<< Prev Question Next Question >>

Question 27/127

On the Cisco IOS XR, when using the match protocol command within a class-map to classify traffic, you noticed that the match protocol option on the Cisco IOS XR shows much fewer protocol options than on the Cisco IOS or IOS XE, like there is no option such as the match protocol yahoo-messenger command on the Cisco IOS XR. Why is this?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (127q)
Question 1: On a Cisco IOS XR router, which mechanism protects the route...
Question 2: (Exhibit) Refer to the partial Cisco IOS XR configurations e...
Question 3: Which field in the MPLS shim header is used to support diffe...
Question 4: You are tasked to enable LDP on many of the interfaces on th...
Question 5: On Cisco routers, how is hierarchical QoS implemented?...
Question 6: Which three options can an engineer select for a traffic pol...
Question 7: On Cisco routers, which QoS marker is only locally significa...
Question 8: A network operations center analyzes a Wireshark capture and...
Question 9: DS-TE implementations on Cisco routers support which bandwid...
Question 10: An engineer is working in a service provider environment to ...
Question 11: Which three statements are correct regarding ping mpls comma...
Question 12: Which two traffic types are recognized by NBAR default confi...
Question 13: What is the term that is used for the label that an LSR assi...
Question 14: Which three network services can be implemented using MPLS w...
Question 15: Which item is not available to be used for QoS classificatio...
Question 16: Which three conditions can occur when metering traffic using...
Question 17: When implementing MPLS TE tunnels on Cisco IOS XR routers, w...
Question 18: Which Cisco IOS XR command should be used in order to enable...
Question 19: Which option is the appropriate method for CBWFQ WRED implem...
Question 20: Layer 2 VPN services that are offered by traditional service...
Question 21: A service provider recently defined new SLA services that pr...
Question 22: Which three mechanisms are used to implement MPLS TE? (Choos...
Question 23: When a link flaps, an mpls ldp session will also flap. Which...
Question 24: The network architecture team is proposing to enable Cisco M...
Question 25: When defining an explicit MPLS TE tunnel path, which two com...
Question 26: An LDP session is established between two neighbors. Over wh...
Question 27: On the Cisco IOS XR, when using the match protocol command w...
Question 28: Which affinity value will be matched by the affinity bit mas...
Question 29: How many labels does an MPLS packet have, with a bottom-of-s...
Question 30: (Exhibit) Referring to the Cisco IOS XR show command output ...
Question 31: What is the correct formula for determining the CIR?...
Question 32: An engineer is setting up a routing instance to route the tr...
Question 33: Scenario: (Exhibit) On CE7 which statement is correct regard...
Question 34: (Exhibit) Refer to the exhibit. Which configuration error pr...
Question 35: Scenario: (Exhibit) On P2IOS-XR router what is targeted LDP ...
Question 36: Which two statements are correct in describing ISP environme...
Question 37: Within the service provider core network, which two QoS mech...
Question 38: Which QoS technique can be used to protect customer traffic ...
Question 39: Which three statements are correct regarding a Cisco MPLS TE...
Question 40: (Exhibit) Refer to the Cisco IOS XR policy-map configuration...
Question 41: Which option is a Cisco-recommended congestion management or...
Question 42: Given this configuration of an interface for MPLS traffic en...
Question 43: Cisco MPLS TE tunnels recently have been deployed to minimiz...
Question 44: Which statement describes the QoS behavior between P and PE ...
Question 45: An engineer wants to extend the trust boundary to a Cisco IP...
Question 46: Which four options are methods by which labels can be assign...
Question 47: In Cisco MPLS TE implementations, what can cause the tunnel ...
Question 48: (Exhibit) Referring to the Cisco IOS XR configuration exhibi...
Question 49: Which configuration fulfills the requirement of configuring ...
Question 50: (Exhibit) Refer to the exhibit. From which table was the inf...
Question 51: Which three commands are used to troubleshoot why IP packets...
Question 52: On the Cisco ASR9K router, when using the bandwidth command ...
Question 53: A network engineer must analyze RSVP-TE signaling on a syslo...
Question 54: Select and Place: (Exhibit)
Question 55: (Exhibit) Referring to the traceroute output exhibit that is...
Question 56: (Exhibit) Refer to the exhibit. XR2 needs to have LDP config...
Question 57: (Exhibit) Only based on the Cisco IOS XR policy-map configur...
Question 58: Scenario: (Exhibit) On CE 7 router, which statement is corre...
Question 59: Scenario: (Exhibit) After reviewing present router configura...
Question 60: In which two Cisco IOS XR configuration modes can mpls ldp i...
