- Home
- Cisco
- Implementing Cisco Application Centric Infrastructure
- Cisco.300-620.v2024-05-04.q133
- Question 61
Valid 300-620 Dumps shared by ExamDiscuss.com for Helping Passing 300-620 Exam! ExamDiscuss.com now offer the newest 300-620 exam dumps, the ExamDiscuss.com 300-620 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 300-620 dumps with Test Engine here:
Access 300-620 Dumps Premium Version
(371 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 61/133
A data center administrator is upgrading an ACI fabric. There are 3 APIC controllers in the fabric and all the servers are dual-homed to pairs of leaf switches configured in VPC mode. How should the fabric be upgraded to minimize possible traffic impact during the upgrade?
Correct Answer: C
You need to upgrade the APIC first and group of switches.
At a high level, steps to upgrade or downgrade the Cisco ACI fabric are as follows:
The procedure or steps for upgrade and downgrade are the same unless stated otherwise in the release notes of a specific release.
Ensure that you have the required CIMC version required for Cisco APIC upgrade. See the Cisco APIC Release Notes for the supported CIMC versions and Upgrading the CIMC Software for the procedures for upgrading the CIMC software, if necessary.
Download the Cisco ACI Controller image (Cisco APIC image) into the repository.
Download the Cisco ACI switch image into the repository.
Upgrade the cluster of Application Policy Infrastructure Controllers (Cisco APICs).
Verify that the fabric is operational and the APIC cluster is "Fully Fit" before proceeding.
Divide the switches into multiple groups, and upgrade the switches by group, verifying that the fabric is operational between switch group upgrades. For example, assume that you divided the switches into two groups - red and blue. You could then go through the following upgrade process:
1. Upgrade the red group of switches.
2. Verify that the fabric is operational.
3. Upgrade the blue group of switches.
4. Verify that the fabric is operational.
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/all/apic-installation- upgrade-downgrade/Cisco-APIC-Installation-Upgrade-Downgrade-Guide/Cisco-APIC-Installation- Upgrade-Downgrade-Guide_chapter_011.html#id_48185
At a high level, steps to upgrade or downgrade the Cisco ACI fabric are as follows:
The procedure or steps for upgrade and downgrade are the same unless stated otherwise in the release notes of a specific release.
Ensure that you have the required CIMC version required for Cisco APIC upgrade. See the Cisco APIC Release Notes for the supported CIMC versions and Upgrading the CIMC Software for the procedures for upgrading the CIMC software, if necessary.
Download the Cisco ACI Controller image (Cisco APIC image) into the repository.
Download the Cisco ACI switch image into the repository.
Upgrade the cluster of Application Policy Infrastructure Controllers (Cisco APICs).
Verify that the fabric is operational and the APIC cluster is "Fully Fit" before proceeding.
Divide the switches into multiple groups, and upgrade the switches by group, verifying that the fabric is operational between switch group upgrades. For example, assume that you divided the switches into two groups - red and blue. You could then go through the following upgrade process:
1. Upgrade the red group of switches.
2. Verify that the fabric is operational.
3. Upgrade the blue group of switches.
4. Verify that the fabric is operational.
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/all/apic-installation- upgrade-downgrade/Cisco-APIC-Installation-Upgrade-Downgrade-Guide/Cisco-APIC-Installation- Upgrade-Downgrade-Guide_chapter_011.html#id_48185
- Question List (133q)
- Question 1: Refer to the exhibit. A network engineer must complete the C...
- Question 2: Refer to the exhibit. An engineer configures a static port b...
- Question 3: Which routing protocol is supported between Cisco ACI spines...
- Question 4: A network administrator is configuring a Cisco ACI fabric to...
- Question 5: Which two actions extend a Layer 2 domain beyond the ACI fab...
- Question 6: An engineer is implementing a Cisco ACI environment that con...
- Question 7: Refer to the exhibit. VM1 and VM2 are in Cisco ACI POD1 and ...
- Question 8: Refer to the exhibit. An engineer plans to upgrade the Cisco...
- Question 9: In Cisco ACI, if no contract is attached to the EPG, what is...
- Question 10: In Cisco ACI, what is the order of steps for deploying an EP...
- Question 11: A packet is routed between two endpoints on different Cisco ...
- Question 12: A situation causes a fault to be raised on the APIC. The ACI...
- Question 13: Drag and Drop Question Drag and drop the Cisco ACI Layer 4 t...
- Question 14: Refer to the exhibit. A syslog service was configured to cap...
