<< Prev Question Next Question >>

Question 19/100

An LDP session is established between two neighbors. Over which protocol and port number do they maintain their adjacency?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (100q)
Question 1: Which two interface types can support qos pre-classify (Choo...
Question 2: Which three conditions can occur when metering traffic using...
Question 3: Refer to the exhibit. (Exhibit) What is the available reserv...
Question 4: Which are typical class-based marking policies that are impl...
Question 5: Refer to the exhibit. (Exhibit) IT administrators report pac...
Question 6: A recent analysis of a service provider network infrastructu...
Question 7: Which IOS XR Software feature supports establishing point-to...
Question 8: Which Cisco IOS XR command should be used to identify if MPL...
Question 9: Refer to the exhibit. From which table was the information o...
Question 10: Which QoS technique can be used to protect customer traffic ...
Question 11: The network architecture team is proposing to enable Cisco M...
Question 12: Scenario: (Exhibit) On PE7 which statement is correct regard...
Question 13: Which two options are able to perform the MPLS label distrib...
Question 14: Which four options are methods by which labels can be assign...
Question 15: Referring to the Cisco IOS XR show command output exhibit, (...
Question 16: A network engineer must design a core network routing domain...
Question 17: How is bandwidth recalculated when utilizing the automatic b...
Question 18: Which feature should you configure to enable routers to main...
Question 19: An LDP session is established between two neighbors. Over wh...
Question 20: An engineer is having a problem getting an operational 10 Gi...
Question 21: Within the service provider core network, which two QoS mech...
Question 22: Scenario: (Exhibit) On the PE8-router what is the label valu...
Question 23: What is a crucial LDP default operating behavior?...
Question 24: Refer to the exhibit. (Exhibit) Which two commands can be us...
Question 25: Which protocol is used to send MPLS OAM traffic over an MPLS...
Question 26: Which configuration fulfills the requirement of configuring ...
Question 27: Which affinity value will be matched by the affinity bit mas...
Question 28: When implementing MPLS DS-TE on Cisco IOS XR routers, all ag...
Question 29: When troubleshooting LDP operations on the Cisco IOS and IOS...
Question 30: When using the tunnel mpls traffic-eng path-option 1 explici...
Question 31: At which layer does Cisco recommend the QoS trust boundary b...
Question 32: An engineer is setting up a routing instance to route the tr...
Question 33: Which option describes the IPv6 flow label field?...
Question 34: Scenario: (Exhibit) On CE 7 router, which statement is corre...
Question 35: According to the Intserv model, which two options are traffi...
Question 36: Refer to the Cisco IOS XR configuration exhibit. (Exhibit) W...
Question 37: What is an important requirement with MPLS applications like...
Question 38: What is the term that is used for the label that an LSR assi...
Question 39: Which option is the appropriate way to configure a color-awa...
Question 40: A company asks an engineer to provide an explanation for imp...
Question 41: Referring to the show output exhibit, which statement is cor...
Question 42: Which two features are used to provide Cisco MPLS TE node an...
Question 43: Which two traffic types are recognized by NBAR default confi...
Question 44: Which class-map configuration selects the following traffic?...
Question 45: An engineer has been tasked to configure a guaranteed 2 Mbps...
Question 46: An engineer is tasked to deploy Fast Reroute for Cisco MPLS ...
Question 47: DRAG DROP (Exhibit)
Question 48: In an IPv6 header, what does a flow label of zero indicate?...
Question 49: Which configuration can a network engineer use to establish ...
Question 50: When implementing MPLS TE tunnels on Cisco IOS XR routers, w...
Question 51: A network architect recently deployed AToM solutions for lar...
Question 52: Scenario: (Exhibit) After reviewing present router configura...
Question 53: Which driver uses an IntServ QoS model in an MPLS TE enabled...
Question 54: Which option is the correct definition of the LB on a Cisco ...
Question 55: Which three statements are correct regarding ping mpls comma...
Question 56: Refer to the exhibit. (Exhibit) MPLS TE Tunnel 138 has a hea...
Question 57: Which option is a Cisco-recommended congestion management or...
Question 58: Cisco MPLS TE tunnels recently have been deployed to minimiz...
Question 59: Which two fields are in the traffic engineering topology dat...
Question 60: Which statement describes the QoS behavior between P and PE ...
Question 61: Which three fields must be the same in an IPv6 header to con...
Question 62: An engineer is deploying CB-WRED across the entire core netw...
Question 63: With unmanaged CE routers, at which point in the service pro...
Question 64: What is the function of MPLS FRR?...
Question 65: Which two protocols facilitate label bindings by neighboring...
Question 66: When a link flaps, an mpls ldp session will also flap. Which...
Question 67: The Cisco IOS and IOS XE qos pre-classify command allows whi...
Question 68: An engineer must automatically copy the IP Prec/DiffServ PHB...
Question 69: When configuring class-based WRED on Cisco routers, which WR...
Question 70: Which of the following three statements are correct regardin...
Question 71: An engineer is allocating a determined amount of bandwidth t...
Question 72: On Cisco routers, which QoS marker is only locally significa...
Question 73: Which four options describe the functions of the control wor...
Question 74: Refer to the partial Cisco IOS XR configurations exhibit for...
Question 75: On a Cisco IOS XR router, which mechanism protects the route...
Question 76: On the Cisco IOS XR, which MQC configuration is different th...
Question 77: In which two Cisco IOS XR configuration modes can mpls ldp i...
Question 78: An engineer sets up QoS over MPLS networks. How many classes...
Question 79: Which three options can an engineer select for a traffic pol...
Question 80: Refer to the exhibit. Which configuration error prevents thi...
Question 81: Which option describes the function of an IPv6 flow label?...
Question 82: An engineer must configure a policy on a Cisco IOS XE router...
Question 83: Which option is the appropriate method for CBWFQ WRED implem...
Question 84: In Cisco IOS, what must be configured to ensure that an MPLS...
Question 85: Which two values must be specified in a Cisco NBAR configura...
Question 86: Refer to the exhibit. What happens to the traffic that excee...
Question 87: DRAG DROP You create an MPLS TE tunnel in IOS XR Software an...
Question 88: An engineer has been tasked to configure a guaranteed 10 Mbp...
Question 89: Referring to the Cisco IOS XR configuration exhibit, (Exhibi...
Question 90: An engineer deployed a Cisco MPLS TE next-hop protection ove...
Question 91: DRAG DROP (Exhibit)
Question 92: On Cisco routers, which three methods can be used to map tra...
Question 93: LDP session protection uses which one to maintain the LDP se...
Question 94: Refer to the Cisco IOS XR policy-map configuration exhibit. ...
Question 95: Layer 2 VPN services that are offered by traditional service...
Question 96: Refer to the exhibit. (Exhibit) Based on the raw format of a...
Question 97: In Cisco MPLS TE implementations, what can cause the tunnel ...
Question 98: Which Cisco IOS XR high-availability feature is used to prev...
Question 99: Refer to the exhibit. (Exhibit) While configuring traffic sh...
Question 100: Which four pieces of information are stored for each prefix ...