300-710 Exam Dumps | An administrator is configuring the interface of a Cisco Secure Firewall Threat Defense device in a passive

Home
Cisco
Securing Networks with Cisco Firepower
Cisco.300-710.v2024-10-09.q147
Question 124

Valid 300-710 Dumps shared by ExamDiscuss.com for Helping Passing 300-710 Exam! ExamDiscuss.com now offer the newest 300-710 exam dumps, the ExamDiscuss.com 300-710 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 300-710 dumps with Test Engine here:

Access 300-710 Dumps Premium Version
(378 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 124/147

An administrator is configuring the interface of a Cisco Secure Firewall Threat Defense device in a passive IPS deployment. The device and interface have been identified. Which set of configuration steps of the administrator take next to complete the implementation?

A. Set the interface mode to passive. Associate the interface with a security zone. Set the MTU parameter.
Reset the interface.

B. Modify the interface to retransmit received traffic. Associate the interface with a security zone Enable the interface. Sat the MTU parameter.

C. Modify the interface to retransmit received traffic. Associate the interface with a security zone. Set the MTU parameter.

D. Set the interface mode to passive. Associate the interface with a security zone. Enable the interface. Set the MTU parameter.

Correct Answer: D

In a passive IPS deployment for a Cisco Secure Firewall Threat Defense (FTD) device, the administrator must configure the interface to operate in passive mode. This involves setting the interface mode, associating it with a security zone, enabling the interface, and setting the MTU parameter.
Steps:
* Set the interface mode to passive:
* In FMC, navigate to Devices > Device Management.
* Select the FTD device and configure the relevant interface.
* Set the interface mode to "Passive."
* Associate the interface with a security zone:
* Create or select an appropriate security zone.
* Assign the passive interface to this security zone.
* Enable the interface:
* Ensure the interface is enabled to receive traffic.
* Set the MTU parameter:
* Configure the Maximum Transmission Unit (MTU) parameter as required.
This ensures that the FTD device can inspect traffic passively without impacting the network flow.
References: Cisco Secure Firewall Management Center Device Configuration Guide, Chapter on Interface Settings

