<< Prev Question Next Question >>

Question 35/148

An engineer must configure Linux hosts that are deployed on Cisco UCS B-Series Servers to boot from SAN. The SAN boot policy is configured in Cisco UCS Manager, and the boot order is verified to be set as expected However, the Linux hosts fail to boot. Which action resolves the issue?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (148q)
Question 1: (Exhibit) Refer to the exhibit. An engineer is investigating...
Question 2: Refer to the exhibit. (Exhibit) After an unexpected reload o...
Question 3: Refer to the exhibit. (Exhibit) Partial configuration from N...
Question 4: Drag each item listed on the left to its proper category on ...
Question 5: An engineer is troubleshooting issues in Cisco UCS Director....
Question 6: A vPC Type-1 inconsistency between two vPC peers in a VXLAN ...
Question 7: Refer to the exhibit. (Exhibit) The vPC between switch1 and ...
Question 8: Refer to the exhibit. (Exhibit) An engineer is investigating...
Question 9: Refer to the exhibit. (Exhibit) During implementation of a C...
Question 10: Refer to the exhibit. (Exhibit) A network engineer finds one...
Question 11: Refer to the exhibit. (Exhibit) An attempt to bind the Ether...
Question 12: Refer to the exhibits. (Exhibit) An engineer troubleshoots s...
Question 13: Refer to the exhibit. (Exhibit) An engineer deploys SAN envi...
Question 14: An upgrade of protected RPMs from the Bash shell did not tak...
Question 15: Refer to the exhibit. (Exhibit) The connection between a Cis...
Question 16: Cisco Unified Computing System Manager raises a critical err...
Question 17: Refer to the exhibit. (Exhibit) A Cisco UCS B-Series Blade S...
Question 18: An engineer discovers that an NPV/NPIV uplink experiences a ...
Question 19: Refer to the exhibit. (Exhibit) An engineer must connect N2K...
Question 20: (Exhibit) Refer to the exhibit. HSRP adjacency fails to form...
Question 21: Drag each item listed on the left to its proper category on ...
Question 22: Drag and drop the actions from the left onto the faults that...
Question 23: Drag and drop the actions from the left onto the faults that...
Question 24: Refer to the exhibit. (Exhibit) An upgrade operation fails w...
Question 25: A customer reports that the Chassis Management Controller fa...
Question 26: Refer to the exhibit. (Exhibit) During implementation of a C...
Question 27: A Fibre Channel interface on a Cisco Nexus 5000 Series Switc...
Question 28: Drag and drop the Cisco UCS SNMP fault types from the left o...
Question 29: A vPC Type-1 inconsistency between two vPC peers in a VXLAN ...
Question 30: You have an ACI environment with three APICs, two spine swit...
Question 31: Refer to the exhibit. (Exhibit)...
Question 32: Refer to the exhibit. (Exhibit) A PC belongs to VLAN 68 The ...
Question 33: Refer to the exhibit. (Exhibit) The scheduler was configured...
Question 34: Refer to the exhibit. (Exhibit) The initiator that has FC ID...
Question 35: An engineer must configure Linux hosts that are deployed on ...
Question 36: Refer to the exhibit. (Exhibit) A PC belongs to VLAN 68 The ...
Question 37: Refer to the exhibit. (Exhibit) The initiator that has FC ID...
Question 38: Refer to the exhibit. (Exhibit) A customer network uses OSPF...
Question 39: Cisco Unified Computing System Manager raises a critical err...
Question 40: Refer to the exhibit. (Exhibit) After the configuration is p...
Question 41: (Exhibit) Refer to the exhibit. VSAN traffic is not routed a...
Question 42: Refer to the exhibit. (Exhibit) A network engineer notices p...
Question 43: Refer to the exhibit. (Exhibit) A network engineer is implem...
Question 44: Refer to the exhibit. (Exhibit) The FCoE traffic fails to tr...
Question 45: Drag and drop the actions from the left onto the faults that...
Question 46: A fabric interconnect fails to start and the console display...
Question 47: Refer to the exhibit. (Exhibit) An engineer is investigating...
Question 48: Refer to the exhibit. A network engineer is configuring the ...
