<< Prev Question Next Question >>

Question 12/99

An engineer working for a private telecommunication company with an employe id:3948:613 needs to limit the malicious traffic on their network. Which configuration must the engineer use to implement URPF loose mode on the GigabitEthernet0/1 interface?
A)

B)

C)

D)

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (99q)
Question 1: An engineer a cisco MPLS tunnel to improve the streaming exp...
1 commentQuestion 2: Refer to Exhibit. (Exhibit) A network engineer is trying to ...
Question 3: A network engineer must configure a router for Flexible NetF...
Question 4: While implementing TTL security, you issue the PE(config-rou...
Question 5: Which statement about the Cisco MPLS TE forwarding adjacency...
Question 6: Refer to the exhibit. The network team must implement MPLS L...
Question 7: Refer to the exhibit: (Exhibit) Which command is used to com...
Question 8: Refer to the exhibit. (Exhibit) Which two topology changes h...
Question 9: Refer to the exhibit. (Exhibit) The network engineer who man...
1 commentQuestion 10: Refer to the exhibit. (Exhibit) ASN 64501 currently reaches ...
Question 11: Refer to the exhibit. (Exhibit) An engineer began to configu...
Question 12: An engineer working for a private telecommunication company ...
Question 13: Which additional feature does MPLS DiffServ tunneling suppor...
Question 14: Refer to the exhibit: (Exhibit) R1 is connected to two servi...
Question 15: An engineer working for a private service provider with empl...
Question 16: Which utility can you use to locate MPLS faults?...
Question 17: Refer to the exhibit: (Exhibit) Router 1 was experiencing a ...
Question 18: Refer to the exhibit. (Exhibit) A network engineer is config...
Question 19: Refer to the exhibit. (Exhibit) A network administrator is i...
Question 20: When Cisco lOS XE REST API uses HTTP request methods what is...
Question 21: Refer to the exhibit. ISP ASN 65100 provides internet servic...
Question 22: What is the function of the FEC field within the OTN signal ...
Question 23: Which task must be performed first to Implement BFD in an IS...
Question 24: A company needs to improve the use of the network resources ...
Question 25: The administrator of a small company network notices that in...
Question 26: Refer to the exhibit: (Exhibit) An engineer is preparing to ...
Question 27: Refer to the exhibit. (Exhibit) An engineer configured multi...
Question 28: Refer to me exhibit. An engineer started lo configure a rout...
Question 29: Refer to the exhibit. (Exhibit) R101 is peering with R102 an...
Question 30: Refer to the exhibit: (Exhibit) Export statistics received d...
Question 31: You are configuring MPLS traffic-engineering tunnels in the ...
Question 32: Which configuration modifies Local Packet Transport Services...
Question 33: Refer to the exhibit. (Exhibit) An ISP provides shared VoIP ...
Question 34: Refer to the exhibit. (Exhibit) A network operator has two I...
Question 35: Refer to the exhibit: (Exhibit) Which purpose of implementin...
Question 36: What do Ansible and Salt Stack have in common?...
Question 37: Refer to the exhibit. (Exhibit) An engineer has started to c...
Question 38: How does model-driven telemetry use YANG?...
Question 39: Refer to the exhibit. (Exhibit) What does the number 2 mean ...
Question 40: Refer to the exhibit. (Exhibit) A network operator must conf...
Question 41: A network engineer is adding 10Gbps link to an existing 2X1G...
Question 42: An network engineer is deploying VRF on ASBR router R1. The ...
Question 43: Refer to the exhibit. After a networking team configured thi...
Question 44: Which additional configuration is required for NetFlow to pr...
Question 45: Refer to the exhibit. (Exhibit) What is the effect of this c...
Question 46: Refer to the exhibit. (Exhibit) To protect in-band managemen...
Question 47: Refer to the exhibit: (Exhibit) What does this value mean wh...
Question 48: What is a constraint of Cisco MPLS TE tunnel configurations?...
Question 49: How can a network administrator secure rest APIs?...
Question 50: Which two PHY modes are available to implement an IOS XR Gig...
Question 51: Refer to the exhibit: (Exhibit) Which statement describes th...
Question 52: Refer to the exhibit. An engineer is configuring IS-IS on IS...
Question 53: A network engineer must implement SNMPv2 with these paramete...
Question 54: Refer to the exhibit. (Exhibit) A network operator working f...
Question 55: Drag and drop the descriptions from the left onto the corres...
Question 56: Refer to the exhibit. (Exhibit) Router 1 and router 2 are ru...
Question 57: An engineer must extend Layer 2 Between two campus sites con...
Question 58: Which configuration mode do you use to apply the mpls Idp gr...
Question 59: Which component is similar to an EVPN instance?...
Question 60: A network administrator is planning a new network with a seg...
Question 61: Refer to the exhibit. (Exhibit) A network engineer is implem...
Question 62: Drag and drop the NAT64 descriptions from the left onto the ...
Question 63: You are writing an RPL script to accept routes only from cer...
Question 64: Which statement about Network Services Orchestrator (NSO) is...
Question 65: Refer to the exhibit. (Exhibit) What type of configuration i...
Question 66: Refer to the exhibit. (Exhibit) An engineer is reviewing the...
Question 67: What is a primary benefit of IPoATM or MPLS over ATM backbon...
Question 68: Refer to the exhibit: (Exhibit) Based on the show/ command o...
Question 69: An engineer is implementing MPLS to monitor within the MPLS ...
Question 70: An engineer must apply an 802.1ad-compliant configuration to...
Question 71: Refer to the exhibit. (Exhibit) CE1 and CE2 require connecti...
Question 72: How do intent APIs make it easier for network engineers to d...
Question 73: Refer to the exhibit. (Exhibit) An engineer is trying to imp...
Question 74: Refer to the exhibit. (Exhibit) Router 1 is missing the rout...
Question 75: Refer to the exhibit. Which additional configuration must an...
Question 76: Refer to me exhibit. (Exhibit) A network engineer notices PE...
Question 77: What do Chef and Puppet have in common?...
Question 78: Which feature will an operator use while implementing MPLS T...
Question 79: Drag and drop the OSPF area types from the left onto the cor...
Question 80: When configuring traffic engineering tunnels in Cisco MPLS c...
Question 81: Why do Cisco MPLS TE tunnels require a link-state routing pr...
Question 82: Refer to the exhibit. Router BRDR-1 is configured to receive...
Question 83: A network engineer has configured TE tunnels in the MPLS pro...
Question 84: A network operator working for a telecommunication company w...
Question 85: Refer to the exhibit. (Exhibit) If RC is a stub router, whic...
Question 86: Drag and drop the functionalities from the left onto the cor...
Question 87: Refer to the exhibit: (Exhibit) Which two statements about t...
Question 88: Refer to the exhibit. (Exhibit) An engineer is configuring a...
Question 89: Which two tasks must an engineer perform when implementing L...
Question 90: Refer to the exhibit. (Exhibit) An engineer is configuring p...
Question 91: How much must the MTU be increased when configuring the 802....
Question 92: Refer to the exhibit. (Exhibit) Which configuration must be ...
Question 93: Refer to the exhibit: (Exhibit) What does the REST API comma...
Question 94: An engineer is setting up overlapping VPNs to allow VRF ABC ...
Question 95: Refer to the exhibit. (Exhibit) A network engineer must meet...
Question 96: You are testing the capabilities of MPLS OAM ping. Which sta...
Question 97: Refer to the exhibit. (Exhibit) A network engineer is deploy...
Question 98: What is the difference between SNMP and model-driven telemet...
Question 99: Refer to the exhibit. (Exhibit) AN engineer is configuring s...