<< Prev Question Next Question >>

Question 47/73

An engineer with troubleshoots poor voice quality on multiple calls. After looking at packet captures, the engineer notices high levels of jitter. Which two areas does the engineer check to prevent jitter? (Choose two.)

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (73q)
Question 1: What is the correct statement about CUCM and Cisco IM&amp;P ...
Question 2: How does an administrator make Cisco IP phone display the la...
Question 3: Which issue can occur if QoS is not Deployed on a Cisco Coll...
Question 4: A customer is deploying a SIP IOS gateway for a customer who...
Question 5: After an engineer runs the utils ntp status command on the C...
Question 6: Which access control group is required on an end user to all...
Question 7: A customer asked to integrate Unity Connection with Cisco UC...
Question 8: What is required when deploying co-resident VMs by using Cis...
Question 9: An engineer is notified that the Cisco TelePresence MX800 th...
Question 10: Why would we not include an end user's PC device in a QoS tr...
Question 11: AN engineer is implementing toll fraud prevention for incomi...
Question 12: An employee of company ABC just quit. The IT administrator d...
Question 13: Which wildcard must an engineer configure to match a whole d...
Question 14: A user dials 9011841234567 to reach Vietnam. Which steps sen...
Question 15: User A Calls user. The call gets connected, but the quality ...
Question 16: Which action is required if an engineer wants to have Cisco ...
Question 17: There is a saturated link that has traffic shaping configure...
Question 18: Configuration of DNS is required to achieve a fully function...
Question 19: An administrator installed a Cisco Unified IP 8831 Conferenc...
Question 20: An administrator is integrating a Cisco Unity Express module...
Question 21: What is a characteristic of video traffic that governs QoS r...
Question 22: What dialled numbers match this Cisco UCM route pattern? 1[2...
Question 23: Which settings are needed to configure the SIP route pattern...
Question 24: Refer to the exhibit. (Exhibit) When a UC Administrator is t...
Question 25: Which DTMF relay method configured on a SIP dial-peer will e...
Question 26: Refer to the exhibit. (Exhibit) The SOP offer/answer has bee...
Question 27: What is set when using CoS to mark an Ethernet frame?...
Question 28: Refer to the exhibit. (Exhibit) Which Codec is negotiated?...
Question 29: What is the difference between Cisco Unified Border Element ...
Question 30: A presence redundancy group is deployed, and an engineer wit...
Question 31: Which two types of device are supported by the Bulk Administ...
Question 32: Which two approaches are taken to implement CAC within Cisco...
Question 33: How does Cisco Unified Communications Manager perform a digi...
Question 34: Which method is used to avoid toll fraud with Cisco Unified ...
Question 35: Refer to the exhibit. (Exhibit) An engineer verifies the con...
Question 36: Refer to the exhibit. (Exhibit) Endpoint A calls endpoint B....
Question 37: Which DiffServ marking is the most likely to drop packets?...
Question 38: Regarding SIP integrations with Cisco Unified Communications...
Question 39: Refer to the exhibit. (Exhibit) An administrator is attempti...
Question 40: Which call routing pattern is used for phone numbers that ar...
Question 41: Due to service provider restriction, Cisco Unified Communica...
Question 42: Calls are being delivered to the end user in the globalized ...
Question 43: Which action enables Cisco MRA?...
Question 44: An administrator is in the process of moving cisco unity con...
Question 45: Which open-standard protocol is the basis for the Extensible...
Question 46: When setting a new primary DNS server in the Cisco UCM CLI w...
Question 47: An engineer with troubleshoots poor voice quality on multipl...
Question 48: Which two protocols does Cisco IM and Presence use to authen...
Question 49: When a user dials a number with a phone that is registered t...
Question 50: During the Cisco IP Phone registration process the TFTP down...
Question 51: Which application traffic does the DiffServ AF41 class accor...
Question 52: what causes poor voice quality and video pixelization in a v...
Question 53: What is the maximum DNS SRV entries that should be defined i...
Question 54: What is the function of the Cisco Unity Connection Call Hand...
Question 55: What are two differences between media flow-around and media...
Question 56: An administrator would like to set several Cisco Jabber conf...
Question 57: Given this H.323 gateway configuration and using cisco best ...
Question 58: What is required for Cisco UCM to accept SIP calls with a UR...
Question 59: Refer to the exhibit. (Exhibit) AN engineer configures a VoI...
Question 60: An engineer with ID012345678 must build an international dia...
Question 61: What are two key features of the Expressway series? (Choose ...
Question 62: A customer wants to deploy Cisco Jabber Phone Mode with cont...
Question 63: Which two DNS records must be created to configure Service D...
Question 64: Which two configuration elements are part of the Cisco Unifi...
Question 65: A DTMF mismatch is occurring between an MGCP gateway registe...
Question 66: Which two functionalities does Cisco Expressway provide in t...
Question 67: Which protocol does prime collaboration Assurance use to pol...
Question 68: In the cisco expressway solution, which two features does mo...
Question 69: Refer to the exhibit. (Exhibit) The translation rule is conf...
Question 70: Refer to the exhibit. (Exhibit) A call is failing to establi...
Question 71: Which issue cause slips on a PRI?...
Question 72: An engineer troubleshoots a Cisco Jabber login problem on a ...
Question 73: An engineer is configuring a BOT device for a Jabber user in...