Question 49: A firmware upgrade on a fabric interconnect fails. A bootfla...
Question 50: A firmware upgrade on a fabric interconnect fails. A bootfla...
Question 51: Refer to the exhibit. (Exhibit) During implementation of a C...
Question 52: Refer to the exhibit. (Exhibit) The script fails to bring up...
Question 53: Refer to the exhibit. (Exhibit) A switch is being downgraded...
Question 54: Refer to the exhibit. (Exhibit) After a failover occurs, whi...
Question 55: Refer to the exhibit. (Exhibit) An attempt to bind the Ether...
Question 56: An engineer is troubleshooting a custom AV pair that was cre...
Question 57: Refer to the exhibit. (Exhibit) A network engineer is implem...
Question 58: Refer to the exhibit. (Exhibit) An engineer is experiencing ...
Question 59: A Cisco Nexus 9000 Series Switch crashes and fails to boot. ...
Question 60: An IOM fails during a firmware upgrade and is unresponsive. ...
Question 61: The script fails to convert a JSON variable into a Python di...
Question 62: Refer to the exhibit. (Exhibit) Refer to the exhibit. The mo...
Question 63: Refer to the exhibit. (Exhibit) An engineer discovers that i...
Question 64: Refer to the exhibits. (Exhibit) An engineer troubleshoots s...
Question 65: Refer to the exhibit. A network engineer creates an EEM scri...
Question 66: One of Cisco Nexus Series interfaces has become errdisabled ...
Question 67: Refer to the Exhibit. (Exhibit) An Engineer cannot log in to...
Question 68: Refer to the exhibit. (Exhibit) A recent configuration chang...
Question 69: (Exhibit) Refer to the exhibit. Sw1 and Sw2 are two Cisco Ne...
Question 70: A server administrator attempts to change the Cisco IMC KVM ...
Question 71: Refer to the exhibit. (Exhibit) A network engineer has conne...
Question 72: A Cisco uCs C-Series Server powers off due to a power outage...
Question 73: DRAG DROP Drag and drop the commands from the left onto the ...
Question 74: Refer to the exhibit. (Exhibit) A network engineer has conne...
Question 75: An engineer configures FCoE between a set of ESXi hosts and ...
Question 76: Refer to the exhibit. (Exhibit) An OSPF adjacency between Ro...
Question 77: Refer to the exhibit. (Exhibit) Refer to the exhibit. The ex...
Question 78: Refer to the exhibit. (Exhibit) An engineer is experiencing ...
Question 79: An engineer troubleshoots a VXLAN EVPN data center. The appl...
Question 80: An engineer removes a VMM domain from an endpoint group call...
Question 81: Refer to the exhibit. (Exhibit) A Cisco UCS Fabric Interconn...
Question 82: Refer to the exhibit. (Exhibit) The vPC between switch1 and ...
Question 83: Refer to the exhibit. (Exhibit) Sw1 and Sw2 are two Cisco Ne...
Question 84: A server administrator attempts to change the Cisco IMC KVM ...
Question 85: Refer to the exhibit. (Exhibit) An engineer is performing a ...
Question 86: Drag and drop the commands from the left onto the correct ca...
Question 87: Refer to the exhibit. (Exhibit) A customer network uses OSPF...
Question 88: A network engineer notices a sudden interruption to the HSRP...
Question 89: Refer to the exhibit. (Exhibit) An engineer monitors a Cisco...
Question 90: Refer to the exhibit. (Exhibit) The scheduler job fails to r...
Question 91: (Exhibit) Refer to the exhibit. A functioning trunk port Eth...
Question 92: A client reports that many flaps and server cluster disconne...
Question 93: Refer to the exhibit. (Exhibit) An engineer is investigating...
Question 94: An engineer must upgrade all components in a Cisco UCS domai...
Question 95: Refer to the exhibit. An engineer discovered a VFC interface...
Question 96: A Cisco Nexus 9000 Series Switch crashes and fails to boot. ...
Question 97: Refer to the exhibit. (Exhibit) An attempt to bind the Ether...
Question 98: Drag and drop the actions from the left onto the faults that...
