<< Prev Question Next Question >>

Question 52/78

This show output is from the S7 Cisco Metro Switch and the PE7 Cisco ASR 9000 Series Router. Which configuration change(s) is/are needed to bring the S7 FastEthernet 0/2 interface into the up/up state?
S7#show cdp neighbors
<OUTPUT OMITTED>
Device ID Local Intrfce Holdtme Capability Platform Port ID PE7 Fas 0/2 163 R ASR9K Ser Gig 0/0/0/0 S78 Fas 0/23 146 S I ME-3400E- Fas 0/21
S8 Fas 0/21 178 S I ME-3400E- Fas 0/21
*Mar 20 21:28:02.177: %ETHCNTR-3-HALF_DUX_COLLISION_EXCEED_THRESHOLD:
Collisions at FastEthernet0/2 exceed threshold. Considered as loop-back. *Mar 20 21:28:02.177: %PM-4- ERR_DISABLE: loopback error detected on Fa0/2, putting Fa0/2 in err-disable state
*Mar 20 21:28:03.184: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/2, changed state to down
S7#show interface fa0/2
FastEthernet0/2 is down, line protocol is down (err-disabled) Hardware is Fast Ethernet, address is e8ba.70b5.6c04 (bia e8ba.70b5.6c04) MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Half-duplex, 10Mb/s, media type is 10/100BaseTX
input flow-control is off, output flow-control is unsupported ARP type: ARPA, ARP Timeout 04:00:00 Last input 00:00:40, output 00:00:00, output hang never Last clearing of "show interface" counters never Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: fifo Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
484423 packets input, 39349929 bytes, 0 no buffer
Received 484423 broadcasts (167203 multicasts)
0 runts, 0 giants, 0 throttles
1 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 0 watchdog, 167203 multicast, 0 pause input
0 input packets with dribble condition detected
972398 packets output, 128931949 bytes, 0 underruns
0 output errors, 46 collisions, 4 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
RP/0/RSP0/CPU0:PE7#show interfaces gi0/0/0/0
GigabitEthernet0/0/0/0 is down, line protocol is down Interface state transitions: 4 Hardware is GigabitEthernet, address is 4055.392f.40a8 (bia 4055.392f.40a8) Internet address is
192.168.107.70/24
MTU 1514 bytes, BW 100000 Kbit (Max: 100000 Kbit)
reliability 255/255, txload 0/255, rxload 0/255
Encapsulation ARPA,
Full-duplex, 100Mb/s, THD, link type is force-up
output flow control is off, input flow control is off loopback not set, ARP type ARPA, ARP timeout 04:00:00
Last input 00:00:00, output 00:00:35
Last clearing of "show interface" counters never
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
972551 packets input, 128953765 bytes, 729 total input drops 172486 drops for unrecognized upper-level protocol
Received 0 broadcast packets, 800781 multicast packets 0 runts, 0 giants, 0 throttles, 0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 484545 packets output, 39360900 bytes, 0 total output drops Output 317283 broadcast packets, 167262 multicast packets 0 output errors, 0 underruns, 0 applique, 0 resets
0 output buffer failures, 0 output buffers swapped out 4 carrier transitions

