<< Prev Question Next Question >>

Question 56/93

MPLS Service Providers use Route Distinguishers and Route Targets as methods to control routing for customer VRFs. Which two statements are true about Route Distinguishers and Route Targets? (Choose two.)

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (93q)
Question 1: A network engineer is responsible for implementing a solutio...
Question 2: Which are the two fundamental ways in which IEEE 1588 differ...
Question 3: Which QoS method is available when GRE is used to provide MP...
Question 4: Refer to the exhibit. R1 and R2 are multicast routers runnin...
Question 5: What are three actions that the control word performs in MPL...
Question 6: What are the four key design requirements for mobile IP back...
Question 7: Which two flexible service mapping features that are used on...
Question 8: Based on the following configuration: vrf definition ABC rd ...
Question 9: Refer to the exhibit. A network engineer must configure BFD ...
Question 10: Refer the exhibit. Two Autonomous Systems are enabled to sup...
Question 11: A telecom company offers ISPs the ability to resell dynamic ...
Question 12: QoS is applied on an outgoing interface as shown below: poli...
Question 13: Which are the two purposes of the MPLS label value 1? (Choos...
Question 14: A Service Provider wants to extend MPLS WAN endpoints in the...
Question 15: DRAG DROP Drag and drop the IPFIX terminology on the left to...
Question 16: An engineer has just configured IOS-XR with out-of-band MPP....
Question 17: Which Cisco IOS XR Virtualization technology provides full i...
Question 18: Which is the RP address of the IPv6 multicast address FF76:0...
Question 19: What are two advantages of Cisco IOS XR Software over Cisco ...
Question 20: An engineer must implement E-Line services for a service pro...
Question 21: Refer to the exhibit. How will the redistributed routes on R...
Question 22: Which two frame types are correct when configuring T3 interf...
Question 23: Which is the main characteristic of LTE architecture compari...
Question 24: Refer to the exhibit. R3 cannot install a route to R1-R2 sub...
Question 25: A Server Provider is seeing an increasing amount of attacks ...
Question 26: Refer to the exhibit. An MPLS Layer 3 VPN service has been p...
Question 27: An engineer is implementing an MPLS within the core of the S...
Question 28: Refer to the exhibit. The referenced TE tunnels compete for ...
Question 29: Refer to the exhibit. The Service Provider is deploying Inte...
Question 30: A network engineer is designing the BGP architecture with a ...
Question 31: Refer to the exhibit. A web server is connected to a switch ...
Question 32: Refer to the exhibit. After the BGP TCP negotiation between ...
Question 33: Two routers that are running MPLS and LDP have multiple link...
Question 34: In which way does the DS-Lite IPv6 transitioning mechanism d...
Question 35: Refer to the exhibit. (Exhibit) When a traceroute is perform...
Question 36: Which are the three header fields that affect how Equal-Cost...
Question 37: The product team at an ISP that offers VoIP services wants t...
Question 38: In a routing virtualization concept, which are the two main ...
Question 39: For MPLS inter-AS Option B, how many labels are associated w...
Question 40: Refer to the exhibit. The configuration in the exhibit redis...
Question 41: What is NETCONF?
Question 42: Refer to the exhibit. R2 and R3 cannot install IS-IS IPv6 ro...
Question 43: Refer to the exhibit. (Exhibit) A service provider has multi...
Question 44: A service provider is implementing Ethernet solutions for cl...
Question 45: Customers connecting to a Service Provider for Internet acce...
Question 46: A Service Provider connects to a client site that has two CE...
Question 47: An R1 router requires an equal load balancing to reach the p...
Question 48: A Service Provider is offering VoIP services and a service l...
Question 49: DRAG DROP Drag and drop the MPLS operation listed on the lef...
Question 50: Refer to the exhibit. OSPFv3 is already running, and R1 has ...
Question 51: A network engineer wants to decrease the convergence time of...
Question 52: Which is the main goal of BGPsec regards to improve BGP secu...
Question 53: In a Layer 2 VPN service, which is the default behavior of a...
Question 54: Refer to the exhibit. In the short-pipe QoS mode, this custo...
Question 55: Refer to the exhibit. Router RT1 has three equal-cost paths ...
Question 56: MPLS Service Providers use Route Distinguishers and Route Ta...
Question 57: What BGP feature improves on DDOS mitigation by allowing ins...
Question 58: Due to recent acquisitions, a company's MPLS infrastructure ...
Question 59: Refer to the exhibit. Two MPLS TE tunnels are configured wit...
Question 60: Refer to the exhibit. (Exhibit) ABC and XYZ MPLS VPN custome...
Question 61: Which BGP feature improves the convergence and response time...
Question 62: A Service Provider provides a Layer 2 connection that is bas...
Question 63: A company is deciding between an HVR and SVR solution in ord...
Question 64: An engineer wants to configure MPLS TE Fast Reroute with lin...
Question 65: A network administrator wants to implement an IP dampening f...
Question 66: Which two statements about Unified MPLS are true? (Choose tw...
Question 67: Two Tier 2 Service Providers are using a Tier 1 Service Prov...
Question 68: In a secure domain router scenario, which two functions are ...
Question 69: An engineer wants to configure Fast Reroute in the network. ...
Question 70: What are three main characteristics of mLDP that differ from...
Question 71: Refer to the exhibit. A customer is running IS-IS within a n...
Question 72: Two Service Providers are beginning a merger between AS boun...
Question 73: An engineer is working to provide high availability to a Ser...
Question 74: Refer to the exhibit. An SP core is running MPLS with OSPF a...
Question 75: Refer to the exhibit. Both MPLS TE tunnel 14 and MPLS TE tun...
Question 76: DRAG DROP Drag and drop Evolved Packet Core functional entit...
Question 77: An engineer is deploying RTBH. What is necessary routing con...
Question 78: DRAG DROP Drag and drop the OAM protocol listed on the left ...
Question 79: A network engineer needs to connect two core switches that u...
Question 80: SSO was configured on a Cisco ASR 1006 Router by using two R...
Question 81: Refer to the exhibit. Customer XYZ Site 1 is not learning pr...
Question 82: Refer to the exhibit. Why is R3 unable to install 1.1.1.1/32...
Question 83: Refer to the exhibit. (Exhibit) The vrf MAINT has been provi...
Question 84: An IS-IS enabled router with multiple IS-IS neighbors is req...
Question 85: Refer to the exhibit. Which statement is true? (Exhibit)...
Question 86: Drag and drop the IOS XR NTP access group options on the lef...
Question 87: Refer to the exhibit. Which IOS command under the BGP VPNv4 ...
Question 88: What is the main advantage of H-VPLS over VPLS?...
Question 89: When troubleshooting a DoS attack, a support engineer finds ...
Question 90: Which are two major changes SyncE offers over traditional Et...
Question 91: Which are the three benefits of using the Yang model? (Choos...
Question 92: What is the PPMP label used for?...
Question 93: Refer to the exhibit. What is the correct action to fix the ...