<< Prev Question Next Question >>

Question 48/62

A network administrator notices that remote access VPN users are not reachable from inside the network. It is determined that routing is configured correctly, however return traffic is entering the firewall but not leaving it What is the reason for this issue?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (62q)
Question 1: After using Firepower for some time and learning about how i...
Question 2: Refer to the exhibit. (Exhibit) And engineer is analyzing th...
Question 3: An administrator is working on a migration from Cisco ASA to...
Question 4: An analyst is investigating a potentially compromised endpoi...
Question 5: An engineer is building a new access control policy using Ci...
Question 6: An engineer runs the command restore remote-manager-backup l...
Question 7: Which connector is used to integrate Cisco ISE with Cisco FM...
Question 8: An engineer is implementing Cisco FTD in the network and is ...
Question 9: An engineer is troubleshooting application failures through ...
Question 10: What is a valid Cisco AMP file disposition?...
Question 11: A network engineer is configuring URL Filtering on Firepower...
Question 12: A network engineer is tasked with minimising traffic interru...
Question 13: With Cisco FTD software, which interface mode must be config...
Question 14: A security engineer is configuring a remote Cisco FTD that h...
Question 15: Which two OSPF routing features are configured in Cisco FMC ...
Question 16: A network engineer is receiving reports of users randomly ge...
Question 17: The event dashboard within the Cisco FMC has been inundated ...
Question 18: Refer to the exhibit. (Exhibit) An engineer is modifying an ...
Question 19: A network engineer is logged into the Cisco AMP for Endpoint...
Question 20: Upon detecting a flagrant threat on an endpoint, which two t...
Question 21: IT management is asking the network engineer to provide high...
Question 22: A VPN user is unable to conned lo web resources behind the C...
Question 23: An engineer must define a URL object on Cisco FMC. What is t...
Question 24: A network engineer implements a new Cisco Firepower device o...
Question 25: A network engineer is logged into the Cisco AMP for Endpoint...
Question 26: An organization wants to secure traffic from their branch of...
Question 27: A network administrator notices that inspection has been int...
Question 28: An engineer is monitoring network traffic from their sales a...
Question 29: Which two conditions must be met to enable high availability...
Question 30: A network engineer is extending a user segment through an FT...
Question 31: Which policy rule is included in the deployment of a local D...
Question 32: An engineer is reviewing a ticket that requests to allow tra...
Question 33: An administrator must use Cisco FMC to install a backup rout...
Question 34: Within Cisco Firepower Management Center, where does a user ...
Question 35: An engineer must investigate a connectivity issue and decide...
Question 36: Which command is run at the CLI when logged in to an FTD uni...
Question 37: In a multi-tennent deployment where multiple domains are in ...
Question 38: With Cisco FTD integrated routing and bridging, which interf...
Question 39: An engineer is troubleshooting connectivity to the DNS serve...
Question 40: A hospital network needs to upgrade their Cisco FMC managed ...
Question 41: An engineer wants to connect a single IP subnet through a Ci...
Question 42: Refer to the exhibit. (Exhibit) An organization has an acces...
Question 43: A network administrator configured a NAT policy that transla...
Question 44: An organization is setting up two new Cisco FTD devices to r...
Question 45: Which Cisco Advanced Malware Protection for Endpoints policy...
Question 46: Which interface type allows packets to be dropped?...
Question 47: A Cisco FTD has two physical interfaces assigned to a BVI. E...
Question 48: A network administrator notices that remote access VPN users...
Question 49: Which group within Cisco does the Threat Response team use f...
Question 50: What is a characteristic of bridge groups on a Cisco FTD?...
Question 51: An engineer has been tasked with providing disaster recovery...
Question 52: An organization has seen a lot of traffic congestion on thei...
Question 53: A company wants a solution to aggregate the capacity of two ...
Question 54: An organization is using a Cisco FTD and Cisco ISE to perfor...
Question 55: What are two application layer preprocessors? (Choose two.)...
Question 56: A security engineer is configuring an Access Control Policy ...
Question 57: A network administrator notices that SI events are not being...
Question 58: A network administrator is seeing an unknown verdict for a f...
Question 59: An administrator is creating interface objects to better seg...
Question 60: Which Cisco Firepower Threat Defense, which two interface se...
Question 61: The administrator notices that there is malware present with...
Question 62: An administrator is attempting to remotely log into a switch...