<< Prev Question Next Question >>

Question 46/109

After configuring Q-in-Q on a new interface, the customer has requested that the IOS version and remote model also be viewable via the trunk. What additional command would need to be applied to both sides of the Q-in-Q trunk?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (109q)
Question 1: Which three are common ISP access network technologies? (Cho...
Question 2: What is dual IOS mode on the Cisco ASR 1001 Router?...
Question 3: Which three are correct statements based on the BGP configur...
Question 4: When configuring a new VLAN on Cisco IOS switches, which con...
Question 5: On Cisco IOS XR software, what is the default commit option?...
Question 6: On Cisco IOS-XR, which command is used to review previous co...
Question 7: Your switch network has been configured to support multiple ...
Question 8: Within an MPLS domain, which table is used by the label swit...
Question 9: You have just enabled IS-IS on the lab testing network. You ...
Question 10: Which spanning-tree mode can be used to map several VLANs to...
Question 11: Select and Place: (Exhibit)
Question 12: Which two statements about carrier-grade NAT are true? (Choo...
Question 13: Which two statements about the BGP weight attribute on Cisco...
Question 14: A network engineer is trying to determine the mac address of...
Question 15: On Cisco IOS XR software, what are the four valid address-fa...
Question 16: Select and Place: (Exhibit)
Question 17: Select and Place: (Exhibit)
Question 18: Topology: (Exhibit) Select and Place: (Exhibit)...
Question 19: On Cisco IOS XR software, how is LDP enabled on an interface...
Question 20: Which Cisco IOS access list permits HTTP traffic that is sou...
Question 21: You want to configure HSRP between a Cisco IOS and a Cisco I...
Question 22: On the Cisco ME 3400 switch, spanning tree is enabled by def...
Question 23: Which three Cisco platforms are classified as core routers? ...
Question 24: Which Cisco platform runs the Cisco IOS XE operating system?...
Question 25: A customer has created a new VLAN for the subnet that was al...
Question 26: Which configuration error within an AS can cause a Cisco IOS...
Question 27: Select and Place: (Exhibit)
Question 28: When upgrading a Cisco ASR 1001 Router, when is the request ...
Question 29: Which three statements about access control lists on a Cisco...
Question 30: A service provider needs to implement a managed CE device th...
Question 31: Refer to the partial configurations exhibit. Real 23 Cisco 6...
Question 32: Which BGP attribute is also used for loop prevention?...
Question 33: What type of package is bootable on the Cisco ASR 1000 route...
Question 34: Refer to the topology diagram in the exhibit. (Exhibit) Whic...
Question 35: Which three are examples of a link-state routing protocols a...
Question 36: Real 47 Cisco 640-878 Exam Which three statements about VLAN...
Question 37: (Exhibit) Hot Area: (Exhibit)
Question 38: Real 91 Cisco 640-878 Exam What are two legitimate IPv4 to I...
Question 39: ISPs use which protocol to establish peering sessions in an ...
Question 40: Which two statements about NAT444 are true? (Choose two.)...
Question 41: A network administrator is troubleshooting an issue whereupo...
Question 42: What command will install the image needed on the Cisco IOS-...
Question 43: Refer to the show command exhibit. Real 32 Cisco 640-878 Exa...
Question 44: Which statement about the benefits of MPLS PHP is true? Real...
Question 45: Refer to the exhibit. (Exhibit) The access list has been con...
Question 46: After configuring Q-in-Q on a new interface, the customer ha...
Question 47: Refer to the partial Cisco IOS XR BGP configuration exhibit....
Question 48: When is a route-policy configuration needed on a Cisco IOS X...
Question 49: Which Cisco IOS-XR command is used to unpack a package on th...
Question 50: You are enabling OSPF on a router and notice that all the Fa...
Question 51: (Exhibit) Hot Area: (Exhibit)
Question 52: Which three statements about service provider network requir...
Question 53: Select and Place: (Exhibit)
Question 54: On Cisco IOS XR software, which set of commands enables OSPF...
Question 55: On Cisco IOS XR software, which set of commands enables OSPF...
Question 56: What layer of the IP NGN Model does the Customer Element and...
Question 57: Which IPv6 address block is reserved for 6to4 tunneling?...
Question 58: What package provides the software for the route processor i...
Question 59: When configuring an ACL entry, which network and wildcard ma...
Question 60: On Cisco routers, the address-family configuration command i...
Question 61: What is a requirement for performing Cisco IOS ISSU on the C...
Question 62: Which two commands are required to configure an access port ...
Question 63: The permit 172.16.32.0 0.0.15.255 access-list entry permits ...
Question 64: Refer to the partial Cisco IOS router configuration exhibit....
Question 65: Which commands will configure the spanning tree operating mo...
Question 66: Select and Place: (Exhibit)
Question 67: Refer to the exhibit. (Exhibit) The access list has been con...
Question 68: Which type of service provider is responsible for offering b...
Question 69: Refer to the configuration snippet below. A new IOS-XR route...
Question 70: What do both Carrier Grade NAT and NAT64 have in common? Rea...
Question 71: Refer to the exhibit. (Exhibit) A new customer is not receiv...
Question 72: What three statements about REP configurations on a Cisco ME...
Question 73: On Cisco IOS XR software, which two of the address-family co...
Question 74: Which two statements about NAT64 are true? (Choose two.) Rea...
Question 75: What are three common problems related to sessions not estab...
Question 76: Select and Place: (Exhibit)
Question 77: Which of the following commands would be used to prevent a s...
Question 78: What is the foundation architecture of Cisco Next Generation...
Question 79: Refer to the partial Cisco IOS-XR configuration. What is the...
Question 80: Which statement is true about enabling IS-IS routing and usi...
Question 81: Which command configures a switchport to connect only a host...
Question 82: During the BGP route selection process on Cisco routers, whi...
Question 83: Refer to the configuration snippet below. A network engineer...
Question 84: A company begins offering SIP and PRI trunks to customers. W...
Question 85: You have installed a new router and configured OSPF on it. H...
Question 86: (Exhibit) Hot Area: (Exhibit)
Question 87: Which procedure is used as the last resort disaster recovery...
Question 88: Refer to the exhibit. (Exhibit) A network engineer implement...
Question 89: Which Cisco router platform supports running either the Cisc...
Question 90: Refer to the configuration output below. OSPFv2 is already c...
Question 91: (Exhibit) Hot Area: (Exhibit)
Question 92: Within an MPLS domain, which table is used by the ingress ed...
Question 93: What is the advantage of running IOS-XE individual consolida...
Question 94: Which four statements about REP configurations on a Cisco ME...
Question 95: Which two statements about the link state routing process ar...
Question 96: Which two protocols are most often deployed in Cisco IP NGN ...
Question 97: Refer to the configuration example exhibit. Real 48 Cisco 64...
Question 98: Refer to the partial Cisco IOS router configuration exhibit....
Question 99: Which statement about Cisco IOS XE software is true?...
Question 100: What feature of the Cisco ASR series enables service provide...
Question 101: Real 83 Cisco 640-878 Exam A customer has been allocated a n...
Question 102: Which number range is allocated to private Autonomous System...
Question 103: Which first-hop router redundancy protocol uses the active v...
Question 104: Which IP addresses are matched by the permit 192.168.80.64 0...
Question 105: Refer to the Cisco IOS XR commands exhibit. (Exhibit) The ro...
Question 106: Which segment protocol provides fast and predictable converg...
Question 107: Which three statements about OSPFv2 or OSPFv3 authentication...
Question 108: (Exhibit)
Question 109: Refer to the exhibit. (Exhibit) Which statement is true?...