<< Prev Question Next Question >>

Question 79/114

Your switch network has been configured to support multiple VLANs. In order for the users on one VLAN to communicate with users on another VLAN, which additional configuration is required?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (114q)
Question 1: What are two legitimate IPv4 to IPv6 migration technologies?...
Question 2: When configuring a new VLAN on Cisco IOS switches, which con...
Question 3: Refer to the Cisco IOS XR configuration exhibit. (Exhibit) W...
Question 4: What platform is best placed as the edge device within the C...
Question 5: A customer has installed a second router and copied the conf...
Question 6: When is a route-policy configuration needed on a Cisco IOS X...
Question 7: The permit 172.16.32.0 0.0.15.255 access-list entry permits ...
Question 8: Refer to the show command exhibit. (Exhibit) Which statement...
Question 9: What is dual IOS mode on the Cisco ASR 1001 Router?...
Question 10: What do both Carrier Grade NAT and NAT64 have in common?...
Question 11: Which IPv6 address block is reserved for 6to4 tunneling?...
Question 12: After configuring Q-in-Q on a new interface, the customer ha...
Question 13: Which three statements about access control lists on a Cisco...
Question 14: A service provider needs to implement a managed CE device th...
Question 15: Which two statements about NAT444 are true? (Choose two.)...
Question 16: Which four statements about REP configurations on a Cisco ME...
Question 17: When upgrading a Cisco ASR 1001 Router, when is the request ...
Question 18: Refer to the exhibit. (Exhibit) A network engineer implement...
Question 19: Which two statements about carrier-grade NAT are true? (Choo...
Question 20: HOTSPOT (Exhibit) Hot Area: (Exhibit)...
Question 21: On Cisco IOS XR software, which set of commands enables OSPF...
Question 22: On Cisco IOS-XR, which command is used to review previous co...
Question 23: On the Cisco ME 3400 switch, spanning tree is enabled by def...
Question 24: Which of the following commands would be used to prevent a s...
Question 25: Which statement is true about enabling IS-IS routing and usi...
Question 26: Which three statements about OSPFv2 or OSPFv3 authentication...
Question 27: Refer to the partial Cisco IOS router configuration exhibit....
Question 28: Which two commands are required to configure an access port ...
Question 29: What type of package is bootable on the Cisco ASR 1000 route...
Question 30: When configuring an ACL entry, which network and wildcard ma...
Question 31: Refer to the exhibit. (Exhibit) A new customer is not receiv...
Question 32: A network engineer is trying to determine the mac address of...
Question 33: Which first-hop router redundancy protocol uses the active v...
Question 34: Refer to the partial Cisco IOS-XR configuration. What is the...
Question 35: Which two statements about NAT64 are true? (Choose two.)...
Question 36: Within an MPLS domain, which table is used by the label swit...
Question 37: HOTSPOT (Exhibit) Hot Area: (Exhibit)...
Question 38: DRAG DROP Select and Place: (Exhibit)...
Question 39: Which type of service provider is responsible for offering b...
Question 40: Cisco IP NGN service providers can offer multiple services t...
Question 41: DRAG DROP Topology Diagram: (Exhibit) Select and Place: (Exh...
Question 42: Which Cisco router platform supports running either the Cisc...
Question 43: Refer to the exhibit. (Exhibit) Which three statements about...
Question 44: A VLAN is a logical grouping of switch ports that belong to ...
Question 45: On Cisco IOS XR software, what are the four valid address-fa...
Question 46: CORRECT TEXT (Exhibit)
Question 47: Refer to the Cisco IOS XR commands exhibit. (Exhibit) The ro...
Question 48: What layer of the IP NGN Model does the Customer Element and...
Question 49: Which statement about the benefits of MPLS PHP is true?...
Question 50: Refer to the partial Cisco IOS router configuration exhibit....
Question 51: What is the foundation architecture of Cisco Next Generation...
Question 52: HOTSPOT (Exhibit) Hot Area: (Exhibit)...
Question 53: Refer to the exhibit. (Exhibit) Which statement is true?...
Question 54: Which three are examples of a link-state routing protocols a...
