<< Prev Question Next Question >>

Question 13/47

Regarding SIP integrations with Cisco Unified Communications Manager, if the Cisco Unity Connection is configured to listen for incoming IPv4 and IPv6 traffic, how should the addressing mode be set up in the Cisco Unity Connection?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (47q)
Question 1: Multiple router patterns match a number. How does Cisco Unif...
Question 2: When a phone is registered over Mobile and Remote Access, wh...
Question 3: A user reports transfer failures from an IP phone for calls ...
Question 4: According to the QoS Baseline Model, drag and drop the appli...
Question 5: Which Cisco Unified Communications Manager service parameter...
Question 6: Refer to the exhibit. (Exhibit) A call is failing to establi...
Question 7: How does Cisco Unified Communications Manager perform a digi...
Question 8: An engineer implements QoS in the enterprise network. Which ...
Question 9: Which two types of device are supported by the Bulk Administ...
Question 10: An engineer is configuring a Cisco Unified Border Element to...
Question 11: An engineer must configure an MGCP gateway and register it t...
Question 12: When a 8800 series phone is registered over MRA, where does ...
Question 13: Regarding SIP integrations with Cisco Unified Communications...
Question 14: Which description of the Mobile and Remote Access feature is...
Question 15: An administrator is trying to change the default LINECODE fo...
Question 16: What is a characteristic of video traffic that governs QoS r...
Question 17: A DTMS mismatch is occurring between an MGCP gateway registe...
Question 18: Which endpoint feature is supported using Mobile and Remote ...
Question 19: Which action is required if an engineer wants to have Cisco ...
Question 20: Where is the default for maximum session Bit Rate for a regi...
Question 21: Given this H.323 gateway configuration and using cisco best ...
Question 22: A Cisco IP Phone 7841 that is registered to a Cisco Unified ...
Question 23: A user dials 9011841234567 to reach Vietnam. Which steps sen...
Question 24: Which two DNS records must be created to configure Service D...
Question 25: Which configuration tells a switch port to send Cisco Discov...
Question 26: How can an administrator stop Cisco Unified Communications M...
Question 27: An engineer is designing a high availability and failover so...
Question 28: Which configuration step is necessary for a Cisco SIP phone ...
Question 29: On which protocol and port combination does Cisco prime coll...
Question 30: Which issue can occur if QoS is not Deployed on a Cisco Coll...
Question 31: An administrator recently upgraded a Cisco Webex DX80 throug...
Question 32: After an engineer runs the utils ntp status command on the C...
Question 33: Which access control group is required on an end user to all...
Question 34: An engineer is configuring a BOT device for a Jabber user in...
Question 35: Refer the exhibit. (Exhibit) Given this "debug isdn q921" ou...
Question 36: What are two key features of the Expressway series? (Choose ...
Question 37: Which field of a Real-Time Transport Protocol packet allows ...
Question 38: Which two protocols does Cisco IM and Presence use to authen...
Question 39: When a remote office location is set up with limited bandwid...
Question 40: Which user group is targeted by MRA services?...
Question 41: Refer to the exhibit. (Exhibit) When a UC Administrator is t...
Question 42: What is the correct statement about CUCM and Cisco IM&amp;P ...
Question 43: Which issue cause slips on a PRI?...
Question 44: Which SNMP service must be activated manually on the Cisco U...
Question 45: Refer to the exhibit. (Exhibit) An engineer is troubleshooti...
1 commentQuestion 46: How many DNS SRV entries can be defined in the SIP trunk des...
Question 47: What is the function of the Cisco Unity Connection Call Hand...