400-101 Exam Dumps | Refer to the exhibit. (Exhibit) While troubleshooting high CPU utilization of a Cisco Catalyst 4500 Series

<< Prev Question Next Question >>

Question 59/181

Refer to the exhibit.

While troubleshooting high CPU utilization of a Cisco Catalyst 4500 Series Switch, you notice the error message that is shown in the exhibit in the log file.
What can be the cause of this issue, and how can it be prevented?

A. The hardware routing table is full. Redistribute from BGP into IGP.

B. The software routing table is full. Redistribute from BGP into IGP.

C. The hardware routing table is full. Reduce the number of routes in the routing table.

D. The software routing table is full. Reduce the number of routes in the routing table.

Question List (181q): Question 1: Which technology is an application of MSDP, and provides loa...; Question 2: Refer to the exhibit. (Exhibit) Which statement is true?...; Question 3: Refer to the exhibit. (Exhibit) Which statement is true?...; Question 4: Which two methods change the IP MTU value for an interface? ...; Question 5: Which two options are causes of out-of-order packets? (Choos...; Question 6: Which statement is true about IGMP?...; Question 7: Which statement about the feasibility condition in EIGRP is ...; Question 8: Which three statements about the designated router election ...; Question 9: Which statement describes the BGP add-path feature?...; Question 10: Which two statements are true about VPLS? (Choose two.)...; Question 11: Refer to the exhibit. Which statement describes the effect o...; Question 12: Which switching technology can be used to solve reliability ...; Question 13: Refer to the exhibit. (Exhibit) While troubleshooting high C...; Question 14: Refer to the exhibit. Routers R1, R2, and R3 are configured ...; Question 15: DRAG DROP (Exhibit); Question 16: Refer to the exhibit. Which VLANs are permitted to send fram...; Question 17: Which two statements about private VLANs are true? (Choose t...; Question 18: What is the goal of Unicast Reverse Path Forwarding?...; Question 19: Which three statements about implementing a NAT application ...; Question 20: Refer to the exhibit. (Exhibit) Which action will solve the ...; Question 21: Which three statements are true about PPP CHAP authenticatio...; Question 22: Refer to the exhibit. Which technology does the use of bi-di...; Question 23: A service provider is deploying L2VPN LAN services in its MP...; Question 24: Refer to the exhibit. (Exhibit) AS #1 and AS #2 have multipl...; Question 25: Refer to the exhibit. (Exhibit) Which statement is true?...; Question 26: How does EIGRP derive the metric for manual summary routes?...; Question 27: Which two mechanisms provide Cisco IOS XE Software with cont...; Question 28: Refer to the exhibit. (Exhibit) Which statement is true?...; Question 29: What can PfR passive monitoring mode measure for TCP flows?...; Question 30: Refer to the exhibit. (Exhibit) What is the PHB class on thi...; Question 31: Refer to the exhibit. (Exhibit) Notice that debug ip bgp upd...; Question 32: Which two statements describe characteristics of HDLC on Cis...; Question 33: DRAG DROP (Exhibit); Question 34: Refer to the exhibit. (Exhibit) Which statement is true?...; Question 35: What is the purpose of EIGRP summary leaking?...; Question 36: Which two statements are true about OTV? (Choose two.)...; Question 37: Refer to the exhibit. (Exhibit) Video Source S is sending in...; Question 38: What is a cause for unicast flooding?...; Question 39: Which statement about the function of poison reverse in EIGR...; Question 40: Which mechanism does Cisco recommend for CE router interface...; Question 41: Refer to the exhibit. Which statement about this device conf...; Question 42: Which statement describes the function of the tracking objec...; Question 43: Which statement is true regarding UDLD and STP timers?...; Question 44: What is the preferred method to improve neighbor loss detect...; Question 45: Which two statements are true about RSTP? (Choose two.)