<< Prev Question Next Question >>

Question 98/109

When implementing CSC services, which two methods can be used to exchange label information between the downstream CSC customer carrier and the CSC backbone carrier? (Choose two.)

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (109q)
Question 1: What are the two AToM interworking modes? (Choose two.)...
Question 2: Which VPN technology is an example of a full-mesh VPN?...
Question 3: Which three Layer 3 VPN technologies are based on the overla...
Question 4: Which option describes what differentiates a U-PE from N-PE?...
Question 5: Implementing H-VPLS instead of VPLS reduces which requiremen...
Question 6: Which service can be used to extend the same broadcast domai...
Question 7: Which Cisco IOS XR BGP configuration command is required to ...
Question 8: Which VPN technology uses the Group Domain of Interpretation...
Question 9: Refer to the exhibit. (Exhibit) What is the AS-PATH list for...
Question 10: Which two Layer 2 VPN methods support interworking between c...
Question 11: What is an advantage of using the Cisco EVC infrastructure t...
Question 12: Select and Place: (Exhibit)
Question 13: Which two statements about implementing a separate MPLS VPN ...
Question 14: Which three possible misconfigurations can occur on the back...
Question 15: Which protocol is used to hide customer VLANs inside the pro...
Question 16: A Cisco IOS XR router is acting as a PE and is running EIGRP...
Question 17: Refer to the exhibit. A customer wants to deploy an IPv6 VPN...
Question 18: Which CE-to-PE routing protocol implements the down bit as a...
Question 19: Which option is used as a loop prevention mechanism to suppo...
Question 20: A network engineer working for a very large financial instit...
Question 21: A presale engineer is asked to advise about the various MPLS...
Question 22: In MPLS Layer 3 VPN implementations, what is used at the PEs...
Question 23: Based on the Cisco IOS XR VRF configuration exhibit, (Exhibi...
Question 24: Which VPN technology allows remote sites with dynamic IP add...
Question 25: Which option represents an AToM pseudowire basic configurati...
Question 26: Which BGP extended community is used to control the distribu...
Question 27: When is it appropriate to activate the VPNv6 address family?...
Question 28: The Cisco IOS XR address-family ipv4 labeled-unicast and the...
Question 29: Which Layer 2 encapsulations can AToM solution support with ...
Question 30: When implementing VPLS on Cisco routers, which data structur...
Question 31: Refer to the exhibit. (Exhibit) XR2 must be configured with ...
Question 32: What is the primary difference between 6PE and 6VPE?...
Question 33: (Exhibit) Which statement is correct regarding the pseudowir...
Question 34: Which technology does an N-PE most likely use to pass traffi...
Question 35: Which two protocols can be used for VPLS signaling on a Cisc...
Question 36: Which two options are disadvantages of MPLS Layer 3 VPNs? (C...
Question 37: When configuring an EoMPLS PW on a Cisco IOS XR router, what...
Question 38: Which statement regarding the Cisco IOS BGP configuration ex...
Question 39: When implementing Layer 3 MPLS VPNs on Cisco IOS/IOS XE PE r...
Question 40: Which option is a valid Cisco IOS XR BGP Layer 3 IPv4 MPLS V...
Question 41: What happens if the destination MAC address is not present i...
Question 42: When implementing MPLS Layer 3 VPNs with customers running O...
Question 43: Which three security features can be implemented on PEs insi...
Question 44: An engineer is deploying L2VPN service between two different...
Question 45: Which method can be used to discover targeted LDP neighbors ...
Question 46: Refer to the exhibit. (Exhibit) PE1 and PE2 are advertising ...
Question 47: (Exhibit) On PE7, what is the pseudowire ID that connects to...
Question 48: Refer to the exhibit. (Exhibit) Given the output shown, whic...
Question 49: In Layer 3 MPLS VPN implementations, which protocol is used ...
Question 50: Refer to the exhibit. (Exhibit) Which two descriptions outli...
Question 51: When verifying Layer 3 MPLS VPN operations, which Cisco IOS ...
Question 52: A Cisco IOS XR device is acting as a PE. It must have an iBG...
Question 53: Which three functions are performed by the PE router in an M...