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (78q)
Question 1: Refer to the exhibit. ***Exhibit is Missing*** Using a singl...
Question 2: Which component is integrated into the Cisco IPoDWDM interfa...
Question 3: Generally, which way is the fastest to open S3 and S4 servic...
Question 4: Given the IP address of 209.168.200.155/27, which two option...
Question 5: Which Cisco IOS XR command displays information about static...
Question 6: What is the SDH equivalent of the SONET STS-12 framing forma...
Question 7: Which two statements about Cisco IOS XR NTP configuration ar...
Question 8: What are the four steps to enable SSH v1 and v2 server on Ci...
Question 9: Which two statements about NetFlow support on Cisco IOS XR a...
Question 10: What does a transparent LAN switch use to build its CAM tabl...
Question 11: Which Cisco IOS XR CLI command can you use to determine if t...
Question 12: Refer to the exhibit. ***Exhibit is Missing*** Which three s...
Question 13: Refer to the exhibit. ***Exhibit is Missing*** Which three s...
Question 14: Which statement about STP operations is true?...
Question 15: Refer to the exhibit. ***Exhibit is Missing*** Given the Cla...
Question 16: You need to enable the "local-router" serial 0/0 connection ...
Question 17: Refer to the exhibit. ***Exhibit is Missing*** Which two opt...
Question 18: Refer to the exhibit. ***Exhibit is Missing*** Robert is sen...
Question 19: Which Cisco IOS XR command presents a list of all interfaces...
Question 20: With IPv6, for which purpose are router solicitation and rou...
Question 21: Given the IP address 10.106.170.145 255.248.0.0, which three...
Question 22: Which type of IPv6 address does the ff00::/8 prefix denote?...
Question 23: Which two statements about IPv4 DHCP operations are true? (C...
Question 24: If a bridge port is in the non-designated state, which two s...
Question 25: Given the CIDR address range of 200.165.160.0 to 200.165.191...
Question 26: Which Cisco IOS XR CLI command displays the running state of...
Question 27: Which two statements about classful or classless routing pro...
Question 28: Which SNMPv2/SNMPv3 operation is not supported in Cisco IOS ...
Question 29: Which two applications require the network to have the least...
Question 30: Which two statements about transparent bridging operations a...
Question 31: You are having problems browsing to http://www.cisco.com fro...
Question 32: Which statement about 10/40/100 GigabitEthernet interface co...
Question 33: Which Cisco IOS CLI command is used to verify the speed and ...
Question 34: Given the IP address 172.16.170.15 255.255.224.0, which thre...
Question 35: Which two statements are correct regarding routing protocol ...
Question 36: Which Layer 2 WAN protocol uses DLCI as the virtual circuit ...
Question 37: With a distance vector routing protocol like RIPv1, when is ...
Question 38: Which Cisco router feature allows multiple independent routi...
Question 39: Refer to the exhibit. ***Exhibit is Missing*** Which two sta...
Question 40: Which three statements about the Cisco IOS XR task-based use...
Question 41: Which statement about SSH is true?...
Question 42: Which two statements about Cisco IOS XE operations are true?...
Question 43: Currently, a Cisco IOS XR router is configured to send IP SL...
Question 44: Which feature is used to protect the control plane of the ro...
Question 45: Refer to the exhibit. ***Exhibit is Missing*** Which layer(s...
Question 46: Given these four Class B networks: 172.104.0.0, 172.105.0.0,...
Question 47: Refer to the exhibit. ***Exhibit is Missing*** Which configu...
Question 48: Which statement about IPv6 global unicast addresses is true?...
Question 49: Which three statements correctly describe DSL-based Internet...
Question 50: Refer to the exhibit. ***Exhibit is Missing*** Which two sta...
Question 51: Refer to the exhibit. ***Exhibit is Missing*** R1 and R2 are...
Question 52: This show output is from the S7 Cisco Metro Switch and the P...
Question 53: Which three statements about Cisco IOS XR CLI operations are...
Question 54: Which IPv6 feature replaced and enhanced the IPv4 ARP functi...
Question 55: What is the default spanning-tree mode of an NNI port on a C...
Question 56: When EIGRP is enabled on Cisco IOS XR, which EIGRP feature i...
Question 57: Using VLSM, how many /30 subnets can be derived from a singl...
Question 58: Which Cisco IOS XR command is involved in enabling remote ac...
Question 59: Refer to the exhibit. ***Exhibit is Missing*** Which stateme...
Question 60: Which three physical lines can provide local or remote acces...
Question 61: Which pair of mechanisms are often used together to allow dy...
Question 62: What are the three RFC 1918 IPv4 private address ranges? (Ch...
Question 63: On Cisco IOS Switches, which port security violation mode re...
Question 64: Which option is enabled by default on Cisco IOS and IOS XE r...
Question 65: Refer to the exhibit. ***Exhibit is Missing*** According to ...
Question 66: Which three statements about the ARP function are true? (Cho...
Question 67: On Cisco IOS XR, for which purpose is the turboboot procedur...
Question 68: Refer to the exhibit. ***Exhibit is Missing*** Which two opt...
Question 69: Which statement about a root bridge in an STP domain is true...
Question 70: Refer to the exhibit. ***Exhibit is Missing*** Company 1 has...
Question 71: Which three statements about Cisco Discovery Protocol operat...
Question 72: In Cisco IOS XR, which three operations is Admin mode used f...
Question 73: Refer to the exhibit. ***Exhibit is Missing*** You want to e...
Question 74: Which two statements about Packet over SONET are true? (Choo...
Question 75: Which Cisco IOS XR command displays traffic counters for an ...
Question 76: Which three IP addresses are valid for hosts that belong to ...
Question 77: Which Cisco IOS XR command presents a list of all interfaces...
Question 78: When two or more different routes exist to the same destinat...