...; Question 46: Which two configuration changes should be made on the OTP in...; Question 47: What are two reasons to define static peers in EIGRP? (Choos...; Question 48: Which option is the default maximum age of the MAC address t...; Question 49: Refer to the exhibit. (Exhibit) A PE router is configured wi...; Question 50: Which type of port would have root guard enabled on it?...; Question 51: DRAG DROP (Exhibit); Question 52: Refer to the exhibit. R3 prefers the path through R1 to reac...; Question 53: Refer to the exhibit. If a port is configured as shown and r...; Question 54: Which two statements about the function of the stub feature ...; Question 55: In the DiffServ model, which class represents the lowest pri...; Question 56: Refer to the exhibit. Which two statements about how the con...; Question 57: Refer to the exhibit. (Exhibit) Why is R2 unable to ping the...; Question 58: Refer to the exhibit. (Exhibit) Router A and router B are ph...; Question 59: Refer to the exhibit. (Exhibit) While troubleshooting high C...; Question 60: Refer to the exhibit. (Exhibit) Which statement is true?...; Question 61: Which mechanism can be used on Layer 2 switches so that only...; Question 62: What is the function of an EIGRP sequence TLV packet?...; Question 63: Refer to the exhibit. (Exhibit) What is the meaning of the a...; Question 64: Which two DHCP messages are always sent as broadcast? (Choos...; Question 65: Which statement is true about VPLS?...; Question 66: Refer to the exhibit. (Exhibit) ICMP Echo requests from host...; Question 67: Which attribute is not part of the BGP extended community wh...; Question 68: Refer to the exhibit. Which two statements about the device ...; Question 69: Which two statements are true about an EPL? (Choose two.)...; Question 70: Refer to the exhibit. (Exhibit) Why is network 172.16.1.0/24...; Question 71: Refer to the exhibit. (Exhibit) Which statement is true abou...; Question 72: Refer to the exhibit. If you change the Spanning Tree Protoc...; Question 73: A GRE tunnel is down with the error message %TUN-5-RECURDOWN...; Question 74: DRAG DROP (Exhibit); Question 75: Which two options are reasons for TCP starvation? (Choose tw...; Question 76: Refer to the exhibit. (Exhibit) Which part of the joined gro...; Question 77: Refer to the exhibit. Which two statements about the output ...; Question 78: Refer to the exhibit. (Exhibit) NHRP registration is failing...; Question 79: Refer to the exhibit. You discover that only 1.5 Mb/s of web...; Question 80: In the DiffServ model, which class represents the highest pr...; Question 81: Refer to the exhibit. (Exhibit) Which two statements about t...; Question 82: Refer to the exhibit. (Exhibit) Which three statements about...; Question 83: Which three statements about IS-IS are true? (Choose three.)...; Question 84: Which two statements are true about IPv6 multicast? (Choose ...; Question 85: Refer to the exhibit. For which reason could a BGP-speaking ...; Question 86: Which statement is true about Fast Link Pulses in Ethernet?...; Question 87: DRAG DROP (Exhibit); Question 88: Refer to the exhibit. (Exhibit) What will be the extended co...; Question 89: Refer to the exhibit. (Exhibit) Service provider SP 1 is run...; Question 90: With which ISs will an ISIS Level 1 IS exchange routing info...; Question 91: Which three factors does Cisco PfR use to calculate the best...; Question 92: Refer to the exhibit. Which statement about this COS-DSCP ma...; Question 93: Refer to the exhibit. (Exhibit) Which three statements about...; Question 94: Refer to the exhibit. (Exhibit) This is the configuration of...; Question 95: Refer to the exhibit. (Exhibit) You have just created a new ...; Question 96: Refer to the exhibit. (Exhibit) Which two statements are tru...; Question 97: DRAG DROP (Exhibit); Question 98: Which statement about OSPF multiaccess segments is true?...; Question 99: DRAG DROP (Exhibit); Question 100: Which two functions are performed by the DR in OSPF? (Choose...; Question 101: The session status for an IPsec tunnel with IPv6-in-IPv4 is ...; Question 102: Which two features does the show ipv6 snooping features comm...; Question 103: Refer to the exhibit. (Exhibit) At which location will the b...; Question 104: Which statement about shaped round robin queuing is true?...; Question 105: What is the cause of ignores and overruns on an interface, w...; Question 106: Which technology can be used to prevent flooding of IPv6 mul...; Question 107: Which three steps are necessary to enable SSH? (Choose three...; Question 108: Refer to the exhibit. (Exhibit) While configuring AAA with a...; Question 109: In which type of EIGRP configuration is EIGRP IPv6 VRF-Lite ...; Question 110: Refer to the exhibit. (Exhibit) What is the role of this mul...; Question 111: Which statement is true comparing L2TPv3 to EoMPLS?...; Question 112: According to RFC 4577, OSPF for BGP/MPLS IP VPNs, when must ...; Question 113: Refer to the exhibit. (Exhibit) Which command is configured ...; Question 114: Refer to the exhibit. Which two corrective actions could you...; Question 115: Which authentication method does OSPFv3 use to secure commun...; Question 116: Refer to the exhibit. (Exhibit) Why is the prefix 1.1.1.1/32...; Question 117: Refer to the exhibit. (Exhibit) Which two statements are tru...; Question 118: Which regular expression will only allow prefixes that origi...; Question 119: Which three modes