- Question 15: An engineer must perform a Cisco ACI fabric upgrade that min...
- Question 16: In Cisco ACI, which three statements are true about endpoint...
- Question 17: Drag and Drop Question Refer to the exhibit. A Cisco ACI fab...
- Question 18: A network engineer must backup the PRODUCTION tenant. The co...
- Question 19: Which feature dynamically assigns or modifies the EPG associ...
- Question 20: What is the result of the pcEnPref flag configured on the ep...
- Question 21: What are two PBR characteristics of the Cisco ACI Active-Act...
- Question 22: The company's Cisco ACI fabric hosts multiple customer tenan...
- Question 23: In a Cisco ACI fabric, an endpoint moves between two leaf sw...
- Question 24: Refer to the exhibit. A Cisco APIC raises this fault when co...
- Question 25: Refer to the exhibit. Server A is connected to the Cisco ACI...
- Question 26: Refer to the exhibit. Which two configuration steps are comp...
- Question 27: Which Cisco APIC configuration prevents a remote network tha...
- Question 28: What is the effect of enabling the disable Remote EP learn f...
- Question 29: Refer to the exhibit. An engineer is configuring a productio...
- Question 30: Refer to the exhibit. A Cisco ACI fabric has these configura...
- Question 31: A network engineer must configure a new SNMP configuration a...
- Question 32: Which setting prevents the learning of Endpoint IP addresses...
- Question 33: Refer to the exhibit. A Cisco ACI fabric is created with L2O...
- Question 34: Drag and Drop Question Drag and drop the Cisco ACI filter en...
- Question 35: Which type of profile needs to be created to deploy an acces...
- Question 36: When configuring Cisco ACI VMM domain integration with VMwar...
- Question 37: As the Cisco ACI fabric administrator for a service provider...
- Question 38: In Cisco ACI, contracts govern which two types of endpoint g...
- Question 39: Which two statements regarding ACI Multi-Site are true? (Cho...
- Question 40: Refer to the exhibit. New e-commerce software is deployed on...
- Question 41: What is the advantage of implementing an active-active firew...
- Question 42: What represents the unique identifier of an ACI object?...
- Question 43: An engineer must ensure that Cisco ACI flushes the appropria...
- Question 44: Which new construct must a user create when configuring in-b...
- Question 45: An engineer must add new servers to a Cisco ACI cluster and ...
- Question 46: Which endpoint learning operation is completed on the egress...
- Question 47: New ESXi hosts are procured in a data center compute expansi...
- Question 48: An engineer must advertise a bridge domain subnet out of the...
- Question 49: An engineer must integrate a Cisco ACI fabric with VMware an...
- Question 50: Which feature allows firewall ACLs to be configured automati...
- Question 51: An engineer is creating a configuration import policy that m...
- Question 52: An engineer is implementing Cisco ACI at a large platform-as...
- Question 53: A Cisco ACI fabric is integrated with a VMware environment. ...
- Question 54: An engineer must deploy Cisco ACI across 10 geographically s...
- Question 55: Refer to the exhibit. A load balancer is connected to the Ci...
- Question 56: The company ESXi infrastructure is hosted on the Cisco UCS-B...
- Question 57: Which network protocol is used for Cisco ACI fabric data pla...
- Question 58: The engineer notices frequent MAC and IP address moves betwe...
- Question 59: An organization has encountered many STP-related issues in t...
- Question 60: Refer to the exhibit. An engineer must migrate workloads fro...
- Question 61: A data center administrator is upgrading an ACI fabric. Ther...
- Question 62: An engineer needs to deploy a leaf access port policy group ...
- Question 63: An engineer is in the process of discovering a new Cisco ACI...
- Question 64: Refer to the exhibit. A systems engineer is implementing the...
- Question 65: In a Cisco ACI Multi-Site fabric, the Inter-Site BUM Traffic...
- Question 66: Refer to the exhibit. Which action should be taken to ensure...
- Question 67: What are two benefits of the Clos architecture? (Choose two....
- Question 68: An engineer must configure a Cisco ACI bridge domain to prev...
- Question 69: Refer to the exhibit. A client reports that the ACI domain c...
- Question 70: An ACI administrator notices a change in the behavior of the...
- Question 71: A bridge domain for an EPC called "Web Servers" must be crea...
- Question 72: An engineer must configure SNMP inside a Cisco ACI fabric. T...
- Question 73: Refer to the exhibit A Cisco ACI fabric is using out-of-band...
