A Cisco MDS 9000 Series Switch is configured for SAN Analytics and SAN Telemetry Streaming. An engineer must enable analytics for NVMe on interfaces in the range of fc1/1-12. Due to a large amount of traffic generated in the SAN environment, the data must be collected at regular intervals of 60 seconds from ports fc 1-12 and then for ports fc13-24 for the next 60 seconds. Ports in the range fc4/13-14 were already enabled for analytics. Which set of commands must be used to meet these requirements?

Correct Answer: A
The commands under option A enable analytics for NVMe on interfaces in the range of fc1/1-12 with port-sampling module 4 size 12 interval 60 analytics nvme. This meets the requirement of collecting data at regular intervals of 60 seconds from ports fc1/1-12. References:
* Cisco MDS 9000 Series NX-OS Interfaces Configuration Guide, Release 8.x - Configuring SAN
* Analytics and Telemetry Streaming [Cisco MDS 9000 NX-OS and SAN-OS Software], Configuring SAN Analytics and Telemetry Streaming, Configuring SAN Analytics
* Cisco MDS 9000 Series NX-OS Interfaces Configuration Guide, Release 8.x - Configuring SAN Analytics and Telemetry Streaming [Cisco MDS 9000 NX-OS and SAN-OS Software], Configuring SAN Analytics and Telemetry Streaming, Configuring Port Sampling