<< Prev Question Next Question >>

Question 48/85

Which statement is correct regarding MP-BGP?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (85q)
Question 1: With PIM-SM operations, which four pieces of information are...
Question 2: Which three statements regarding NAT64 operations are correc...
Question 3: When implementing high-availability stateful switchover BGP ...
Question 4: Refer to the Cisco IOS-XR BGP configuration exhibit. (Exhibi...
Question 5: (Exhibit) Which router Is configured as the RPforthe 234.1.1...
Question 6: Which multicast routing protocol is most optimal for support...
Question 7: The IPv6 2002::/16 prefix is used in which kind of implement...
Question 8: Which mechanism is used by an IPv6 multicast receiver to joi...
Question 9: Which two features are used to provide high availability mul...
Question 10: In Cisco IOS-XR, the maximum-prefix command, to control the ...
Question 11: (Exhibit) Which two statements are correct regarding the mul...
Question 12: Refer to the Cisco IOS DHCPv6 configuration shown in the exh...
Question 13: Refer to the exhibit for the outputs from an ASR9K router. (...
Question 14: Which four statements are correct regarding MSDP configurati...
Question 15: When configuring PIM operations, what is the effect of setti...
Question 16: The 224.192.16.1 multicast IP address maps to which multicas...
Question 17: Which multicast group range is reserved for SSM?...
Question 18: Refer to the configuration exhibit, taken from a Cisco IOS-X...
Question 19: Which two statements regarding Auto RP operations and implem...
Question 20: Which two statements correctly describe the RPF check when a...
Question 21: When implementing source-based remote-triggered black hole f...
Question 22: With IPv6 multicast, which feature can be used as a replacem...
Question 23: The following Cisco IOS-XR configuration command will global...
Question 24: (Exhibit) On the PE, which two statements are correct regard...
Question 25: (Exhibit) Which two statements regarding the BGP peerlngs ar...
Question 26: When enabling interdomain multicast routing, which two state...
Question 27: What is enabled by default on Cisco IOS-XR routers and canno...
Question 28: Which of the following can be used by dual-stack service pro...
Question 29: The bsr-border router PIM interface configuration command is...
Question 30: When verifying multicast configurations and operations on Ci...
Question 31: When enabling interdomain multicast routing, which two state...
Question 32: What are three BGP configuration characteristics of a multih...
Question 33: Which types of multicast distribution tree can PIM-SM use?...
Question 34: Which two BGP mechanisms are used to prevent routing loops w...
Question 35: Refer to the exhibit. (Exhibit) The following multicast IP a...
Question 36: What is determined by running the same hash algorithm on all...
Question 37: Which multicast routing protocol supports dense mode, sparse...
Question 38: Refer to the exhibit. (Exhibit) Which three statements are c...
Question 39: You noticed a recent change to the BGP configuration on a PE...
Question 40: What is determined by running the same hash algorithm on all...
Question 41: Which of the following is a feature added in IGMPv3?...
Question 42: Refer to the EBGP configuration on a PE IOS-XR router exhibi...
Question 43: Which multicast routing protocol supports dense mode, sparse...
Question 44: Refer to the Cisco IOS-XR show output exhibit. (Exhibit) Whi...
Question 45: What must occur before an (S,G) entry can be populated in th...
Question 46: Refer to the Cisco IOS-XR configuration exhibit. (Exhibit) T...
Question 47: (Exhibit) On the PE5 router, which statement Is correct rega...
Question 48: Which statement is correct regarding MP-BGP?...
Question 49: A junior network engineer has just configured a new IBGP pee...
Question 50: When implementing interdomain multicast routing, which mecha...
Question 51: When configuring BFD, the multiplier configuration option is...
Question 52: Given the IPv6 address of 2001:0DB8::1:800:200E:88AA, what w...
Question 53: Which type of BGP session behaves like an EBGP session durin...
Question 54: In Cisco IOS-XR, the ttl-security command is configured unde...
Question 55: Refer to the EBGP configuration on a PE IOS-XR router exhibi...
Question 56: When a BGP route reflector receives an IBGP update from a no...
Question 57: Refer to the Cisco IOS configuration exhibit. (Exhibit) Whic...
Question 58: Which type of DNS record is used for IPv6 forward lookups?...
Question 59: Referring to the topology diagram show in the exhibit, (Exhi...
Question 60: Assume that the R1 router is enabled for PIM-SM and receives...
Question 61: Which statement is correct regarding using the TTL threshold...
Question 62: What is one of the configuration errors within an AS that ca...
Question 63: (Exhibit) Which three statements are correct regarding the v...
Question 64: When implementing Anycast RP, the RPs are also required to e...
Question 65: Which field in the IPv6 header can be used to set the DSCP v...
Question 66: (Exhibit) Which three statements regarding the BGP operation...
Question 67: Which two statements correctly describe the BGP ttl-security...
Question 68: Which type of BGP session behaves like an EBGP session durin...
Question 69: When implementing source-based remote-triggered black hole f...
Question 70: Which three statements are correct regarding PIM-SM? (Choose...
Question 71: Which statement is correct regarding using the TTL threshold...
Question 72: (Exhibit) Which two statements regarding the BGP peerlngs ar...
Question 73: Refer to the topology diagram shown in the exhibit and the p...
Question 74: Refer to the Cisco IOS-XR show output exhibit. (Exhibit) Whi...
Question 75: Refer to the exhibit. (Exhibit) Given the partial BGP config...
Question 76: On Cisco IOS-XR, which BGP configuration group allows you to...
Question 77: Which additional feature is provided using MLDv2 that is not...
Question 78: With PIM-SM operations, which four pieces of information are...
Question 79: On Cisco IOS-XR, which BGP process can be distributed into m...
Question 80: Refer to the exhibit. (Exhibit) Which configuration is missi...
Question 81: Refer to the exhibit. (Exhibit) Which statement correctly ex...
Question 82: (Exhibit) Which three statements regarding the BGP operation...
Question 83: After configuring the tunnel interface as shown in the exhib...
Question 84: Which three methods can be used to reduce the full-mesh IBGP...
Question 85: When implementing IP SLA icmp-echo probes on Cisco IOS-XE ro...