (Exhibit) Refer to the exhibit. An installer is adding a new...
- Question 33: When does a VLAN ID need to be configured on Dell PS Series ...
- Question 34: Which two cable types are appropriate to cable a 10 Gb PS Se...
- Question 35: A technician needs to add a new PS Series array to existing ...
- Question 36: An installer needs to deploy a PS series SAN and connect Sus...
- Question 37: A technician sets up a new PS Series 6100XV array in an exis...
- Question 38: A technician is setting up a 10 GbE PS Series group SAN usin...
- Question 39: A customer has a single-member group with a RAID policy of R...
- Question 40: A VMware administrator requests the creation of a 100 GB vol...
- Question 41: A customer is deploying a new PS Series Storage array that w...
- Question 42: A customer has a multi-member, multi-pool group in productio...
- Question 43: A customer needs a full, permanent, point-in-time, local cop...
- Question 44: An engineer needs to migrate a volume from a live production...
- Question 45: An alarm is triggered within vCenter. The alarm indicates th...
- Question 46: A technician needs to install three Windows hosts and one PS...
- Question 47: Which Dell PowerEdge server slot does an HBA card use?...
- Question 48: A technician needs to implement a new VMware ESXi 5.5. envir...
- Question 49: A storage administrator has a two-member PS Series group tha...
- Question 50: A customer has a Windows 2012 VM that runs on a VMware ESXi ...
- Question 51: A customer has 10 volumes within a storage group. Each volum...
- Question 52: An installer needs to deploy a PSM4110 array in a new blade ...
- Question 53: A customer has an existing group with a single PS6210X membe...
- Question 54: What are three reasons that the iSCSI subnet might need to b...
- Question 55: A 1 Gb PS Series group with a pool having multiple arrays is...
