<< Prev Question Next Question >>

Question 88/116

Refer to the exhibit.

An administrator is troubleshooting a situation where a call placed from a phone registered to Cisco Unified Communications Manager does not complete. The administrator wants to use the Dialed Number Analyzer on Cisco Unified CM to check which translation pattern the call is matching. However, when logging in to Cisco Unified Serviceability there is no option for Dialed Number Analyzer under the tool menu. Which two steps must be performed to resolve this issue? (Choose two.)

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (116q)
Question 1: A company wants to optimize the ability to answer the phone ...
Question 2: An administrator is configuring a SIP trunk to an ITSP. The ...
Question 3: Refer to the exhibit. (Exhibit) DN 1003 was the last to ring...
Question 4: When a third-party SIP Phone System is dialed inbound across...
Question 5: Signal number reach call phone that not answered are leaving...
Question 6: Refer to the exhibit. (Exhibit) A collaboration engineer inv...
Question 7: An engineer must implement call restriction to toll-free num...
Question 8: An engineer needs to deploy Cisco Extension Mobility. The en...
Question 9: Refer to the exhibit. (Exhibit) Which INVITE is sent to 10.1...
Question 10: For s SIP to SIP call flow, when does Cisco Unified Border E...
Question 11: Refer to the exhibit. (Exhibit) Refer to the exhibit. An eng...
Question 12: Which services are needed to successfully implement Cisco Ex...
Question 13: A user has a problem calling a specific PSTN number. An engi...
Question 14: In Cisco Unified Communications Manager globalized call rout...
Question 15: Refer to the exhibit. (Exhibit) Within the North American Nu...
Question 16: A company with only 15 users needs to have a phone system wi...
Question 17: An administrator is configuring Cisco UCM and wants all inbo...
Question 18: An administrator configured Extension Mobility on Cisco UCM....
Question 19: An engineer is configuring a Cisco UCM solution. The require...
Question 20: Refer to the exhibit. (Exhibit) An engineer is troubleshooti...
Question 21: When configuring hunt groups, where does the administrator a...
Question 22: Configure Call Queuing in Cisco Unified Communications Manag...
Question 23: Alter a new SIP trunk is configured from a third-party SIP t...
Question 24: Which elements does Cisco cloud mobility for collaboration i...
Question 25: What is a capability of the gateway-preferred, network-based...
Question 26: Refer to the exhibit. (Exhibit) Refer to the exhibit. A coll...
Question 27: Refer to the exhibit. (Exhibit) Which change to the translat...
Question 28: An engineer must route all SIP calls in the form of &lt;user...
Question 29: ABC company has decided to implement hunt groups to help dis...
Question 30: The same digits sent in OOB, as well as in-band on the Cisco...
Question 31: Which two statements are correct with respect to the Client ...
Question 32: Which action is correct with respect to toll fraud preventio...
Question 33: Refer to the exhibit. (Exhibit) Outbound calls to the servic...
Question 34: A new deployment is using MVA for a specific user on the sal...
Question 35: Cisco SIP IP telephony is implemented on two floors of your ...
Question 36: Where is the dtmf-relay command configured on Cisco Unified ...
Question 37: Refer to the exhibit. (Exhibit) The Cisco Unified Border Ele...
Question 38: An organization needs to ensure that the Cisco UCM can provi...
Question 39: Which built-in bridge configuration option can be set on the...
Question 40: Refer to the exhibit. (Exhibit) How many maximum hops can an...
Question 41: Refer to the exhibit. (Exhibit) A user cannot call number 73...
Question 42: Refer to me exhibit. (Exhibit) A user cannot access Extensio...
Question 43: Refer to the exhibit. (Exhibit) Refer to the exhibit. How ma...
Question 44: An engineer is configuring Cisco UCM lo forward parked calls...
Question 45: Refer to the exhibit. (Exhibit) An engineer is troubleshooti...
Question 46: A single site reports that when they dial select numbers, th...
Question 47: Refer to the exhibit. (Exhibit) Refer to the exhibit. Users ...
Question 48: The administrator of ABC company is troubleshooting a one-wa...
Question 49: An engineer is configuring call queuing to place callers in ...
Question 50: When locations-based Call Admission Control denies the call,...
Question 51: How does an engineer globalize routing for ingress calls com...
Question 52: Refer to the exhibit. (Exhibit) A call mode through the Cisc...
Question 53: When route patterns are defined as precisely as possible on ...
Question 54: An administrator is configuring a cluster for ILS and wants ...
