350-401 Exam Dumps | Drag and drop the snippets onto the blanks within the code to construct a script that brings up the failover

<< Prev Question Next Question >>

Question 122/187

Drag and drop the snippets onto the blanks within the code to construct a script that brings up the failover Ethernet port if the primary port goes down and also shuts down the failover port when the primary returns to service. Not all options are used.

Question List (187q): Question 1: What is one characteristic of an AP that is operating in Mob...; Question 2: SIMULATION (Exhibit); Question 3: What are two characteristics of a directional antenna? (Choo...; Question 4: Which tag defines the properties to be applied to each speci...; Question 5: Which architectural component enables a zero-trust security ...; Question 6: Which method requires a client to authenticate and has the c...; Question 7: Whichtwo benefits result from a network design mat uses smal...; Question 8: Which task Is mandatory when provisioning a device through t...; Question 9: Drag and drop the automation characteristics from the left o...; Question 10: Which solution supports end-to-end line-rate encryption betw...; Question 11: Which two sources cause interference for Wi-Fi networks? (Ch...; Question 12: Drag and drop the characteristics from the left into the orc...; Question 13: Refer to the exhibit. (Exhibit) Based on the configuration i...; Question 14: Which language defines the structure or modelling of data fo...; Question 15: Which three methods does Cisco Catalyst Center (formerly DNA...; Question 16: Refer to the exhibit. (Exhibit) Refer to the exhibit. Which ...; Question 17: Which characteristic applies to Cisco SD-Access?...; Question 18: Refer to the exhibit. (Exhibit) Refer to the exhibit. What i...; Question 19: Which two protocols are used with YANG data models? (Choose ...; Question 20: In a Cisco SD-Access network architecture, which access laye...; Question 21: Which method creates an EEM applet policy that is registered...; Question 22: Drag and drop the code snippets from the bottom onto the bla...; Question 23: Which two mechanisms are used with OAuth 2.0 for enhanced va...; Question 24: Refer to the exhibit. A network engineer must configure NETC...; Question 25: What is a client who is running 802.1x for authentication re...; Question 26: Which network design principle should be followed to improve...; Question 27: Refer to the exhibit. (Exhibit) Refer to the exhibit. The ex...; Question 28: Refer to the exhibit. (Exhibit) Refer to the exhibit. A netw...; Question 29: Drag and drop the snippets onto the blanks within the code t...; Question 30: Which NGFW mode block flows crossing the firewall?...; Question 31: How does Cisco DNA Center perform a network discovery?...; Question 32: Which API does Cisco DNA Center use to retrieve information ...; Question 33: Refer to the exhibit. (Exhibit) Refer to the exhibit An engi...; Question 34: Drag and drop the command snippets from the right onto the b...; Question 35: Which solution supports end to end line-rate encryption betw...; Question 36: SIMULATION (Exhibit); Question 37: Refer to the exhibit. (Exhibit) Refer to the exhibit. How sh...; Question 38: Which protocol does Cisco Catalyst Center (formerly DNA Cent...; Question 39: Which method does FastLocate use to collect location-based i...; Question 40: Refer to the exhibit. (Exhibit) Reler to the exhibit. An eng...; Question 41: What is the function of the statement "import actions" in th...; Question 42: Refer to the exhibit. (Exhibit) Refer to lhe exhibit. An eng...; Question 43: SIMULATION (Exhibit); Question 44: SIMULATION (Exhibit); Question 45: SIMULATION (Exhibit); Question 46: What is an advantage of utilizing data models in a multivend...; Question 47: Drag and drop the DHCP messages that are exchanged between a...; Question 48: Which feature is needed to maintain the IP address of a clie...; Question 49: What is a characteristics of a type 1 hypervisor?...; Question 50: Which two southbound interfaces originate from Cisco Catalys...; Question 51: What is the responsibility of a secondary WLC?...; Question 52: What is used to measure the total output energy of a Wi-Fi d...; Question 53: Refer to the exhibit. (Exhibit) Refer to the exhibit. What i...; Question 54: Refer to the exhibit. (Exhibit) What does the snippet of cod...; Question 55: Which characteristic applies to the endpoint security aspect...; Question 56: Drag and drop the solutions that comprise Cisco Cyber Threat...; Question 57: What is one primary REST security design principle?...; Question 58: What is required for a VXLAN tunnel endpoint to operate?...; Question 