are valid PfR monitoring modes of operatio...; Question 120: Which two mechanisms can be used to eliminate Cisco Express ...; Question 121: Refer to the exhibit. (Exhibit) How many EIGRP routes will a...; Question 122: Refer to the exhibit. (Exhibit) What is a possible reason fo...; Question 123: What is the most efficient way to confirm whether microburst...; Question 124: Refer to the exhibit. (Exhibit) Which two are causes of outp...; Question 125: Which statement about the BGP originator ID is true?...; Question 126: Refer to the exhibit. Which statement about this IP SLA is t...; Question 127: Refer to the exhibit. (Exhibit) The interface FastEthernet0/...; Question 128: Refer to the exhibit. (Exhibit) Why is the router not access...; Question 129: Which statement about a type 4 LSA in OSPF is true?...; Question 130: Refer to the exhibit. (Exhibit) Why is the neighbor relation...; Question 131: What is a reason for 6PE to use two MPLS labels in the data ...; Question 132: DRAG DROP (Exhibit); Question 133: Refer to the exhibit. (Exhibit) Which option explains why th...; Question 134: Like OSPFv2, OSPFv3 supports virtual links.Which two stateme...; Question 135: Which three statements are functions that are performed by I...; Question 136: DRAG DROP (Exhibit); Question 137: What is a key advantage of Cisco GET VPN over DMVPN?...; Question 138: Refer to the exhibit. (Exhibit) A spoke site that is connect...; Question 139: A TCP/IP host is able to transmit small amounts of data (typ...; Question 140: What is the purpose of Route Target Constraint?...; Question 141: Consider an OSPFv3 network with four parallel links between ...; Question 142: Which two statements are true about an EVPL? (Choose two.)...; Question 143: Which implementation can cause packet loss when the network ...; Question 144: Refer to the exhibit. (Exhibit) Which two statements are tru...; Question 145: Which two options are advantages of NetFlow version 9 over N...; Question 146: Which three elements compose a network entity title? (Choose...; Question 147: DRAG DROP (Exhibit); Question 148: What are the minimal configuration steps that are required t...; Question 149: Which group of neighbors can be configured as a BGP peer gro...; Question 150: DRAG DROP (Exhibit); Question 151: For which kind of MPLS deployment is the next-hop-self all k...; Question 152: Refer to the exhibit. Which statement about the debug behavi...; Question 153: Refer to the exhibit. (Exhibit) What does "(received-only)" ...; Question 154: Refer to the exhibit. (Exhibit) Which statement is true?...; Question 155: Refer to the exhibit. (Exhibit) All switches have default br...; Question 156: Which three actions are required when configuring NAT-PT? (C...; Question 157: Which three statements describe the characteristics of a VPL...; Question 158: EIGRP allows configuration of multiple MD5 keys for packet a...; Question 159: Which is the way to enable the control word in an L2 VPN dyn...; Question 160: In GETVPN, which key is used to secure the control plane?...; Question 161: Refer to the exhibit. (Exhibit) All switches have default br...; Question 162: Refer to the exhibit. Which two statements about the VPN sol...; Question 163: Which variable in an EEM applet is set when you use the sync...; Question 164: Refer to the exhibit. (Exhibit) What is wrong with the confi...; Question 165: Refer to the exhibit. (Exhibit) Which statement is true?...; Question 166: What is a disadvantage of using aggressive mode instead of m...; Question 167: Which statement about the RPF interface in a BIDIR-PIM netwo...; Question 168: Which two statements about port ACLs are true? (Choose two.)...; Question 169: Refer to the exhibit. (Exhibit) What kind of load balancing ...; Question 170: Refer to the exhibit. Which two statements about the EEM app...; Question 171: Which three conditions can cause excessive unicast flooding?...; Question 172: Consider a network that mixes link bandwidths from 128 kb/s ...; Question 173: Which Carrier Ethernet service supports the multiplexing of ...; Question 174: What is a reason to use DHCPv6 on a network that uses SLAAC?...; Question 175: Which three statements are true about OSPFv3? (Choose three....; Question 176: Refer to the exhibit. (Exhibit) What is a reason for the RIB...; Question 177: Refer to the exhibit. (Exhibit) Which statement about the ou...; Question 178: Refer to the exhibit. R2 is mutually redistributing between ...; Question 179: Which field is specific to the OPSFv3 packet header, as oppo...; Question 180: Refer to the exhibit. Which additional configuration is nece...; Question 181: Refer to the exhibit. (Exhibit) Which configuration is missi...

Question 59/181

LEAVE A REPLY

Download PDF File