<< Prev Question Next Question >>

Question 16/54


Refer to the exhibit.
The trunk links are being over utilized. A network engineer needs to resolve the issue by pruning the trunk links of unnecessary vlans. Each switch must be management accessible via VLAN 1.
What are the allowed vlans on each trunk link?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (54q)
Question 1: A network engineer needs to apply Layer 2 port security on a...
Question 2: Which three components can be used to deploy 10GbE N-Series ...
Question 3: (Exhibit) Refer to the exhibit. The deployment engineer need...
Question 4: In an OSPF network, what happens if the OSPF Priority level ...
Question 5: (Exhibit) Refer to the exhibits. A networking engineer is un...
Question 6: (Exhibit) Refer to the exhibit. On switch S4820-2, commands ...
Question 7: By default, how often are Bridge Protocol Data Units (BPDUs)...
Question 8: Which of the following effectively describes basic iBGP?...
Question 9: A network engineer needs to create a VLAN on the N-Series sw...
Question 10: (Exhibit) Refer to the exhibit. A customer plans to deploy a...
Question 11: Refer to the exhibit. A customer installs a non-PoE line car...
Question 12: What is the correct syntax to set a management route on an S...
Question 13: A network engineer is configuring several trunk ports for VL...
Question 14: A network engineer has configured LACP on two connected S-Se...
Question 15: A customer has two locations that are six miles apart and co...
Question 16: (Exhibit) Refer to the exhibit. The trunk links are being ov...
Question 17: A network engineer needs to install five Dell N-Series switc...
Question 18: Which three properties are required for two OSPF router inte...
Question 19: The network engineer has two Dell Networking switches: an N-...
Question 20: (Exhibit) Refer to the exhibit. On switch S4820-1, commands ...
Question 21: Refer to the exhibit. A networking engineer reviews output f...
Question 22: What is the correct syntax to configure an Out-of-Band inter...
Question 23: A customer needs to convert S-Series stacked switches to a V...
Question 24: Refer to the exhibit. A network engineer is implementing MLA...
Question 25: A network engineer is verifying the configuration of a LAG c...
Question 26: (Exhibit) Refer to the exhibit. On switch S4820-1, commands ...
Question 27: A network engineer is modifying an existing VLT configuratio...
Question 28: A networking engineer needs to configure several VLANs for S...
Question 29: Refer to the exhibit. A network engineer utilizes the hot an...
Question 30: Refer to the outputs. (Exhibit) Without announcing all conne...
Question 31: A network engineer needs to raise the STP priority value fro...
Question 32: (Exhibit) Refer to the exhibit. Two S-Series switches are co...
Question 33: (Exhibit) Refer to the exhibits of the S-Series switch. A ne...
Question 34: Which component is required to deploy the N2000/N3000 Series...
Question 35: Two Dell S-Series Switches are directly connected. (Exhibit)...
Question 36: A network engineer is troubleshooting an access-list issue o...
Question 37: Refer to the exhibits. A network engineer has configurations...
Question 38: A customer needs to convert S-Series stacked switches to a V...
Question 39: (Exhibit) Refer to the exhibit. A customer has a C-Series ch...
Question 40: The exhibit shows an IGMPv2 multocast network where "Rn" are...
Question 41: A previous network engineer has disabled Power-over-Ethernet...
Question 42: A network engineer is working with an S-Series switch. The n...
Question 43: On an S-Series switch, what two events occur when a static n...
Question 44: Refer to the exhibits. A network engineer is troubleshooting...
Question 45: A network engineer needs to create an IEEE 802.3ad Port-Chan...
Question 46: (Exhibit) Refer to the exhibit. Two S-Series switches have b...
Question 47: Which process should a network engineer use to update the fi...
Question 48: Which two methods can determine the master switch selection ...
Question 49: Which three cabling items should be considered when stacking...
Question 50: (Exhibit) Refer to the exhibits. An organization has a netwo...
Question 51: Refer to the output. (Exhibit) According to the partial conf...
Question 52: (Exhibit) Refer to the exhibit. A customer has a SAN deploym...
Question 53: Exhibit 1. (Exhibit) Exhibit 2. (Exhibit) Refer to the exhib...
Question 54: (Exhibit) Refer to the exhibit. Given the output from an N-S...