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (147q): Question 1: What is the role of the casebook feature in Cisco Threat Res...; Question 2: Which Cisco Firepower feature is used to reduce the number o...; Question 3: An engineer is setting up a remote access VPN on a Cisco FTD...; Question 4: Which Cisco Advanced Malware Protection for Endpoints policy...; Question 5: An engineer attempts to pull the configuration for a Cisco F...; Question 6: Cisco Security Analytics and Logging SaaS licenses come with...; Question 7: Which feature is supported by IRB on Cisco FTD devices?...; Question 8: An administrator is configuring their transparent Cisco FTD ...; Question 9: A cisco Secure firewall Threat Defence device is configured ...; Question 10: A security engineer must create a malware and file policy on...; Question 11: A network administrator wants to block traffic to a known ma...; Question 12: An engineer must investigate a connectivity issue from an en...; Question 13: An engineer defines a new rule while configuring an Access C...; Question 14: An administrator Is setting up a Cisco PMC and must provide ...; Question 15: An engineer must investigate a connectivity issue and decide...; Question 16: When a Cisco FTD device is configured in transparent firewal...; Question 17: An engineer is configuring two new Cisco FTD devices to repl...; Question 18: administrator is configuring SNORT inspection policies and i...; Question 19: An engineer is troubleshooting connectivity to the DNS serve...; Question 20: Network users experience issues when accessing a server on a...; Question 21: IT management is asking the network engineer to provide high...; Question 22: An engineer is configuring a custom application detector for...; Question 23: A network engineer must provide redundancy between two Cisco...; Question 24: A network administrator registered a new FTD to an existing ...; Question 25: A network engineer detects a connectivity issue between Cisc...; Question 26: An administrator is attempting to add a Cisco Secure Firewal...; Question 27: What is a valid Cisco AMP file disposition?...; Question 28: Which two routing options are valid with Cisco Firepower Thr...; Question 29: An organization is configuring a new Cisco Firepower High Av...; Question 30: An engineer must configure a Cisco FMC dashboard in a child ...; Question 31: Due to an Increase in malicious events, a security engineer ...; Question 32: An engineer is configuring URL filtering for a Cisco FTD dev...; Question 33: An engineer is investigating connectivity problems on Cisco ...; Question 34: Within an organization's high availability environment where...; Question 35: Which Cisco Firepower Threat Defense, which two interface se...; Question 36: An engineer configures an access control rule that deploys f...; Question 37: What is the advantage of having Cisco Firepower devices send...; Question 38: A network engineer must configure an existing firewall to ha...; Question 39: An administrator is attempting to remotely log into a switch...; Question 40: An engineer is attempting to create a new dashboard within t...; Question 41: An engineer must integrate a thud-party security Intelligenc...; Question 42: An organization created a custom application that is being f...; Question 43: Which two dynamic routing protocols are supported in Firepow...; Question 44: Which policy rule is included in the deployment of a local D...; Question 45: What is the RTC workflow when the infected endpoint is ident...; Question 46: An engineer integrates Cisco FMC and Cisco ISE using pxGrid....; Question 47: After deploying a network-monitoring tool to manage and moni...; Question 48: While configuring FTD, a network engineer wants to ensure th...; Question 49: An engineer is configuring a Cisco Secure Firewall Threat De...; Question 50: Which firewall design allows a firewall to forward traffic a...; Question 51: When deploying a Cisco ASA Firepower module, an organization...; Question 52: Which connector is used to integrate Cisco ISE with Cisco FM...; Question 53: (Exhibit) Refer to the exhibit. An engineer is analyzing a N...; Question 54: When packet capture is used on a Cisco Secure Firewall Threa...; Question 55: A Cisco FMC administrator wants to configure fastpathing of ...; Question 56: A network engineer is planning on replacing an Active/Standb...; Question 57: What is the advantage of having Cisco Firepower devices send...; Question 58: An organization has a Cisco FTD that uses bridge groups to p...; Question 59: In which two ways do access control policies operate on a Ci...; Question 60: An engineer must export a packet capture from Cisco Secure F...; Question 61: An engineer is attempting to add a new FTD device to their F...; Question 62: An engineer wants to connect a single IP subnet through a Ci...; Question 63: An administrator must fix a network problem whereby traffic ...; Question 64: Which action should you take when Cisco Threat Response noti...; Question 65: What is a feature of Cisco AMP private cloud?...; Question 66: An engineer must configure high availability for the Cisco F...; Question 67: In a Cisco AMP for Networks deployment, which disposition is...; Question 68: What is a characteristic of bridge groups on a Cisco FTD?...; Question 69: A network administrator notices that SI events are not being...; Question 70: An engineer has been tasked with using Cisco FMC to determin...; Question 71: Which command is typed at the CLI on the primary Cisco FTD u...; Question 72: An engineer is troubleshooting a device that cannot connect ...; Question 73: A hospital network needs to upgrade their Cisco FMC managed ...; Question 74: Which license type is required on Cisco ISE to integrate wit...; Question 75: An organization recently implemented a transparent Cisco