59: How do FHRPs differ from SSO?; Question 60: Refer to the exhibit. (Exhibit) Refer to the exhibit. What i...; Question 61: SIMULATION (Exhibit); Question 62: Refer to the exhibit. (Exhibit) Refer to the exhibit. Authen...; Question 63: What is a characteristic of omnidirectional antennas?...; Question 64: Refer to the exhibit. (Exhibit) Which JSON syntax is derived...; Question 65: A company hires a network architect to design a new OTT wire...; Question 66: When deploying Cisco SD-Access Fabric APs, where does the da...; Question 67: Why does the vBond orchestrator have a public IP? Why does t...; Question 68: SIMULATION (Exhibit); Question 69: Which function does a Cisco SD-Access extended node perform?...; Question 70: Which AP mode allows an engineer to scan configured channels...; Question 71: Which two characteristics apply to Type 1 hypervisors? (Choo...; Question 72: Why would an architect use an OSPF virtual link?...; Question 73: Which tool functions in a push model, supports languages lik...; Question 74: What does the statement print(format(0.8, \0%')) display?...; Question 75: SIMULATION (Exhibit); Question 76: What is one characteristic of Cisco SD-Access networks?...; Question 77: Drag and drop the command snippets from the right onto the b...; Question 78: What is a TLOC in a Cisco Catalyst SD-WAN deployment?...; Question 79: What is the primary responsibility of the vBond orchestrator...; Question 80: A customer requires their wireless data traffic to egress at...; Question 81: Refer to the exhibit. (Exhibit) Refer to the exhibit. A cust...; Question 82: What is a characteristic of a traditional WAN?...; Question 83: A script contains the statement *white loop != 999 ' Which v...; Question 84: Which nodes require VXLAN encapsulation support In a Cisco S...; Question 85: Which technology is the Cisco SD-Access control plane based ...; Question 86: Which message type is valid for IGMPv3?...; Question 87: Which two new security capabilities are introduced by using ...; Question 88: Which new security enhancement is introduced by deploying a ...; Question 89: Which IEEE standard provides the capability to permit or den...; Question 90: Refer to the exhibit. (Exhibit) Refer to the exhibit. Which ...; Question 91: What is a client who is using 802.1x for authentication refe...; Question 92: Which feature is available to clients using layer 2 roaming ...; Question 93: How is a data modelling language used?...; Question 94: Which function is performed by vSmart in the Cisco Catalyst ...; Question 95: Which A record type should be configured for access points t...; Question 96: On which protocol or technology is the fabric data plane bas...; Question 97: Refer to the exhibit. (Exhibit) Refer to the exhibit. An eng...; Question 98: A customer has several small branches and wants to deploy a ...; Question 99: Drag and drop the code snippets from the bottom onto the bla...; Question 100: In a virtual environment, what is a VMDK file?...; Question 101: Which technology is the Cisco SD-Access control plane based ...; Question 102: Which Cisco WLC feature allows a wireless device to perform ...; Question 103: Drag and drop the snippets onto the blanks within the code t...; Question 104: In a Cisco SD-WAN solution, which two functions are performe...; Question 105: Refer to the exhibit. (Exhibit) Refer to the exhibit. An eng...; Question 106: What is used by vManage to interact withCiscoSD-WAN devices ...; Question 107: Drag and drop the characteristics from the left onto the orc...; Question 108: SIMULATION (Exhibit); Question 109: In a wireless network environment, which measurement compare...; Question 110: Refer to the exhibit. (Exhibit) Which action must be taken t...; Question 111: SIMULATION (Exhibit); Question 112: SIMULATION (Exhibit); Question 113: What is a characteristic of VRRP?...; Question 114: Which technique is used to protect end user devices and data...; Question 115: Refer to the exhibit. A customer reports occasional brief au...; Question 116: What is a TLOC in a Cisco SD-WAN deployment?...; Question 117: Drag and drop the characteristics of Cisco Catalyst SD-WAN f...; Question 118: Which type of tunnel is required between two WLCs to enable ...; Question 119: Which data is properly formatted with JSON? (Exhibit)...; Question 120: In a campus network design, what are two benefits of using B...; Question 121: Which device is responsible for finding EID-to-RLOC mappings...; Question 122: Drag and drop the snippets onto the blanks within the code t...; Question 123: Drag and drop the code snippets from the bottom onto the bla...; Question 124: An engineer must create a script to append and modify