Question 61: Which Cisco IOS XR command should be used in order to enable...
Question 62: An engineer must automatically copy the IP Prec/DiffServ PHB...
Question 63: An engineer has been tasked to configure a guaranteed 10 Mbp...
Question 64: Which option describes what happens when a labelled packet w...
Question 65: Which two considerations are important when implementing a C...
Question 66: Which Cisco IOS XR high-availability feature is used to prev...
Question 67: Which two characteristics describe the difference between MP...
Question 68: When troubleshooting LDP operations on the Cisco IOS and IOS...
Question 69: When configuring class-based WRED on Cisco routers, which WR...
Question 70: Which are typical class-based marking policies that are impl...
Question 71: Which three steps are required to configure QPPB on Cisco IO...
Question 72: What are the four fields inside the MPLS shim header? (Choos...
Question 73: Which protocol is used to send MPLS OAM traffic over an MPLS...
Question 74: Which method is used to mark traffic matched by class-map MY...
Question 75: Which option is the appropriate way to configure a color-awa...
Question 76: Which two fields are in the traffic engineering topology dat...
Question 77: Cisco MPLS TE path setup can be affected by which three tunn...
Question 78: Select and Place: (Exhibit)
Question 79: Which four options describe the functions of the control wor...
Question 80: Which three options are class maps able to match? (Choose th...
Question 81: LDP session protection uses which one to maintain the LDP se...
Question 82: Which four pieces of information are stored for each prefix ...
Question 83: Select and Place: (Exhibit)
Question 84: A DSCP value of 41 in decimal corresponds to which IP preced...
Question 85: Scenario: (Exhibit) From the PE8 router, how many total pref...
Question 86: An engineer is allocating a determined amount of bandwidth t...
Question 87: According to the Intserv model, which two options are traffi...
Question 88: A network operations center requests support to configure a ...
Question 89: Scenario: (Exhibit) On the PE8-router what is the label valu...
Question 90: Select and Place: (Exhibit)
Question 91: Which QoS mechanism is used for congestion avoidance?...
Question 92: Scenario: (Exhibit) On PE7 which statement is correct regard...
Question 93: The Cisco IOS and IOS XE qos pre-classify command allows whi...
Question 94: Which Cisco IOS XR command should be used to identify if MPL...
Question 95: A network engineer must make a reservable maximum bandwidth ...
Question 96: On the Cisco IOS XR, which MQC configuration is different th...
Question 97: When using the tunnel mpls traffic-eng path-option 1 explici...
Question 98: On Cisco routers, which three methods can be used to map tra...
Question 99: In an IPv6 header, what does a flow label of zero indicate?...
Question 100: A network engineer must design a core network routing domain...
Question 101: Which two of the following statements are correct regarding ...
Question 102: Select and Place: (Exhibit)
Question 103: (Exhibit) Refer to the exhibit. Based on the raw format of a...
Question 104: An engineer has been tasked to configure a guaranteed 2 Mbps...
Question 105: (Exhibit) Referring to the show output exhibit, which statem...
Question 106: With unmanaged CE routers, at which point in the service pro...
Question 107: When implementing Cisco MPLS TE, the constrained-based path ...
Question 108: Select and Place: (Exhibit)
Question 109: Cisco MPLS TE resource attributes that are configured locall...
Question 110: (Exhibit) Referring to the Cisco IOS XR show command output ...
Question 111: When implementing CBWFQ, where should Weighted Random Early ...
Question 112: What is an important requirement with MPLS applications like...
Question 113: Which two features are used to provide Cisco MPLS TE node an...
Question 114: The Cisco IOS and IOS XE qos pre-classify command allows whi...
Question 115: Which statement is correct regarding the default MPLS TTL be...
Question 116: When implementing MPLS DS-TE on Cisco IOS XR routers, all ag...
Question 117: Which two network devices are trusted endpoints in a network...
Question 118: The regional operation center deploys a Cisco MPLS TE tunnel...
Question 119: On a Cisco router, when will the router actually reserve the...
Question 120: A company asks an engineer to provide an explanation for imp...
Question 121: Implementing IPoDWDM interfaces on Cisco CRS routers elimina...
Question 122: When configuring LLQ (strict priority queue) on a traffic cl...
Question 123: An engineer is tasked to deploy Fast Reroute for Cisco MPLS ...
Question 124: Which method maps MPLS EXP bit 5 to COS 5 on Cisco IOS XE?...
Question 125: Which configuration can a network engineer use to establish ...
Question 126: Refer to the Cisco IOS XR configuration exhibit. (Exhibit) W...
Question 127: Which three fields must be the same in an IPv6 header to con...