Question 54: When implementing VPLS on Cisco IOS XR routers, the customer...
Question 55: Which option is the primary purpose of central service MPLS ...
Question 56: When troubleshooting EoMPLS configuration problems, which th...
Question 57: When using H-VPLS, the PE router may use an IRB interface. H...
Question 58: When implementing VPLS on Cisco IOS XR routers, the VPLS PW ...
Question 59: In MPLS Layer 3 VPN implementations, what is used on the PE ...
Question 60: In Layer 3 MPLS VPN implementations, if some of the VPNv4 ro...
Question 61: Which two methods can be used for VPLS PW signaling? (Choose...
Question 62: When implementing EoMPLS PWs, which configuration is optiona...
Question 63: Refer to the partial Cisco IOS XR PE router configuration ex...
Question 64: A company recently completed a third company acquisition and...
Question 65: (Exhibit) On PE7, which encapsulation method is used on the ...
Question 66: A customer is connecting to a Cisco IOS XR PE device via BGP...
Question 67: When implementing EoMPLS on Cisco IOS XR routers, which comm...
Question 68: Which flavor of MPLS Layer 3 VPN has MPLS enabled on PE-CE l...
Question 69: Refer to the Cisco IOS XR router output exhibit, (Exhibit) w...
Question 70: What is required on a Cisco IOS XR router to assign an inter...
Question 71: A customer wants two separated sites to be connected via a p...
Question 72: On Cisco IOS and IOS XE Layer 3 MPLS VPN implementations, wh...
Question 73: Select and Place: (Exhibit)
Question 74: Select and Place: (Exhibit)
Question 75: A service provider wants to scale MAC address advertisements...
Question 76: When using the Cisco EVC software infrastructure, a double-t...
Question 77: What is the purpose of the route distinguisher in a service ...
Question 78: A service provider is tasked to write up a template for the ...
Question 79: (Exhibit) On PE7, how many multiprotocol IBGP routes are lea...
Question 80: A routing entry on a PE router has an ext-hop address of ::f...
Question 81: Refer to the exhibit PE1 and PE2 are advertising the same su...
Question 82: On Cisco IOS XR platforms using the EVC infrastructure, whic...
Question 83: Which method is used to provide inter-AS AToM services?...
Question 84: Which option is the correct command to define an interface a...
Question 85: In which Cisco IOS XR configuration mode is the redistribute...
Question 86: A customer requests Internet through its MPLS provider. Whic...
Question 87: When implementing a Layer 2 transport subinterface on a Cisc...
Question 88: A customer needs Internet and MPLS services from the service...
Question 89: Refer to the partial Cisco IOS XR PE router VRF configuratio...
Question 90: Which organization provides and promotes a standards-based d...
Question 91: Which type of VPN requires a full mesh of virtual circuits t...
Question 92: When implementing nonhierarchical VPLS with eight PE routers...
Question 93: An engineer is configuring VPLS BGP-based autodiscovery on a...
Question 94: Which Layer 2 VPN technology is implemented over an IP core ...
Question 95: When implementing H-VPLS with QinQ access on Cisco Metro Eth...
Question 96: (Exhibit) On PE7, which three statements are correct regardi...
Question 97: Which MP-BGP address family must be configured to use VPLS a...
Question 98: When implementing CSC services, which two methods can be use...
Question 99: When configuring VPLS on the Cisco ASR 9000, which three con...
Question 100: An engineer is configuring an EoMPLS circuit on a Cisco IOS ...
Question 101: Which option is the minimal configuration required inside th...
Question 102: When you are using OSPF as the CE-to-PE routing protocol in ...
Question 103: A network engineer is troubleshooting an MPLS Layer 3 VPN an...
Question 104: In hierarchical VPLS implementations, which two access archi...
Question 105: Which two MPLS QoS models described by RFC3270 are used for ...
Question 106: Within the service provider IP/MPLS core network, what must ...
Question 107: Which three options are features of MPLS Layer 2 VPNs? (Choo...
Question 108: In which configuration mode is a route distinguisher configu...
Question 109: In Layer 3 MPLS VPN implementations, if a customer is using ...