Valid 400-151 Dumps shared by ExamDiscuss.com for Helping Passing 400-151 Exam! ExamDiscuss.com now offer the newest 400-151 exam dumps, the ExamDiscuss.com 400-151 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 400-151 dumps with Test Engine here:
Access 400-151 Dumps Premium Version
(200 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 10/160
A Cisco switch has this configuration for a port channel connecting to an ESXi using dual NICs and is intended for use with an N1Kv.
Interface fastethernet 1/10
Switchport mode trunk
Switchport trunk allowed vlan all
Channel-group 10 mode on
No shut
Interface fastethernet 1/11
Switchport mode trunk
Switchport trunk allowed vlan all
Channel-group 10 mode on
No shut
Interface port-channel10
Switchport mode trunk
Switchport allowed vlan all
No shut
Which Port Channel configuration must be used on the Nexus 1000v port-profile?
Interface fastethernet 1/10
Switchport mode trunk
Switchport trunk allowed vlan all
Channel-group 10 mode on
No shut
Interface fastethernet 1/11
Switchport mode trunk
Switchport trunk allowed vlan all
Channel-group 10 mode on
No shut
Interface port-channel10
Switchport mode trunk
Switchport allowed vlan all
No shut
Which Port Channel configuration must be used on the Nexus 1000v port-profile?
Correct Answer: C
Explanation/Reference:
Explanation:
Explanation:
- Question List (160q)
- Question 1: In a Cisco Unified Computing System, where are SAN port chan...
- Question 2: Which statement describes the graceful restart capability in...
- Question 3: Refer to the exhibit. (Exhibit) On which of the interfaces c...
- Question 4: On a Cisco Unified Computing System (UCS), which two stateme...
- Question 5: Which three capabilities make the Cisco Nexus 7010 switch an...
- Question 6: Cisco DCNM-LAN supports the configuration and monitoring of ...
- Question 7: Each port that is configured to use LACP has an LACP port pr...
- Question 8: When configuring unified ports on a 5548 switch, which port ...
- Question 9: After configuring FabricPath, the following appears in the s...
- Question 10: A Cisco switch has this configuration for a port channel con...
- Question 11: Where are Cisco UCS vNICs created?...
- Question 12: Where are SAN Port Channel is created in UCS Manager?...
- Question 13: Overlay Transport Virtualization (OTV) join interface is use...
- Question 14: Application Control Engine (ACE) can check the health of ser...
- Question 15: What is the correct order for FIP virtual establishment?...
- Question 16: Which two statements about SAN port channels configured on C...
- Question 17: What is the mechanism that is used to allocate MAC addresses...
- Question 18: Select and Place: (Exhibit)
- Question 19: Which statement is true about "full state backup" in a Cisco...
- Question 20: Which two are benefits of using remote AAA services for Cisc...
- Question 21: Which three statements describe user authentication in Cisco...
- Question 22: Which three statements about the DHCP snooping feature on Ci...
- Question 23: Refer to the exhibit. (Exhibit) Given this FCoE topology, ho...
- Question 24: In a virtual port channel (vPC) configuration, VRRP exhibits...
- Question 25: What is the difference between the Ethanalyzer and the SPAN ...
- Question 26: In the event of a catastrophic disaster, after which you nee...
- Question 27: Select and Place: (Exhibit)
- Question 28: On Cisco Nexus 5000 Series Switches, where are the virtual o...
- Question 29: Which statement about the Adapter FEX feature on the Cisco N...
- Question 30: Which attribute is used to pass the user role back to the Ne...
- Question 31: On the Cisco Nexus 7000 Series Switch, Control Plane Policin...
- Question 32: On a Cisco Nexus 7000 Series Switch, what is the purpose of ...
- Question 33: Which two Fibre Channel features are not supported in Cisco ...
- Question 34: In the Cisco FabricPath domain, one switch becomes the root ...
- Question 35: Nexus# sh ip igmp snooping vlan 120 IGMP Snooping informatio...
- Question 36: Which three statements describe the configuration change man...
- Question 37: Refer to the exhibit. (Exhibit) You create a service profile...
- Question 38: Which statement about NPIV is true?...
- Question 39: What interface is created when an FC Port Channel is created...
- Question 40: 2012 Feb 23 23:00:08.676710 pim: [16132] (default-base) Rece...
- Question 41: Overlay Transport Virtualization (OTV) uses the Authoritativ...
- Question 42: Which three statements best describe HSRP configuration on C...