device...; Question 125: Which WLC discovery method uses CISCO-CAPWAP-CONTROLLER as a...; Question 126: Which technology collects location information through data ...; Question 127: Which method ensures the confidentiality of data exchanged o...; Question 128: Which protocol does Cisco Catalyst SD-WAN use to protect con...; Question 129: Which component of the Cisco Cyber Threat Defense solution p...; Question 130: Which type of roaming event occurs when a client roams acros...; Question 131: Refer to the exhibit. (Exhibit) Refer to the exhibit. A POST...; Question 132: Which feature allows HSRP to failover from the active route ...; Question 133: At which plane does vBond operate in Cisco SD-WAN solutions?...; Question 134: What are two benefits of virtualizing the server with the us...; Question 135: Which feature allows clients to perform Layer 2 roaming betw...; Question 136: Refer to the exhibit. (Exhibit) Refer to the exhibit. Which ...; Question 137: Why are stateless calls executed by REST API useful in cloud...; Question 138: An engineer is configuring a new SSID to present users with ...; Question 139: Refer to the exhibit. (Exhibit) Refer to the exhibit. What d...; Question 140: Which two pieces of information are necessary to compute SNR...; Question 141: What is YANG used for?; Question 142: Which unit of measure is used to measure wireless RF SNR?...; Question 143: What is a characteristic of Layer 3 roaming?...; Question 144: What is the calculation that is used to measure the radiated...; Question 145: An engineer is configuring RADIUS-Based Authentication with ...; Question 146: Refer to the exhibit. (Exhibit) Refer to the exhibit. The ke...; Question 147: To support new clients in the environment, an engineer must ...; Question 148: Which two operations are valid for RESTCONF? (Choose two)...; Question 149: Which measurement is used from a post wireless survey to dep...; Question 150: Which authorization framework gives third-party applications...; Question 151: Drag and drop the wireless elements on the left to their def...; Question 152: SIMULATION (Exhibit); Question 153: What is a Type 1 hypervisor?; Question 154: What is two characteristic of Cisco DNA Center and vManage n...; Question 155: Refer to the exhibit. (Exhibit) Refer to the exhibit. A cust...; Question 156: SIMULATION (Exhibit); Question 157: Drag and drop the Cisco Catalyst Center (formerly DNA Center...; Question 158: What happens when a FlexConnect AP changes to standalone mod...; Question 159: A wireless administrator must create a new web authenticatio...; Question 160: An engineer must configure a new WLAN that supports 802.11r ...; Question 161: An engineer must configure a new 6 Ghz only SSID on a cisco ...; Question 162: In a wireless Cisco SD-Access deployment, which roaming meth...; Question 163: What is a characteristic of a virtual machine?...; Question 164: Which two Cisco SD-Access components provide communication b...; Question 165: SIMULATION (Exhibit); Question 166: SIMULATION (Exhibit); Question 167: Which First Hop Redundancy Protocol should be used to meet a...; Question 168: Which AP mode allows administrators to generate pcap files t...; Question 169: What is the API keys option for REST API authentication?...; Question 170: What is one benefit of adopting a data modeling language?...; Question 171: What is a fact about Cisco EAP-FAST?...; Question 172: Which language can be used to model configuration and state ...; Question 173: Drag and drop the code snippets from the bottom onto blanks ...; Question 174: Refer to the exhibit. (Exhibit) Refer to the exhibit Which c...; Question 175: What is one main REST security design principle?...; Question 176: Which security feature does stateless authentication and aut...; Question 177: Which protocol is used by vmanage to push centralized polici...; Question 178: What is one method for achieving REST API security?...; Question 179: How does SSO work with HSRP to minimize network disruptions?...; Question 180: What is used by vManage to interact with Cisco SD-WAN device...; Question 181: Refer to the exhibit. (Exhibit) An engineer is installing a ...; Question 182: Drag and drop characteristics of PIM dense mode from the lef...; Question 183: Refer to the exhibit. (Exhibit) Refer to the exhibit. Based ...; Question 184: When a wireless client roams between two different wireless ...; Question 185: Which two conditions occur when the primary route processor ...; Question 186: What are two device roles in the Cisco SD-Access fabric? (Ch...; Question 187: What is the measure of the difference between the received s...

Question 122/187

LEAVE A REPLY

Download PDF File