FreeCram
  1. Home
  2. Cisco
  3. Implementing and Maintaining Cisco Technologies Using IOS XR
  4. Cisco.644-906.v2019-01-24.q39
  5. Question 16
<< Prev Question Next Question >>

Question 16/39

Which command should be used to view only the running configuration of OSPF in Cisco IOS XR Software?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (39q)
Question 1: Which three types of packet drop statistics can be determine...
Question 2: What is the effect of configuring "logging disable"?...
Question 3: What is the correct procedure to associate a VRF to a static...
Question 4: How many stages are there in the Cisco CRS-1 switch fabric?...
Question 5: Which statement is false?
Question 6: (Exhibit) Referring to the configuration output exhibit, whi...
Question 7: Which CLI command can be used to display interfaces statisti...
Question 8: Which is-is router interface configuration command will conf...
Question 9: Which three commands can verify that the route-policy shown ...
Question 10: Which two of the following statements regarding task-based a...
Question 11: In which two ways do you set the maximum number of Telnet se...
Question 12: What is the correct Cisco IOS XR command to configure an aut...
Question 13: Refer to the exhibit. (Exhibit) Examine the configuration fo...
Question 14: What is the correct command to copy the contents of the hard...
Question 15: Which four list the mandatory steps in order to implement SS...
Question 16: Which command should be used to view only the running config...
Question 17: Which Cisco IOS XR show command is used to display the IPv4 ...
Question 18: Which command will show the IP address of a Cisco Discovery ...
Question 19: Refer to the exhibit. (Exhibit) Based on the configuration, ...
Question 20: How would MPLS Label Distribution Protocol, Graceful Restart...
Question 21: How would you configure IS-IS process TEST to support MPLS T...
Question 22: Which configuration is required in order for chassis managem...
Question 23: On a Cisco CRS, which statement is correct about what happen...
Question 24: What are the two commands to show all log entries except BGP...
Question 25: What is the main function of LPTS?...
Question 26: What is the size of the packets that traverse the Cisco CRS-...
Question 27: Which Cisco IOS XR only command will show the status of IPv4...
Question 28: Where is the LPTS policer applied?...
Question 29: What are the two prerequisites for enabling multicast-only f...
Question 30: (Exhibit) Referring to the diagram and configuration on Rout...
Question 31: Which of the following functions can be configured in the Ad...
Question 32: Which component is shared between different SDRs?...
Question 33: Which of the following configurations adds a community to ro...
Question 34: Which optional PIE do you need to install if you want to use...
Question 35: When running MPLS Traffic Engineering with Cisco IOS XR Soft...
Question 36: Which configuration command will set EXEC shell timeout on t...
Question 37: Which Cisco IOS XR command sequence will load a specific con...
Question 38: Which Cisco IOS XR command is the most useful for checking i...
Question 39: A network administrator needs to configure a default IPv4 ro...