<< Prev Question Next Question >>

Question 18/105

Which protocol does a Cisco MPLS TE tunnel use to maintain paths within the core?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (105q)
Question 1: Refer to the exhibit. The USER mat is connecting an applicat...
Question 2: Refer to the exhibit. What does this value mean when it is r...
Question 3: Refer to the exhibit. A network administrator implemented MP...
Question 4: Which MPLS design attribute can you use to provide Internet ...
Question 5: Refer to the exhibit. Assume all other configurations are co...
Question 6: Refer to the exhibit. Which condition must be met by the OSP...
Question 7: Refer to the exhibit. What does the REST API command do? (Ex...
Question 8: Egress PE NAT is being used via a single centralized router ...
Question 9: Refer to the exhibit. An engineer is configuring router R1 f...
Question 10: Refer to the exhibit. Which task completes the configuration...
Question 11: Why do packet loops occur during the configuration of BlDlR-...
Question 12: Refer to the exhibit. A network engineer must meet these req...
Question 13: You are testing the capabilities of MPLS OAM ping. Which sta...
Question 14: Refer to the exhibit. An engineer must configure router R2 a...
Question 15: Refer to the exhibit A network engineer is in the process of...
Question 16: Refer to the exhibit. An engineer configured multicast routi...
Question 17: Refer to the exhibit. Which effect of this configuration is ...
Question 18: Which protocol does a Cisco MPLS TE tunnel use to maintain p...
Question 19: Refer to the exhibit. A network operator needs to shut down ...
Question 20: The network-engineering team of a service provider is integr...
Question 21: Refer lo the exhibit. An engineer working for private Servic...
Question 22: Refer to the exhibit. The network engineer who manages ASN 6...
Question 23: An engineer implemented LDP protocol on the ISP network. The...
Question 24: Refer to the exhibit. An engineer is updating this network t...
Question 25: The engineering team at a large ISP has been alerted a custo...
Question 26: Which two PHY modes are available to implement an IOS XR Gig...
Question 27: Refer to the exhibit. BGPsec is implemented on R1. R2. R3. a...
Question 28: A customer requests that sites are connected over an MPLS ba...
Question 29: What is the difference between SNMP and model-driven telemet...
Question 30: What is the characteristic of the Tl-LFA?...
Question 31: What is a role of NSO?
Question 32: An engineer working for a private service provider with empl...
Question 33: Refer to me exhibit. A network engineer notices PE-21 conver...
Question 34: You are configuring MPLS traffic-engineering tunnels in the ...
Question 35: Refer to me exhibit. A network operator recently configured ...
Question 36: Refer to the exhibit. An engineer is securing a customer's n...
Question 37: Drag and Drop Question Drag and drop the NAT64 descriptions ...
Question 38: An engineer working for a private telecommunication company ...
Question 39: Refer to the exhibit. A Cisco engineer is implementing gRPC ...
Question 40: Which function of the LSA packet pacing feature is true?...
Question 41: A router is configured to perform MPLS LDP graceful restart....
Question 42: Refer to the exhibit.A network engineer is implementing a st...
Question 43: Refer to the exhibit. Routers R2 and R3 are Level 1/Level 2 ...
Question 44: Refer to the exhibit. An engineer is preparing to implement ...
Question 45: Which type of attack is a protocol attack?...
Question 46: Refer to the exhibit. On R1, which output does the show isis...
Question 47: A network engineer is configuring a router to send multicast...
Question 48: Refer to the exhibit. After implementing a new design for th...
Question 49: An engineer is developing a configuration script to enable d...
Question 50: Refer to the exhibit. A network administrator is implementin...
Question 51: Refer to the exhibit. Which purpose of implementing NSF with...
Question 52: Which statement about Network Services Orchestrator (NSO) is...
Question 53: On the BGP Best Path Selection, when two external paths from...
Question 54: A network engineer is implementing BFD configuration changes...
Question 55: Refer to the exhibit. A network engineer is configuring MPLS...
Question 56: Refer to the exhibit. Which effect of this configuration is ...
Question 57: Refer to the exhibit. A network engineer is implementing QoS...
Question 58: How can a network administrator secure rest APIs?...
Question 59: A remote operation center is deploying a set of l-BGP and E-...
Question 60: When configuring traffic engineering tunnels in Cisco MPLS c...
Question 61: Refer to the exhibit. What reestablishes the OSPF neighbor r...
Question 62: Refer to the exhibit. Which information is provided for trac...
Question 63: Refer to the exhibit. Router 1 is missing the route for the ...
Question 64: Why do Cisco MPLS TE tunnels require a link-state routing pr...
Question 65: A network engineer must implement SNMPv2 with these paramete...
Question 66: Refer to the exhibit. A network engineer is implementing an ...
Question 67: Which two features must be configured to perform AToM NSF? (...
Question 68: Refer to the exhibit. A network engineer is deploying SNMP c...
Question 69: Refer to the exhibit. EIGRP a running across the core lo exc...
Question 70: Which component is similar to an EVPN instance?...
Question 71: network the network is already using PlM-SM with a static RP...
Question 72: Refer to the exhibit. What is the result of this configurati...
Question 73: Refer to the exhibit. Which show command should be implement...
Question 74: How can shared services in an MPLS Layer 3 VPN provide Inter...
Question 75: Refer to the exhibit. An engineer is configuring two routers...
Question 76: Refer to the exhibit. Which effect of this configuration is ...
Question 77: Refer to the exhibit. What does the script configure? (Exhib...
Question 78: Refer to the exhibit. The network team must implement MPLS L...
Question 79: Refer to the exhibit. A network operator has two IPv4 and IP...
Question 80: Refer to the exhibit. An ISP provides shared VoIP Extranet s...
Question 81: Refer to the exhibit. This configuration is being applied on...
Question 82: Drag and Drop Question Drag and drop the functionalities fro...
Question 83: Which module refers to the network automation using Ansible?...
Question 84: Which action enables an IPv6 multicast router on a subnet wi...
Question 85: Refer to the exhibit. If router A is the RP, which PIM mode ...
Question 86: Which additional feature does MPLS DiffServ tunneling suppor...
Question 87: Which control plane protocol is used between Cisco SD-WAN ro...
Question 88: Drag and Drop Question Drag and drop the multicast concepts ...
Question 89: Which statement about VRF Lite is true?...
Question 90: Refer to the exhibit. What does the REST API command do? (Ex...
Question 91: Refer to the exhibit. Which configuration prevents the OSPF ...
Question 92: On Cisco IOS XR devices, which action improves failure react...
Question 93: A network engineer is configuring Flexible NetFlow and enter...
Question 94: Which are the two limitations of the predefined NAT solution...
Question 95: Refer to the exhibit. All listed MPLS TE tunnels have the au...
Question 96: Refer to the exhibit. An engineer is reviewing the BGP confi...
Question 97: After a series of unexpected device failures on the network....
Question 98: Refer to the exhibit. While troubleshooting the network, a n...
Question 99: In an MPLS VPN environment, the QoS making over the MPLS bac...
Question 100: Refer to the exhibit. An engineer is preparing to implement ...
Question 101: Refer to the exhibit. An engineer applied a gRPC dial-in con...
Question 102: Which two tasks must you perform when you implement LDP NSF ...
Question 103: A network engineer is deploying VPLS configuration between m...
Question 104: What is a characteristic of prefix segment identifier?...
Question 105: An engineer is implementing a router redistribution within B...