- Question 74: A customer must deploy three Cisco ACI based data centers. E...
- Question 75: How is an EPG extended outside of the ACI fabric?...
- Question 76: An engineer must allow multiple external networks to communi...
- Question 77: Assuming that a service device you are integrating into the ...
- Question 78: An engineer is implementing an out-of-band (OOB) management ...
- Question 79: A network engineer must allow secure access to the Cisco ACI...
- Question 80: Which description regarding the initial APIC cluster discove...
- Question 81: A Cisco ACI fabric is connected to an external Cisco Catalys...
- Question 82: Refer to the exhibit. An engineer is deploying a Cisco ACI f...
- Question 83: An engineer must connect a new host to port 1/1 on Leaf 101....
- Question 84: A Cisco APIC is configured with RADIUS authentication as the...
- Question 85: Refer to the exhibit. A client is configuring a new Cisco AC...
- Question 86: An engineer plans a Cisco ACI firmware upgrade. The ACI fabr...
- Question 87: An application team tells the Cisco ACI network administrato...
- Question 88: Which feature should be disabled on a bridge domain when a d...
- Question 89: Which endpoint learning operation is completed on the ingres...
- Question 90: Refer to the exhibit. A service provider hosts applications ...
- Question 91: An engineer must configure a service graph for the policy-ba...
- Question 92: Refer to the exhibit. A Cisco ACI environment hosts two e-co...
- Question 93: An engineer is extending an EPG out of the ACI fabric using ...
- Question 94: An engineer configures a Cisco ACI Multi-Pod for disaster re...
- Question 95: Refer to the exhibit. An engineer configures an L3Out but re...
- Question 96: Refer to the exhibit. A Cisco ACI fabric displays this fault...
- Question 97: A Cisco ACI is integrated with a VMware vSphere environment....
- Question 98: An engineer is implementing a connection that represents an ...
- Question 99: An engineer configured Layer 2 extension from the ACI fabric...
- Question 100: An engineer must configure a new local user inside a Cisco A...
- Question 101: Drag and Drop Question An engineer is configuring a VRF for ...
- Question 102: Drag and Drop Question An engineer must configure RADIUS aut...
- Question 103: Using EPG extension, an engineer has moved all endpoints in ...
- Question 104: Refer to the exhibit. An engineer connects a Cisco ACI fabri...
- Question 105: A network engineer must configure a Cisco ACI system to dete...
- Question 106: A network engineer must integrate VMware vCenter cluster wit...
- Question 107: Refer to the exhibit. A company merges three of its departme...
- Question 108: Refer to the exhibit. A customer is deploying a WAN with the...
- Question 109: A network engineer must design a method to allow the Cisco A...
- Question 110: What happens to the traffic flow when the Cisco ACI fabric h...
- Question 111: Refer to the exhibit. An engineer configured subnets on the ...
- Question 112: An engineer must configure a group of servers with a contrac...
- Question 113: A company must connect three Cisco ACI data centers by using...
- Question 114: Refer to the exhibit. A company decided to decrease its rout...
- Question 115: A Cisco ACI fabric with an ARP packet must ensure detection ...
- Question 116: Which Cisco ACI feature allows the encryption of communicati...
- Question 117: What are two requirements for the IPN network when implement...
- Question 118: Refer to the exhibit. A network engineer deploys Cisco APIC ...
- Question 119: A recent set of changes by a Cisco ACI administrator corrupt...
- Question 120: Which statements are correct regarding ACI support for BFD? ...
- Question 121: Which two actions does the Cisco ACI take when a bridge doma...
- Question 122: Refer to the exhibit. An engineer wants to initiate an ICMP ...
- Question 123: An engineer has set the VMM resolution immediacy to pre-prov...
- Question 124: An engineer must advertise a selection of external networks ...
- Question 125: What two actions should be taken to deploy a new Cisco ACI M...
- Question 126: An engineer is troubleshooting fabric discovery in a newly d...
- Question 127: Refer to the exhibit. How are the STP BPDUs forwarded over C...
- Question 128: A network engineer must optimize a Cisco ACI multi-pod deplo...
- Question 129: An administrator must migrate the vSphere Management VMkerne...
- Question 130: A Cisco APIC is configured to authenticate users by using RA...
- Question 131: A RADIUS user resolves its role via the Cisco AV Pair. What ...
- Question 132: A customer creates Layer 3 connectivity to the outside netwo...
- Question 133: An engineer configured a bridge domain with the hardware-pro...
