<< Prev Question Next Question >>

Question 5/30

Refer to the exhibit.

How would HA select a default server for accounting?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (30q)
Question 1: What command must be used to enable IPSec on the Foreign Age...
Question 2: What is the result of the "authentication mn-aaa renew-and-d...
Question 3: What two mechanisms can content filtering be achieved throug...
Question 4: Which interface is used to establish a Mobile IP tunnel betw...
Question 5: Refer to the exhibit. (Exhibit) How would HA select a defaul...
Question 6: Which two nodes assign IP addresses to Mobile for Simple IP?...
Question 7: Which access ruledef configuration can be used to match all ...
Question 8: What UDP port is used between PCF and PDSN for the A11 inter...
Question 9: Which Cisco ASR 5000 CLI options are available actions that ...
Question 10: Which message is sent from the PDSN to the AAA server to ind...
Question 11: What two tunnelling protocols does Mobile IPv4 use? (Choose ...
Question 12: Which configuration in an AAA group defines the attribute na...
Question 13: PDSN Simple IP LAC services can be applied to incoming PPP s...
Question 14: Which two result codes in CCA-U from primary Online Charging...
Question 15: What does the X-Header Insertion feature on the Cisco ASR 50...
Question 16: Which context is used on the standalone PDSN to configure IP...
Question 17: Which two protocols are used in Simple IP by Mobile? (Choose...
Question 18: Which configuration will set the next hop address for post p...
Question 19: Which configuration sequence in HA on the Cisco ASR 5000 is ...
Question 20: Which statement best describes the role the Cisco ASR 5000 s...
Question 21: What does the Cisco ASR 5000 PDSN do when subscriber's authe...
Question 22: Which statement is correct when 'domain cisco.com default su...
Question 23: IPSec Encapsulating Security Payload uses what IP protocol n...
Question 24: Refer to the exhibit. (Exhibit) How would you enable failure...
Question 25: What command will display information pertaining to a L2TP s...
Question 26: Which RFC specifies the Diameter base protocol?...
Question 27: Which option describes the GRE protocol?...
Question 28: What is an attack in which the attacker sets the source IP a...
Question 29: Which ruledef configuration can be used for charging of HTTP...
Question 30: What is the default port used for in Mobile IP Registration ...