Question 55: On Cisco IOS XR software, how is LDP enabled on an interface...
Question 56: Which three statements about service provider network requir...
Question 57: Which two statements about the BGP weight attribute on Cisco...
Question 58: What three statements about REP configurations on a Cisco ME...
Question 59: Which three are common ISP access network technologies? (Cho...
Question 60: Which statement about Cisco IOS XE software is true?...
Question 61: What does the command 'rep admin vlan 100' accomplish?...
Question 62: Refer to the exhibit. (Exhibit) A network engineer configure...
Question 63: Which three Cisco platforms are classified as core routers? ...
Question 64: Which segment protocol provides fast and predictable converg...
Question 65: DRAG DROP Select and Place: (Exhibit)...
Question 66: Within an MPLS domain, which table is used by the ingress ed...
Question 67: Refer to the configuration output below. OSPFv2 is already c...
Question 68: On Cisco IOS XR software, which set of commands enables OSPF...
Question 69: DRAG DROP Select and Place: (Exhibit)...
Question 70: Refer to the configuration snippet below. A new IOS-XR route...
Question 71: Which command configures a switchport to connect only a host...
Question 72: Refer to the exhibit. (Exhibit) The access list has been con...
Question 73: You have just enabled IS-IS on the lab testing network. You ...
Question 74: What command will install the image needed on the Cisco IOS-...
Question 75: Which IP addresses are matched by the permit 192.168.80.64 0...
Question 76: Which file extension indicates a bootable installation file ...
Question 77: ISPs use which protocol to establish peering sessions in an ...
Question 78: Which Cisco IOS access list permits HTTP traffic that is sou...
Question 79: Your switch network has been configured to support multiple ...
Question 80: DRAG DROP Select and Place: (Exhibit)...
Question 81: Which number range is allocated to private Autonomous System...
Question 82: You have installed a new router and configured OSPF on it. H...
Question 83: Which BGP attribute is also used for loop prevention?...
Question 84: Which spanning-tree mode can be used to map several VLANs to...
Question 85: Which commands will configure the spanning tree operating mo...
Question 86: What are three common problems related to sessions not estab...
Question 87: Which two protocols are most often deployed in Cisco IP NGN ...
Question 88: Refer to the exhibit. (Exhibit) What additional configuratio...
Question 89: Refer to the topology diagram in the exhibit. (Exhibit) Whic...
Question 90: Which three are correct statements based on the BGP configur...
Question 91: During the BGP route selection process on Cisco routers, whi...
Question 92: Which IOS Software solution is used for transporting RFC 191...
Question 93: On Cisco IOS XR software, which two of the address-family co...
Question 94: Which three statements about VLAN implementation in a Layer ...
Question 95: What package provides the software for the route processor i...
Question 96: A company begins offering SIP and PRI trunks to customers. W...
Question 97: DRAG DROP Select and Place: (Exhibit)...
Question 98: HOTSPOT (Exhibit) Hot Area: (Exhibit)...
Question 99: Refer to the partial Cisco IOS XR BGP configuration exhibit....
Question 100: Refer to the partial configurations exhibit. (Exhibit) What ...
Question 101: A customer has created a new VLAN for the subnet that was al...
Question 102: Which configuration error within an AS can cause a Cisco IOS...
Question 103: DRAG DROP Select and Place: (Exhibit)...
Question 104: DRAG DROP Select and Place: (Exhibit)...
Question 105: Refer to the configuration example exhibit. (Exhibit) Which ...
Question 106: You want to configure HSRP between a Cisco IOS and a Cisco I...
Question 107: On Cisco routers, the address-family configuration command i...
Question 108: Which spanning-tree mode uses the name command to configure ...
Question 109: What feature of the Cisco ASR series enables service provide...
Question 110: You are enabling OSPF on a router and notice that all the Fa...
Question 111: DRAG DROP Topology: (Exhibit) Select and Place: (Exhibit)...
Question 112: Which two statements about the link state routing process ar...
Question 113: Refer to the two show output examples below. The switch with...
Question 114: What is the advantage of running IOS-XE individual consolida...