- Question 43: If the default VDC is configured to limit resources to a spe...
- Question 44: Given the following output: san-port-channel 12 is up Hardwa...
- Question 45: How many VSM modes are there in a Cisco Nexus 1000V environm...
- Question 46: Cisco FabricPath uses what as a common bridge ID to connecte...
- Question 47: Which two statements about end-host mode in SAN connectivity...
- Question 48: Which statements are valid for a local SPAN configuration? (...
- Question 49: When creating a role in a Cisco Nexus 7000 Series Switch, ru...
- Question 50: DCNM is capable of monitoring the network performance of a S...
- Question 51: Which two statements about authentication settings for DCNM-...
- Question 52: Which statement describes the XML management interface in Ci...
- Question 53: Refer to the exhibit. (Exhibit) According to the equipment t...
- Question 54: What is the use of NPV in Cisco Unified Computing Systems? (...
- Question 55: The vPC peer-gateway capability allows a vPC switch to act a...
- Question 56: On a Cisco UCS B250 M2 server that is fully populated with 1...
- Question 57: Which two servers support memory extension technology and gi...
- Question 58: When creating a QoS policy dialog box in Cisco UCSM, which f...
- Question 59: Server load balancing (SLB) is the process of deciding to wh...
- Question 60: Which two statements about VACLs on Cisco Nexus 7000 Series ...
- Question 61: Which statement best describes ACL configuration using confi...
- Question 62: Which statement describes the FIP function of the FCoE Initi...
- Question 63: Refer to the exhibit. (Exhibit) An ESX host is added to a di...
- Question 64: Cisco IOS NetFlow gathers data that can be used in which thr...
- Question 65: Given the following configuration, what command can be used ...
- Question 66: Refer to the exhibit. (Exhibit) All Ethernet ports are trunk...
- Question 67: When building a NIC team (virtual port channel) between a ho...
- Question 68: Which command will allow you to display the configured QoS g...
- Question 69: Virtual PortChannels (vPCs) allow links that are physically ...
- Question 70: When using Overlay Transport Virtualization (OTV), how do L2...
- Question 71: An administrator creates a vNIC and assigns it to Fabric A w...
- Question 72: What is the benefit of using Anycast RP via RFC 4610 for IP ...
- Question 73: You can install Cisco DCNM-LAN on a supported version of whi...
- Question 74: Refer to the exhibit. (Exhibit) Fabric Interconnect A, opera...
- Question 75: Enabling jumbo frame support on a Cisco Nexus 5500 Switch ca...
- Question 76: Refer to the exhibit. (Exhibit) Your company would like to d...
- Question 77: On a Cisco UCS B250 server, how many physical DIMM slots mak...
- Question 78: When configuring vPC-HM CDP with multiple links to the same ...
- Question 79: Lossless Ethernet for FCoE is achieved through the use of wh...
- Question 80: With Cisco NX-OS on a Cisco Nexus platform, which command sh...
- Question 81: Overlay Transport Virtualization (OTV) provides an overlay t...
- Question 82: Given the following configuration: port-profile type etherne...
- Question 83: SNMPv3 authorizes management operations only by configured u...
- Question 84: Smart Call Home provides an email-based notification for cri...
- Question 85: Which statement about SAN port channels configured on Cisco ...
- Question 86: A customer would like to monitor traffic that is being sent ...
- Question 87: In a Cisco Unified Computing System, What is the "designated...
- Question 88: What is the use of an "all configuration" backup in Cisco UC...
- Question 89: vPath is a critical component in the VNS architecture. Which...
- Question 90: From the Cisco UCS CLI, how do you verify which uplink ports...
- Question 91: Which statement describes OTV configuration on the Cisco Nex...
- Question 92: What is the purpose of this command in a Cisco Application C...
- Question 93: What is required for Cisco UCS C-Series rack server integrat...
- Question 94: Your company wants Server 1/eth0 (vNIC 1) configured so that...
- Question 95: Which port channel command is recommended for N1KV on Cisco ...
- Question 96: Why is a Cisco UCS B250 server unable to support 16-GB DIMMs...
- Question 97: On a Nexus 5000 Series Switch, when a VFC is not online, wha...
- Question 98: Refer to the exhibit. (Exhibit) Your company requires a Cisc...
- Question 99: What is the appliance port used to connect to in a Cisco Uni...
- Question 100: Refer to the exhibit. (Exhibit) vPC+ is configured between w...