FTD...; Question 76: Which Firepower feature allows users to configure bridges in...; Question 77: A user within an organization opened a malicious file on a w...; Question 78: An administrator must use Cisco FMC to install a backup rout...; Question 79: An administrator receives reports that users cannot access a...; Question 80: Which CLI command is used to control special handling of cli...; Question 81: An engineer must configure a Cisco FMC dashboard in a multid...; Question 82: A security engineer found a suspicious file from an employee...; Question 83: An engineer currently has a Cisco FTD device registered to t...; Question 84: An engineer plans to reconfigure an existing Cisco FTD from ...; Question 85: (Exhibit) A security engineer must improve security in an or...; Question 86: A network engineer wants to add a third-party threat feed in...; Question 87: What is the role of realms in the Cisco ISE and Cisco FMC in...; Question 88: Refer to the exhibit. (Exhibit) An administrator is looking ...; Question 89: Which command must be run to generate troubleshooting files ...; Question 90: Which action should be taken after editing an object that is...; Question 91: A network administrator wants to configure a Cisco Secure Fi...; Question 92: An organization does not want to use the default Cisco Firep...; Question 93: A network administrator is configuring an FTD in transparent...; Question 94: A network engineer sets up a secondary Cisco FMC that is int...; Question 95: Within Cisco Firepower Management Center, where does a user ...; Question 96: A network administrator is trying to configure an access rul...; Question 97: An engineer is configuring a Cisco IPS to protect the networ...; Question 98: An analyst using the security analyst account permissions is...; Question 99: An engineer must define a URL object on Cisco FMC. What is t...; Question 100: Which component is needed to perform rapid threat containmen...; Question 101: With Cisco Firepower Threat Defense software, which interfac...; Question 102: While integrating Cisco Umbrella with Cisco Threat Response,...; Question 103: An engineer is tasked with deploying an internal perimeter f...; Question 104: Refer to the exhibit. (Exhibit) And engineer is analyzing th...; Question 105: A network administrator notices that remote access VPN users...; Question 106: Which two remediation options are available when Cisco FMC i...; Question 107: A security engineer manages a firewall console and an endpoi...; Question 108: An engineer is configuring a custom intrusion rule on Cisco ...; Question 109: An engineer is configuring URL filtering tor a Cisco Secure ...; Question 110: A security engineer is configuring an Access Control Policy ...; Question 111: A consultant Is working on a project where the customer is u...; Question 112: A network administrator needs to create a policy on Cisco Fi...; Question 113: A company has many Cisco FTD devices managed by a Cisco FMC....; Question 114: Which two considerations must be made when deleting and re-a...; Question 115: A network administrator is reviewing a weekly scheduled atta...; Question 116: An engineer wants to add an additional Cisco FTD Version 6.2...; Question 117: A network administrator reviews me attack risk report and no...; Question 118: A network engineer is deploying a pair of Cisco Secure Firew...; Question 119: A network administrator must create an EtherChannel Interfac...; Question 120: A network administrator notices that inspection has been int...; Question 121: What is a limitation to consider when running a dynamic rout...; Question 122: Refer to the exhibit. What must be done to fix access to thi...; Question 123: A network security engineer must replace a faulty Cisco FTD ...; Question 124: An administrator is configuring the interface of a Cisco Sec...; Question 125: With a recent summer time change, system logs are showing ac...; Question 126: Drag and drop the steps to restore an automatic device regis...; Question 127: Which file format can standard reports from Cisco Secure Fir...; Question 128: A network administrator is configuring a site-to-site IPsec ...; Question 129: An engineer must deploy a Cisco FTD appliance via Cisco FMC ...; Question 130: Which protocol establishes network redundancy in a switched ...; Question 131: An engineer wants to perform a packet capture on the Cisco F...; Question 132: Which firewall design will allow It to forward traffic at la...; Question 133: An engineer configures a network discovery policy on Cisco F...; Question 134: A network administrator is configuring Snort inspection poli...; Question 135: An organization has noticed that malware was downloaded from...; Question 136: Which two statements about bridge-group interfaces in Cisco ...; Question 137: Which two routing options are valid with Cisco FTD? (Choose ...; Question 138: Which report template field format is available in Cisco FMC...; Question 139: Which two deployment types support high availability? (Choos...; Question 140: A security engineer must configure policies tor a recently d...; Question 141: A network administrator cannot select the link to be used fo...; Question 142: A company is deploying Cisco Secure Endpoint private cloud. ...; Question 143: A security engineer must configure a Cisco FTD appliance to ...; Question 144: Refer to the exhibit. (Exhibit) An organization has an acces...; Question 145: What is the result when two users modify a VPN policy at the...; Question 146: An analyst is investigating a potentially compromised endpoi...; Question 147: A company is deploying intrusion protection on multiple Cisc...

[×]

Download PDF File

Enter your email address to download Cisco.300-710.v2024-10-09.q147.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 124/147

LEAVE A REPLY

Download PDF File