Question 55: Refer to the exhibit. (Exhibit) An administrator is troubles...
Question 56: Which set of commands binds SIP media and signaling to inter...
Question 57: Which two descriptions of the Standard Local Route Group dep...
Question 58: Refer to the exhibit. (Exhibit) Refer to the exhibit. An eng...
Question 59: A solution for a large company is being reconfigured to opti...
Question 60: An engineer must configure a Cisco UCM hunt list so that cal...
Question 61: An organization needs a solution to meet these requirements ...
Question 62: A company has users that frequently visit locations outside ...
Question 63: Refer to the exhibit. (Exhibit) Users report that outbound P...
Question 64: Refer to the exhibit. (Exhibit) An administrator just Implem...
Question 65: An administrator is attempting to set up redundancy to allow...
Question 66: An engineer Is configuring a Cisco Unified Border Element. T...
Question 67: An administrator is asked to configure egress call routing b...
Question 68: An administrator is implementing a new dial-plan on Cisco Un...
Question 69: Phone A calls to phone B, but phone B has Call Forward All s...
Question 70: Refer to the exhibit. (Exhibit) Refer to the exhibit. When s...
Question 71: An administrator is configuring a new deployment using Cisco...
Question 72: Refer to the exhibit. (Exhibit) Refer to the exhibit An engi...
Question 73: Refer to the exhibit. (Exhibit) An administrator is troubles...
Question 74: Some users report having issues dialing some external number...
Question 75: If all patterns below are configured in Cisco Unified Commun...
Question 76: An engineer is troubleshooting local ringback on a Cisco SIP...
Question 77: An administrator is troubleshooting call failures on an H.32...
Question 78: A customer has multisite deployments with a globalized dial ...
Question 79: Refer to the exhibit. (Exhibit) Refer to the exhibit. A coll...
Question 80: Refer to the exhibit. (Exhibit) An engineer is troubleshooti...
Question 81: Refer to the exhibit. (Exhibit) For long-distance calls, use...
Question 82: After configuring a Cisco CallManager Express with Cisco Uni...
Question 83: An engineer has two cisco UCM Clusters and wants to integrat...
Question 84: Refer to the exhibit. (Exhibit) Users report that when they ...
Question 85: A user's phone is already configured for Single Number Reach...
Question 86: Due to a shortage of physical interfaces on a device the adm...
Question 87: Drag and drop the commands from the bottom to the blanks in ...
Question 88: Refer to the exhibit. (Exhibit) An administrator is troubles...
Question 89: You see the voice register pool 1 command in your Cisco Unif...
Question 90: An engineer is configuring a Cisco Collaboration system for ...
Question 91: In Cisco UCM, which tool is used to check SIP traces?...
Question 92: Refer to the exhibit. (Exhibit) Refer to the exhibit. Calls ...
Question 93: Refer to the exhibit. (Exhibit) Refer to the exhibit. An adm...
Question 94: What are two configureation features of the Client matter co...
Question 95: An engineer needs to configure a translation pattern in Cisc...
Question 96: Refer to the exhibit. (Exhibit) The customer is troubleshoot...
Question 97: An administrator deployed a third-party H.323 gateway in a v...
Question 98: Refer to the exhibit. (Exhibit) A company needs to ensure th...
Question 99: Refer to the exhibit. (Exhibit) A user reports that when the...
Question 100: A collaboration engineer is configuring call pickup for a Ci...
Question 101: Refer to the exhibit. (Exhibit) Refer to the exhibit. An eng...
Question 102: Where on Cisco Unified Communications Manager do you configu...
Question 103: A company is using a H.323 gateway for PSTN calls from Cisco...
Question 104: Some Cisco mobility users cannot resume calls on the desk ph...
Question 105: The company Cisco UCM cluster has two different gateways for...
Question 106: Refer to the exhibit. (Exhibit) Refer to the exhibit. An eng...
Question 107: Drag and drop the steps from the left into the order to prov...
Question 108: After configuring a Cisco CallManager Express with Cisco Uni...
Question 109: CollabCorp is a global company with two clusters, emea.colla...
Question 110: Which configuration element of a hunt group allows for chang...
Question 111: An administrator sees the voice register pool 1 command in a...
Question 112: Which description of RTP timestamps or sequence numbers is t...
Question 113: An engineer has a hunt group with some overflow and many cal...
Question 114: An engineer set up and successfully tested a TEHO solution o...
Question 115: The company implemented Cisco Unified Mobility on the Cisco ...
Question 116: When configuring hunt groups, where do you add the individua...