- Question 101: Given a Cisco Unified Computing System, which is a valid por...
- Question 102: When will an "all configuration" backup be imported into the...
- Question 103: Which GSS "source access list" is used to allow access to GS...
- Question 104: FabricPath brings the benefits of routing protocols to layer...
- Question 105: Which of the following are supported in Cisco Global Site Se...
- Question 106: On Cisco Nexus 7000 Series Switch Cisco FabricPath domain, o...
- Question 107: Traffic drop for FCoE is experienced across a Nexus 5548 swi...
- Question 108: Nexus# conf t Enter configuration commands, one per line. En...
- Question 109: The hardware and software configurations for vPC+ are simila...
- Question 110: How are IP multicast IGMP entries synchronized between vPC p...
- Question 111: What is the use of ERSPAN on N1kv?...
- Question 112: Which three are valid methods to monitor and trend SAN port ...
- Question 113: A Cisco UCS fabric interconnect in end-host mode learns MAC ...
- Question 114: The Cisco Nexus 1000V Series Switches are virtual machine ac...
- Question 115: In a Cisco Nexus 7000 platform configured with GLBP, which G...
- Question 116: KAL-AP on the Cisco ACE allows communication with Cisco ACE ...
- Question 117: Given a host with two NICs assigned to a N1k profile, which ...
- Question 118: Which capabilities are not supported in DCNM device manager?...
- Question 119: Cisco NX-OS Software supports SNMPv1, SNMPv2c, and SNMPv3. B...
- Question 120: In a configuration with redundant supervisors, how many IP a...
- Question 121: What does the mac packet-classify command do when applied to...
- Question 122: Which statement describes multihop FCoE function when an FCo...
- Question 123: Which policy determines what happens to local data and to th...
- Question 124: Which Ethernet field is used to differentiate between the FC...
- Question 125: A virtual port channel (vPC) allows links that are physicall...
- Question 126: The network administrator is adding a new N1Kv to the vCente...
- Question 127: Which is true when describing a connection replication in Ci...
- Question 128: n1kv-l3(config)# show lacp offload status Current Status : E...
- Question 129: By default, what type of SSH server key is generated by Cisc...
- Question 130: VLAN configuration using DCNM can be completed by which two ...
- Question 131: A Host connected to an NPV switch is not able to see the sto...
- Question 132: Which statement describes SNMP functionality in Cisco NX-OS ...
- Question 133: When testing ICMP access to a functional load-balancing ACE ...
- Question 134: DCNM device discovery is done by connecting to Cisco NX-OS d...
- Question 135: Cisco UCS Manager provides the ability to manage power utili...
- Question 136: Nexus7000# config t Nexus700(config)# interface ethernet 2/1...
- Question 137: What are the two parallel SCSI specifications? (Choose two.)...
- Question 138: What would be the cause for the following fault in UCS Manag...
- Question 139: An administrator is creating a service profile but receives ...
- Question 140: Regarding disk scrub, which two of these occur to the data o...
- Question 141: Cisco UCS provides integration interfaces and protocols to s...
- Question 142: Which statement is correct about the number of available QoS...
- Question 143: Which option describes the default roles available to RBAC o...
- Question 144: Where is a typical request in the Cisco UCS XML API placed i...
- Question 145: A Cisco Application Control Engine Appliance (ACE) non-admin...
- Question 146: Which statement describes the below output from an MDS switc...
- Question 147: A VSM is actually a virtual machine that requires how many v...
- Question 148: What is required for proper implementation of jumbo frame su...
- Question 149: Refer to the exhibit. (Exhibit) During troubleshooting of Vi...
- Question 150: Which statement about Cisco Unified Fabric switches is corre...
- Question 151: Which two statements about QoS options in a Cisco UCS enviro...
- Question 152: Which three statements best describe multicast operation on ...
- Question 153: Which mechanism do the CNA and the Cisco Nexus 5000 Series S...
- Question 154: What does the command "IP ARP synchronize" do in a vPC confi...
- Question 155: Overlay Transport Virtualization (OTV) overlay interface is ...
- Question 156: Refer to the exhibit. (Exhibit) The Cisco UCS domain is oper...
- Question 157: Which statements are true regarding the Cisco UCS fabric fai...
- Question 158: When using VSD, traffic flow goes from the virtual machine t...
- Question 159: DHCP snooping on Cisco Nexus 1000V Series Switches acts like...
- Question 160: Which command is used to determine if a host has logged in t...
