<< Prev Question

Question 28/28

A network engineer is configuring URL Filtering on Firepower Threat Defense. Which two port requirements on the Firepower Management Center must be validated to allow communication with the cloud service?
(Choose two.)

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (28q)
Question 1: An administrator is attempting to remotely log into a switch...
Question 2: The event dashboard within the Cisco FMC has been inundated ...
Question 3: Which two routing options are valid with Cisco Firepower Thr...
Question 4: Which action should you take when Cisco Threat Response noti...
Question 5: Which interface type allows packets to be dropped?...
Question 6: In a Cisco AMP for Networks deployment, which disposition is...
Question 7: An organization has noticed that malware was downloaded from...
Question 8: What is the maximum SHA level of filtering that Threat Intel...
Question 9: Which limitation applies to Cisco Firepower Management Cente...
Question 10: Which two conditions are necessary for high availability to ...
Question 11: Refer to the exhibit. (Exhibit) And engineer is analyzing th...
Question 12: Which command-line mode is supported from the Cisco Firepowe...
Question 13: Which connector is used to integrate Cisco ISE with Cisco FM...
Question 14: Which Firepower feature allows users to configure bridges in...
Question 15: An engineer is troubleshooting application failures through ...
Question 16: Which group within Cisco does the Threat Response team use f...
Question 17: Which command is entered in the Cisco FMC CLI to generate a ...
Question 18: Which command is run on an FTD unit to associate the unit to...
Question 19: Which command is run at the CLI when logged in to an FTD uni...
Question 20: After using Firepower for some time and learning about how i...
Question 21: An engineer is configuring a second Cisco FMC as a standby d...
Question 22: An engineer is configuring a cisco FTD appliance in IPS-only...
Question 23: On the advanced tab under inline set properties, which allow...
Question 24: Which report template field format is available in Cisco FMC...
Question 25: Which two packet captures does the FTD LINA engine support? ...
Question 26: When creating a report template, how can the results be limi...
Question 27: Which Cisco Advanced Malware Protection for Endpoints policy...
Question 28: A network engineer is configuring URL Filtering on Firepower...