DCAN-100 Exam Dumps | Refer to the output: console#show interfaces switchport gigabitethernet 1/0/5 Port: Gi1/0/5 VLAN Membership

Home
Dell
Dell Networking Associate Exam
Dell.DCAN-100.v2018-09-16.q35
Question 27

Valid DCAN-100 Dumps shared by ExamDiscuss.com for Helping Passing DCAN-100 Exam! ExamDiscuss.com now offer the newest DCAN-100 exam dumps, the ExamDiscuss.com DCAN-100 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com DCAN-100 dumps with Test Engine here:

Access DCAN-100 Dumps Premium Version
(62 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 27/35

Refer to the output:
console#show interfaces switchport gigabitethernet 1/0/5
Port: Gi1/0/5
VLAN Membership Mode: Access Mode
Access Mode VLAN: 3
General Mode PVID: 1 (default)
General Mode Ingress Filtering: Enabled
General Mode Acceptable Frame Type: Admit All
General Mode Dynamically Added VLANs:
General Mode Untagged VLANs: 1
General Mode Tagged VLANs:
General Mode Forbidden VLANs:
Trunking Mode Native VLAN: 1 (default)
Trunking Mode Native VLAN Tagging: Disabled
Trunking Mode VLANs Enabled: All
Private VLAN Host Association: none
Private VLAN Mapping:
Private VLAN Operational Bindings:
Default Priority: 0
Protected: Disabled
Port Gi1/0/5 on a Dell N2024 will be used to create an IEEE 802.1Q-compliant trunk to another switch.
Why will the trunk fail to form?

A. Native VLAN tagging is disabled.

B. VLANs have not been created on this switch.

C. The port is currently configured for a single VLAN.

D. The correct IP address has not been configured.

Correct Answer: C

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (35q): Question 1: An N-Series switch is configured to route between VLANs 1 an...; Question 2: Which of the following is the starting prefix to denote a li...; Question 3: A network technician has printers that negotiate at half-dup...; Question 4: Two N3024F switches are directly connected using 10GBASE-SR ...; Question 5: A Dell N2024 switch receives a frame from a directly connect...; Question 6: A technician must deploy powering source equipment at a cust...; Question 7: A technician needs to configure a static LAG between two N-S...; Question 8: A technician creates a new connection between two switches. ...; Question 9: Refer to the exhibit. (Exhibit) Two Dell Networking N2000s c...; Question 10: A dell Networking N-Series has configured a port-channel wit...; Question 11: A technician decides to create an ACL. The technician includ...; Question 12: Which switch should Spanning Tree Protocol choose to become ...; Question 13: Refer to the output from a Dell N-Series switch: (Exhibit) A...; Question 14: A client must connect a printer located on a public area on ...; Question 15: What does the blinking yellow Activity/PoE LED indicate on a...; Question 16: A Dell Networking N3024 has a link aggregation configured as...; Question 17: How will RIP treat packets that have exceeded the default ma...; Question 18: Refer to the output: (Exhibit) A technician creates a new fi...; Question 19: Refer to the output. (Exhibit) A technician implements a new...; Question 20: Which of the following is an IPv4 address?...; Question 21: Refer to the exhibit and output. (Exhibit) Which change shou...; Question 22: Refer to the output: (Exhibit) How has OSPF been configured?...; Question 23: A technician enables Dot1x RADIUS authentication globally on...; Question 24: Which two subnet masks should be used to achieve a network i...; Question 25: What are two commonly deployed PoE powered devices? (Choose ...; Question 26: A Dell Networking N-Series switch is directly connected to a...; Question 27: Refer to the output: console#show interfaces switchport giga...; Question 28: Refer to the output shown: (Exhibit) Which two statements de...; Question 29: Which two port states are valid on a root bridge in a conver...; Question 30: Refer to the exhibit. (Exhibit) A technician configures RIP ...; Question 31: A technician implements a new copper connection to Gi2/0/20....; Question 32: The "show ip ospf database" command outout indicates Type 5 ...; Question 33: What are three benefits of using dynamic routing protocols o...; Question 34: A technician inserts an SFP+transceiver into an N3024F 1 Gbp...; Question 35: Root bridge Switch A is connected to Switch B They are conne...

[×]

Download PDF File

Enter your email address to download Dell.DCAN-100.v2018-09-16.q35.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 27/35

LEAVE A REPLY

Download PDF File