Question 99: Refer to the exhibit. (Exhibit) An engineer is configuring b...
Question 100: Drag and drop the Cisco UCS SNMP fault types from the left o...
Question 101: An engineer is troubleshooting issues in Cisco UCS Director....
Question 102: Refer to the exhibit. (Exhibit) An engineer is performing a ...
Question 103: Refer to the exhibit. (Exhibit) The scheduler was configured...
Question 104: An attempt to use a global vNIC redundancy template pair res...
Question 105: (Exhibit) Refer to the exhibit. An engineer discovered a VFC...
Question 106: An engineer attempts to register Cisco UCS Manager to Cisco ...
Question 107: An engineer is implementing a storage VDC, but fails. Which ...
Question 108: Refer to the exhibit. (Exhibit) The EEM script is applied in...
Question 109: Refer to the exhibit. (Exhibit) The job fails to run. Which ...
Question 110: Refer to the exhibit. (Exhibit) An engineer must save the ru...
Question 111: What does this adapter output indicate? adapter 1/6/1 (fls):...
Question 112: An engineer troubleshoots a failed DCBX exchange between a s...
Question 113: Refer to the exhibit. (Exhibit) An upgrade operation fails w...
Question 114: Refer to the exhibit. (Exhibit) A blade that is connected to...
Question 115: A firmware upgrade on a fabric interconnect fails. A bootfla...
Question 116: Refer to the exhibit. (Exhibit) A Cisco UCS B-Series Blade S...
Question 117: (Exhibit) Refer to the exhibit. The EEM script overrides all...
Question 118: (Exhibit) Refer to the exhibit. A new Cisco Nexus 5548 Switc...
Question 119: Refer to the exhibit. (Exhibit) A PC belongs to VLAN 68 The ...
Question 120: Refer to the exhibit. (Exhibit) An upgrade operation fails w...
Question 121: Refer to the exhibit. (Exhibit) Refer to the exhibit. The ad...
Question 122: Refer to the exhibit. (Exhibit) A network engineer notices p...
Question 123: A system administrator connects a Cisco Nexus 2248PQ FEX to ...
Question 124: Refer to the exhibit. (Exhibit) Sw1 and Sw2 are two Cisco Ne...
Question 125: After upgrading a client's fabric interconnect to the latest...
Question 126: An attempt to use a global vNIC redundancy template pair res...
Question 127: Drag and drop the commands from the left onto the correct ca...
Question 128: A firmware upgrade on a fabric interconnect fails. A bootfla...
Question 129: Refer to the exhibits. (Exhibit) An engineer troubleshoots s...
Question 130: An engineer is troubleshooting a custom AV pair that was cre...
Question 131: An engineer is troubleshooting issues in Cisco UCS Director....
Question 132: An engineer is troubleshooting issues in Cisco UCS Director....
Question 133: (Exhibit) Refer to the exhibit. An engineer must connect N2K...
Question 134: (Exhibit) Refer to an exhibit. An engineer is troubleshootin...
Question 135: Refer to the exhibit. (Exhibit) A network engineer upgrades ...
Question 136: Refer to the exhibit. (Exhibit) Sw1 and Sw2 are two Cisco Ne...
Question 137: Refer to the exhibit. (Exhibit) The integration between Cisc...
Question 138: A mission-critical server is connected to site A. Connectivi...
Question 139: (Exhibit) Refer to the exhibit. A network engineer configure...
Question 140: The Cisco Nexus switch is connected to a peer switch that is...
Question 141: Refer to the exhibit. (Exhibit) The connection between a Cis...
Question 142: Refer to the exhibit. A certificate is implemented on the se...
Question 143: Refer to the exhibit. (Exhibit) Sw1 and Sw2 are two Cisco Ne...
Question 144: An engineer upgrades Cisco UCS firmware from release 3. 1(2)...
Question 145: An IOM fails during a firmware upgrade and is unresponsive. ...
Question 146: A customer reports that the Chassis Management Controller fa...
Question 147: Refer to the exhibit. (Exhibit) The vPC between switch1 and ...
Question 148: A network engineer must connect a Cisco UCS Fabric Interconn...